Mr. Coffee APS-998 - Manual

Mr. Coffee APS-998

Mr. Coffee APS-998 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
Page: / 28

Table of Contents:

  • Page 2 – To program these selectable features
  • Page 5 – INSTALLATION OF THE MAJOR COMPONENTS:
  • Page 7 – WIRING THE 6 PIN MAIN POWER HARNESS:
  • Page 8 – YELLOW START WIRE DETAIL
  • Page 9 – WIRING THE 4 PIN ALTERNATE IGNITION HARNESS
  • Page 11 – Siren Wiring Detail; Positive Door Switch Wiring Detail
  • Page 12 – General Motors VATS By-Pass Diagram
  • Page 16 – Channel 3 Relay Wiring Detail
  • Page 17 – some remote start trigger inputs, will damage the control module.; Green/Yellow Wire: DIESEL WAIT TO START INPUT; when the transmitter is used to alm/lock the system.; Black w/ Red Trace Wire: Pulsed Ground Output After Shutdown
  • Page 21 – change, the above sequence will have to be followed.
  • Page 22 – Programming Tach Rate:
  • Page 24 – the ignition switch off. DO NOT attempt to remove the key.
  • Page 27 – COMPLETING THE INSTALLATION:; these mechanisms and impair the safe operation of the vehicle.
Loading the manual

128-7405

1 of 28

Model APS-998

Installation Manual

The selectable features can be set manually as explained below

, or with the RF feature programmer

.

T

o

set features using the RF programmer

, follow the instructions packaged with the programmer

.

Factory default settings are indicated by bold text.

Note :

The method of manual override can either be selected to operate from the valet switch or operate as custom code.

Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.

NOTE: Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated.

Also, No data will be indicated if a feature is not available for a particular model. The unit will enter the feature but no s

election will be available.

RF Programmable Feature Bank 1 Is For T

ransmitter Programming See T

ransmitter Programming Guide.

RF Programmable Features Bank 2 Is Alarm Selectable Features:

Feature Selection

1 Chirp

2 Chirps

3 Chirps

4 Chirps

5 Chirps

6 Chirps

1st DoorL/UL

1 Sec.

3.5

Sec.

1 Sec L, Dbl. U/L

Dbl L, 1 Sec UL

Dbl

L,

Dbl

UL

1

S

l/350mS

ul

2nd Accy Lock

Auto

Lock

On

Auto Lock Off

3rd Accy

.

UL

Auto UL Dr

.

Auto

UL

All

Auto UL Off

4th Headlights

On

Arm

On

Disarm

On Both

Off

5th Passive

Locks

Passive

Active

6th Pass/Act Arm

Passive

Arm

Active Arm

7th Siren/Horn

Siren/Horn

Siren Only

Horn

Only

8th Horn Chirp

10mS

16mS

30mS

40mS

50mS

9th O/R Method

Custom

Code

V

alet

10th 2 Step U/L

O

n

Off

1

1th Chp Del Tx

O

n

Off

12th V

olts/HdW

ire

Not A

vailable

13th Trigger Circuits

Not

A

vailable

14th L/UL Poll

Not A

vailable

When using the RF programmer

, enter the program mode as follows:

Turn the ignition on

Press and release valet switch 3 times

turn ignition off then on

Press and hold valet switch for 5 seconds

Siren chirps 2 times indicating access to RF feature program mode.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - To program these selectable features

128-7405 2 of 28 2 To program these selectable features; Action System Response Turn ignition on No response Press and release the valet switch 3 times 1 Chirp - LED 1 flash Within 3 seconds, turn ignition Off Then On Short chirp, then long chirp This Action Accesses Feature Bank 2 Alarm Selectable ...

Page 5 - INSTALLATION OF THE MAJOR COMPONENTS:

128-7405 5 of 28 This Remote Start/Alarm System is designed to be used with Automatic Transmission- Fuel InjectionVehicles Only! The unit provides a selectable ignition control that allows a number of selectable timed outputs for glow plug pre-heat in addition to a "Wait To Start Input" eith...

Page 7 - WIRING THE 6 PIN MAIN POWER HARNESS:

128-7405 7 of 28 This unit is to be used in vehicles with AUTOMATIC TRANSMISSIONS only! Although this combinationAlarm/Remote Start unit is a sophisticated system with many advanced features, IT MUST NOT be in-stalled into a vehicle with a manually operated transmission. Doing so may result in serio...

Other Mr. Coffee Models

All Mr. Coffee Other