Miele O 184 - User Manual

M.-Nr. 07 912 020 / 00

en

Upper basket O 184 for laboratory glassware

Miele Company Ltd., Fairacres, Marcham Road, Abingdon, Oxon, OX14 1TW, Tel 0845 365 0555,
Fax 0845 365 0777, Internet: http://www.miele.co.uk /

!

Alteration rights reserved / Publication date 19.08.2010

Intended use:

Up to 96 centrifugal tubes, phials and test tubes can be processed in this upper basket.

Laboratory glassware, which because of its design cannot be flushed through properly, should not be
processed in this basket.
This basket should only be used for processing laboratory glassware which has been declared as suitable for
machine processing by the glassware manufacturer.

,

Please observe the Warning and Safety instructions in the Operating Instructions for your washer-

disinfector as well as any instructions provided by the glassware manufacturer.
Broken glassware can cause serious injury.
All glassware should be properly inspected and tested for cleanliness. Do not rely on a visual check alone.

Please note:

If this basket is used in conjunction with a

lower basket with water feed pipe

, e. g. U 175/1, you will need to

remove the stopper from the water connection in the upper basket. Loosen the nut slightly to release the stop-
per. (Applies to G 7836 and PG 8536 washer-disinfectors only).

If the upper basket is used with a

lower basket which does not have a water feed pipe

, the stopper must be

fitted in the water connection.

,

Use the LAB PIPETTES programme or increase the water intake for the relevant reprocessing

programmes as follows:
G 7836, PG 8536 + 5 litres
G 7835, G 7883, G 7883 CD, G 7893, PG 8535 + 6 litres

Do not allow individual pieces of glassware to touch
each other.

If the tip of the jet touches the base of the glassware,
slide the plastic support up and secure with the
O ring.

Tighten loose jets with an SW 9 spanner.

^

Fit the seal in the holder in the upper basket.

^

Then fit the water feed pipe into the holder. The hot
air drying connection point must face the back of
the basket.

^

Tighten the nut by hand.

To avoid having to keep adjusting the height of the
plastic supports, the injector module should be
used for glassware of the same type and size.

The plastic support can be moved in order to adjust
the height of the jet to the height of the item being
processed. Pliers can be used to do this if necessary.

^

Slide the plastic support on the jet to the required
height.

^

Slide the O ring up under the plastic support to
secure its position.

Fitting the water feed pipe:

Light items can be secured with an A5 cover.

To avoid the A5 cover slipping during processing,
only glassware of a similar type and size should be
processed together.

Remove coarse soiling from centrifugal tubes before
processing.

Items supplied:

Upper basket O 184, H 260 (with TA 468), W 531,
D 475 mm

96 x ID 110 jets, 2.5 x 110 mm

1 water feed pipe

1 Seal

Arranging the laboratory glassware: