Moen 8416 - Manual
Moen 8416 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation; Lift Rod & Waste Assembly; Flushing
- Page 3 – Disassembly; Cleaning & Care Instructions for; Reassembly
- Page 4 – Consumer Information
MT138A
INSTALLATION INSTRUCTIONS
LAVATORY FAUCETS
Four-Inch Centerset
6" X 2" WIDE
1/2" IPS
THREADED
CONNECTIONS
LIFT ROD
POSITION
USE SPACER TO INSTALL
ON THINNER LAVATORY
BOWLS OR COUNTERS
DISCARD SPACER WHEN
INSTALLING ON THICKER
LAVATORY BOWLS OR COUNTERS
1-3/4"
MAX.
4-3/4"
3-5/8" C.C.
1-3/4"
5" NOMINAL
OPEN
POSITION
5" NOMINAL
OPEN
POSITION
CONCENTRIX HANDLE
CONCENTRIX
HANDLE INSERT
3-5/8" C.C.
1-3/4"
3-5/8" C.C.
1-3/4"
5" NOMINAL
OPEN
POSITION
LEVER HANDLE
KNOB HANDLE
With clamp bar, spacer and
mounting nut installed, tilt
clamp bar back as shown,
then drop faucet supplies
down through deck holes and
tighten from below. On decks
thicker than 3/4" you may
have to remove spacer.
Fits 4" centers and through a 1" minimum diameter hole.
All models equipped with a Moen Flow-Rator™.
TILT BACK
CLAMP BAR
8410, 8415, 8416, 8450, 8455
®
Always turn water off before disassembling the valve. Open valve handle to alleviate
water pressure to insure that complete water shut-off has been accomplished.
Before turning water on during either rough-in or trim-out, make sure that the cartridge retainer clip is in place. The cartridge
and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible
that through the handling of the valve by any number of persons the retainer clip may not be properly installed. This should
be carefully checked at time of rough-in and trim-out. If the retainer clip is not properly installed, water pressure could force
the cartridge out of the casting. Personal injury or water damage to the premises could result.
CAUTION:
CLIP
EAR
Complies with ASME A112.18.1M and CSA B125
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
FAUCET CONNECTION NIPPLE TIGHTEN NUT HOLD WITH WRENCH Installation Be sure lavatory or mounting surface is clean and dry. Place a bead of plumber's putty around the inside lip of the gasket, position gasket on deck. Assemble clamp bars, spacers if needed, and mounting nuts to escutcheon sutds. Tilt ...
Disassembly CAUTION: Turn OFF both hot and cold water supplies. Open handle to alleviate water pressure to insure that complete water shut-off has been accomplished. For Knob Models: 1. Remove handle cover, handle screw, knob, stop tube, washer, and retainer clip. For Concentrix Handle Models: 1. Re...
MT138A SEP 95 © Copyright 1995 Moen Incorporated Printed in U.S.A. Consumer Information Faucets made of leaded brass alloys may contribute small amounts of lead to water that is allowed to stand in contact with the brass. The amount of lead contributed by any faucet is highest when the faucet is new...
