Milwaukee 2718-22HD - User Manual
Milwaukee 2718-22HD Hammer Drill – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – BPM; WARNING
- Page 3 – FUNCTIONAL DESCRIPTION; OPERATION
- Page 4 – MAINTENANCE
- Page 5 – AVERTISSEMENT
- Page 6 – Insertion/Retrait de la batterie; Attache de poignée latérale
- Page 7 – MANIEMENT
- Page 8 – ENTRETIEN; ACCESOIRES
- Page 9 – ADVERTENCIA
- Page 10 – Como se inserta/quita la batería en la; Agarre del mango lateral
- Page 11 – OPERACION
- Page 12 – MANTENIMIENTO; ACCESORIOS; SOPORTE DE SERVICIO - MEXICO
- Page 13 – MILWAUKEE TOOL; PÓLIZA DE GARANTÍA - VALIDA
Cat. No. / No de cat.
2718-20
M18 FUEL™ 1-3/4" ROTARY HAMMER WITH ONE-KEY™
MARTEAU ROTATIF DE 45 mm (1-3/4") M18 FUEL™ AVEC
ONE-KEY™
MARTILLO ROTATIVO DE 45 mm (1-3/4") M18 FUEL™ CON
ONE-KEY™
OPERATOR'S MANUAL
MANUEL de L'UTILISATEUR
MANUAL del OPERADOR
WARNING
To reduce the risk of injury, user must read and understand operator's manual.
AVERTISSEMENT
Afin de réduire le risque de blessures, l'utilisateur doit lire et bien
comprendre le manuel.
ADVERTENCIA
Para reducir el riesgo de lesiones, el usuario debe leer y entender el manual.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 3 • WARNING Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paint • crystalline silica from bricks and ...
4 5 Selecting Action These MILWAUKEE Rotary Hammers have three settings: hammering with rotation, hammering-only, and chisel adjustment. 1. Hammering with rotation. Use this setting for drilling holes with drill bits. 2. Hammering only. For use with “hammering-only” accessories. Use this setting for...
6 7 4. Press the centering bit firmly against your cen- ter mark, hold the tool firmly and pull the trig- ger. N O T E : I f t h e 48-20-5099 threaded stud is used, or a cen- ter pin and guide plate are not available, use a template or notched board to start the hole. 5. Start the tool. After drill-...
