Msd 6425 Digital 6AL Ignition Control- User Manual
Msd 6425 Digital 6AL Ignition Control– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
© 2012 Autotronic Controls Corporation
FRM30943
Created 01/12
Printed in U.S.A.
REV Limiter Verification
MSD Digital 6AL Ignition Control
PN 6425
The MSD Digital 6AL has an optional built in Rev Limiter Verification feature. When activated, it will display the
unit’s rev limit setting at key-on. This feature is not activated from the factory. To enable this feature, follow the
procedure below.
Note: It is important to note that this feature should not be used with EFI systems. When activated, an rpm
signal is sent to the tachometer. With an aftermarket EFI system, this could activate the injectors causing
a flooding situation.
ENABLE REV LIMIT VERIFICATION
1. With the ignition switch in the off position, ground the Gray tach output wire.
2. With the Gray wire connected to ground, turn the ignition on without starting the engine.
3. Hold the Gray tach output wire to ground for seven seconds. (AT LEAST five seconds.)
4. Release the wire from ground before ten seconds have passed.
5. To confirm the process has worked, cycle turn the key On. The tachometer should sweep to the rpm limit
set on the ignition.
To deactivate the verification feature, repeat the process.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
