Msd 8252 Blaster HVC, Works w_ MSD 6 Series Units Inst- User Manual
Msd 8252 Blaster HVC, Works w_ MSD 6 Series Units Inst– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered
in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
MSD Blaster HVC Coil
PN 8252
WARNING: Very high voltages are present at the coil when the engine is running. Never connect
any test equipment or touch the coil while the engine is running.
WARNING: Disconnect the battery during installation. When disconnecting the battery, always
remove the negative cable first and install it last.
Parts Included
1 - Blaster HVC Coil
2 - Rings Lug Terminals
2- 45° Blade Terminals
4 - Vibration Mounts
2 - Nuts & Washers
2- Star Washers
1 - 2-Pin Weathertight Connector and Harness 2 - Spade Connectors
1 - 2-Pin Weathertight Connector Assembly
1 - 4" Black Wire
The Blaster HVC Coil is designed to be used with an MSD Ignition Control. It may also be
used with stock or other aftermarket ignitions.
INSTALLATION
1. The Coil can be mounted in any position, but should be away from direct heat sources.
Use the Coil as a template and mark the location of the mounting holes. Use an 1/8” bit
to drill the holes.
2. Install the supplied vibration mounts to the coil and install the coil. Also install one end of
the 4" Black wire between a vibration mount and the bracket. Connect the other end to
ground.
Note:
The supplied star washers must be used on both sides of the ground wire ring
lug terminal. This ensures proper grounding through the anodized brackets.
3. Route the coil wires away from heat sources, the plug wires and the trigger pickup
wires.
4. The MSD Orange wire connects to coil positive (+). Black connects to coil negative(-).
There are two options when connecting the coil:
• Use the supplied ring lugs or 45° blade terminals to connect the MSD Ignition
wiring.
OR
• Install the supplied 2-pin harness and connect the matching 2-pin connector to
the ignition's wiring.
5. Connect the coil secondary wire to the coil and distributor cap.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
