Moen 8901 - Manual
Moen 8901 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Check the system for leaks.
- Page 3 – Disassembly; Lift off the retaining ring.; Reassembly; Replace retaining ring.
- Page 4 – Consumer Information; Use only cold water for drinking or cooking.
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
MODELS 4901, 8901
Measurements
Installs through 1-1/4" hole drillings on 4" centers.
Escutcheons diameters - 1-3/4".
Supplies are 3/8" O.D. copper tubing with 1/2" male
NPT nipple connedtions. Makes up to supply stops or
connec tions with flexible supplies.
The spout is not a swing spout. Fasten spout escutch-
eon securely before tightening the spout nut.
Equipped with flow control aerator.
BAR SINK FAUCET WITH
GOOSENECK SPOUT
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
10-3/4"
8-1/2"
3-1/2"
SPOUT
NUT
ESCUTCHEON
SPOUT
ASSEMBLY
HANDLE
HOUSING
HANDLE
LEVER
ESCUTCHEON
WASHER
SPACER
RETAINER
CLIP
MODEL 8901
NOTE: Maximum Deck
Thickness is 1/16".
CAUTION:
CLIP
EAR
CLIP
EAR
Always turn water off before disassembling the valve. Open valve
handle to relieve water pressure and insure that complete water shut-
off has been accomplished.
Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place. The
cartridge and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely,
it is nevertheless possible that through the handling of the valve by any number of persons the retainer clip
may not be properly installed. This should be carefully checked at time of rough-in and trim-out. If the retainer
clip is not properly installed, water pressure could force the cartridge out of the casting. Personal injury or water
damage to the premises could result.
®
Complies with ASME A112.18.1M and CSA B125
MT161A
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
WASHER AERATOR SPOUT NUT RETAINING RING SPOUT O-RING ESCUTCHEON Maintenance Your new Moen faucet will give good service for an extended period of time. Should foreign materials in the system affect itsoperation, routine repairs can be easily made. If your faucet drips from the spout end or leaks up ...
Disassembly 1. Turn "OFF" both hot and cold water supplies. Turnfaucet on to relieve pressure and insure completeshut-off. Pull handle cap up and off (it snaps intoplace). Remove the handle screw (illustration 1). 2. Push cartridge stem down and then lift and tilthandle lever and handle body...
MT161A SEP 95 Copyright 1995 Moen Incorporated Printed in U.S.A. Consumer Information Faucets made of leaded brass alloys may contribute small amounts of lead to water that is allowed to stand in contact withthe brass. The amount of lead contributed by any faucet is highest when the faucet is new. T...
