Mitsubishi Electric FD630U - Manual
Mitsubishi Electric FD630U – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Control command configuration; Code unique to each control operation.
- Page 6 – Use the following commands to obtain other information.
- Page 7 – How to set the value; Use the character or ASCII code as shown below to set the value.; Function commands
- Page 10 – Password lock commands
1
DLP
Projector
XD600U/XD600U-G/WD620U/WD620U-G/FD630U/FD630U-G
Controlling the projector using a personal computer
This projector can be controlled by connecting a personal computer with RS-232C terminal.
PC-controllable functions:
•
Turning the power ON or OFF
•
Changing input signals
•
Inputting commands by pressing the buttons on the control panel and remote control
•
Menu setting
Connection
Important:
•
Connect the computer with the projector on a one-to-one basis.
•
Make sure that your computer and projector are turned off before connection.
•
Boot up the computer first, and then plug the power cord of the projector.
(If you do not follow this instruction, the Com por t may not function.)
•
Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.
1. Interface
1.1 Pin assignment of SERIAL terminal (Mini-DIN 8-pin)
1.2 Communications format
This projector uses RXD, TXD and GND lines for RS-232C control.
Pin No.
Name
I/O
1
RXD
IN
2
OPEN
3
OPEN
4
GND
5
OPEN
6
OPEN
7
TXD
OUT
8
OPEN
PROTOCOL
RS-232C
BAUD RATE
9600 [bps]
DATA LENGTH
8 [bits]
PARITY BIT
NONE
STOP BIT
1 [bit]
FLOW CONTROL
NONE
1
2
3
4
5
6
7
8
RS-232C
terminal
D-SUB 9-pin
RS-232C cable
Mini-DIN 8-pin
SERIAL
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 2. Control command configuration The command consists of the address code, function code, data code, ACK/NAK, and end code. The length of the com-mand varies among the functions. [Address code] Fixed to 00. (‘30h’ ‘30h’ in the ASCII code) [Function code] Code unique to each control operation. [Dat...
6 Use the following commands to obtain other information. The PC sends the command without attaching the data code to it. On the other hand, the projector attaches tothe received command its current operating status as the data code and send it back to the PC. [Example] When checking the currently s...
7 [Example] When displaying the MENU selection bar. (Values enclosed in quotation marks are ASCII codes.): 4.4 Direct commands (Not executable in stand-by mode. Possible only to read during muting.) The direct commands are used to numerically adjust the volume and keystone.When the computer sends th...
