Moen 8713 - Manual
Moen 8713 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Disassembly; Installation
- Page 3 – Reassembly; Maintenance; Reversed Rough-In Where Hot and Cold Positions Are Reversed:
- Page 4 – Consumer Information
KITCHEN WALL MOUNT FAUCETS
Models 8713, 8714
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
MT149A
®
CAUTION:
Always turn water off before disassembling the valve. Open valve handle to
alleviate water pressure to insure that complete water shut-off has been
accomplished.
Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place. The
cartridge and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it
is nevertheless possible that through the handling of the valve by any number of persons the retainer clip may not
be properly installed. This should be carefully checked at time of rough-in and trim-out. If the retainer clip is not
properly installed, water pressure could force the cartridge out of the casting. Personal injury or water damage to
the premises could result.
CLIP
EAR
Measurements
ECCENTRICS
8" CENTERS
ADJUST FROM
7-1/2" TO 8-1/2"
9" SPOUT (MODEL 7400, 8713)
12" SPOUT (MODEL 8714)
7" NOMINAL
OPEN POSITION
1/2" VERTICAL
ADJUSTMENT
2-1/16"
1/2"
Complies with ASME A112.18.1M and CSA B125
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Disassembly 1. Turn “OFF” both hot and cold water supplies. Turn faucet on to relieve pressure and insure complete shut-off.. Pull handle cap up and off (it snaps into place). Remove the handle screw, (Illustration 1). 2. Push the cartridge stem down and then lift and tilt handle lever and handle bo...
Reassembly 1. With cartridge stem UP , insert cartridge with ears aligned front to back (illustra- tion 4). 2. Push the cartridge down by the ears (Illustration 5) until the top of the ears are flush with the top of the body. 3. Turn notched flat of cartridge stem toward front of sink. (Note: for cr...
MT149A SEP 95 © Copyright, 1995 Moen Incorporated Printed in U.S.A. Consumer Information Faucets made of leaded brass alloys may contribute small amounts of lead to water that is allowed to stand in contact with the brass. The amount oflead contributed by any faucet is highest when the faucet is new...
