Milwaukee 2912-20-2829-20 - User Manual
Milwaukee 2912-20-2829-20 Hammer Drill – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – READ ALL SAFETY WARNINGS AND ALL INSTRUCTIONS; Capacities; BPM; US
- Page 4 – LIMITED WARRANTY - USA AND CANADA
- Page 5 – LIRE TOUTES LES RÈGLES ET INSTRUCTIONS DE SÉCURITÉ.; WAUKEE
- Page 6 – Ne recharger la
- Page 7 – GARANTIE LIMITÉE - AUX ÉTATS-UNIS ET AU CANADA; MILWAUKEE
- Page 8 – LEA TODAS LAS ADVERTENCIAS E INSTRUCCIONES DE
- Page 10 – PÓLIZA DE GARANTÍA - VALIDA SOLO PARA MÉXICO,
- Page 11 – MILWAUKEE ELECTRIC TOOL CORPORATION; UNITED STATES; MILWAUKEE Service; CANADA; CENTRO DE ATENCION A CLIENTES; Contacta nuestro servicio técnico para....; MEXICO; - Soporte de Servicio
OPERATOR'S MANUAL
MANUEL de L'UTILISATEUR
MANUAL del OPERADOR
TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND OPERATOR'S
MANUAL.
AFIN DE RÉDUIRE LE RISQUE DE BLESSURES, L'UTILISATEUR DOIT LIRE ET BIEN
COMPRENDRE LE MANUEL DE L'UTILISATEUR.
PARA REDUCIR EL RIESGO DE LESIONES, EL USUARIO DEBE LEER Y ENTENDER EL
MANUAL DEL OPERADOR.
Cat. No.
No de cat.
2712-20
M18™ FUEL™ 1" SDS PLUS ROTARY HAMMERS
PERCEUSES À PERCUSSION SDS PLUS DE 25 mm (1")
FUEL™ M18™
ROTOMARTILLOS SDS PLUS FUEL™ M18™ DE 25 mm (1")
SDS
PLUS
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 3 PERSONAL SAFETY GENERAL POWER TOOL SAFETY WARNINGS WORK AREA SAFETY ELECTRICAL SAFETY POWER TOOL USE AND CARE • Recharge only with the charger specifi ed by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fi re when used with another battery pack. B...
6 7 APPLICATIONS Selecting Bits When selecting a bit, use the right type for your job. For best performance, always use sharp bits. Drilling 1. Before drilling, be sure the workpiece is clamped securely. Use backing material to prevent dam-age to the workpiece during breakthrough. 2. When starting a...
8 9 RÈGLES DE SÉCURITÉ GÉNÉRALES RELATIVES AUX OUTILS ÉLECTRIQUES SÉCURITÉ DU LIEU DE TRAVAIL • Maintenir la zone de travail propre et bien éclairée. Les zones encombrées ou mal éclairées sont favorables aux accidents. • Ne pas utiliser d’outil électrique dans une at- mosphère explosive, telle qu’en...
