Morphy Richards GrimeBuster steam cleaner - Manual
Morphy Richards GrimeBuster steam cleaner – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Features
- Page 4 – Filling the boiler
- Page 5 – To fit the connector
- Page 8 – Maintenance; Cleaning the boiler; Consumables
- Page 9 – Troubleshooting; Fault; Possible cause; Solution
- Page 10 – Two year guarantee
GrimeBuster steam cleaner
Please read and keep these instructions
www.morphyrichards.co.uk
getting the best from your
new cleaner...
No steam
• Check the power supply.
• Check the steam switch is set to the on position.
WARNING: If the cleaner has been boiled dry it must be
switched off for a few minutes to allow the safety cut-out
to reset.
• Check water is in the tank.
• The cleaner may need descaling. We recommend the use of
filtered water to reduce the scale.
(In hard water areas the cleaner will require regular descaling.
Follow the instructions on page 8.)
Please study all instructions carefully before use.
This product is also supplied with a user guide CD ROM.
70515+70516 Rev 1 19/5/04 3:59 PM Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Features ⁄ Filler cap ¤ Heater on/off button ‹ Steam on/off button › Machine socket fi ‘Heater on’ indicator light fl ‘Steam ready’ indicator light ‡ ‘Refill’ indicator light · ‘Steam indicator’ light ‚ Carrying handle „ Flexible hose ‰ Hose plug  Handle with remote steam control Ê Handle control ste...
Setting up your steamcleaner Filling the boiler 1 Unscrew the filler cap ⁄ anti-clockwise. 2 Fill the boiler with a maximum of 1.8litres of water by using the funnel Ï provided. A 3 Do not use any detergents. 4 Screw the filler cap ⁄ clockwise until finger tight. Do not overtighten. Attaching hose a...
5 To fit the connector 1 Push the connector end, holding itupside down, fully into the brush inlet E . 2 Twist the connector 1/ 2 a turn, until it is in place. F • The fit between the connector and the tubes and/or handle is tight to ensure nosteam leaks. It is recommended to keepboth parts lubricat...
