Page 2 - Contents
Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Disposal of the packing material . . . . . . . . . . . . . . . . . . . . . . . ...
Page 4 - Warning and Safety instructions
To avoid the risk of accidents anddamage to the machine please readthese instructions carefully beforeusing it for the first time. Theycontain important information on itssafety, use and maintainence.Keep these operating instructions ina safe place and ensure that newusers are familiar with the cont...
Page 5 - Operation
If the connection cable is faulty itmust only be replaced by a Miele approved service technician to protectthe user from danger. In the event of a fault or forcleaning purposes, the machine is only completely isolated from theelectiricty supply when: – it is switched off at the wall socket and the p...
Page 6 - Using accessories
Always close the door after use.This way you will avoid the danger of: – children climbing onto or into the dryer or hiding things in it. – pets or other small animals climbing into it. Do not let anyone sit or lean on thedoor, as this can cause the machine to tip up. There is danger of fire with fa...
Page 7 - To save energy and time:; Caring for the environment
Disposal of the packingmaterial The transport and protective packinghas been selected from materials whichare environmentally friendly for disposaland can normally be recycled. Ensure that any plastic wrappings,bags etc. are disposed of safely andkept out of the reach of babies andyoung children. Da...
Page 8 - Control panel / Features; Delay Start; Start; Timed drying; Programme selector; Door; Guide to the appliance
Control panel / Features a Delay Start button The start of a programme can bedelayed by up to 24 hours. b Start button Press the Start button to start a programme.The indicator lamp will flash toindicate that a programme can bestarted. It lights up constantly oncethe programme has started. c Display...
Page 10 - Wash care labels; Tips on drying; Notes on laundry care
Wash care labels Before drying check the dryingsymbol on the wash care label. Significance of symbols: q Dry at normal temperature r Dry at low temperature s Do not tumble dry If no symbol is featured, dry at yourown risk applying the followingprinciples: Cotton and minimum iron items shouldbe dried...
Page 11 - rr; Programme chart
Programmes Fabric type Special notes Drying levels COTTONS maximum load: 5 kg (1) Extra dry Multi-layered fabrics, which would not be thoroughly dried using the "Normal +" programme. Do not dry jersey wear in the Extra dry programme - tendency to shrink. Normal + Single and multi-layered fab...
Page 14 - Prepare the laundry; the type of fibre or weave,; Load the drum and switch; How to dry correctly
A Prepare the laundry ^ As far as possible, sort laundry for:- the type of fibre or weave, - the degree of dryness required, - similar size of items, - the moisture content afterspinning. This will help towards achieving aneven drying result. Fasten duvet covers etc. to preventsmall items from being...
Page 15 - Selecting a programme; Selecting additional options
C Selecting a programme ^ Turn the programme selector to theprogramme required. COTTONS and MINIMUM IRONThe length of the programme iselectronically calculated according tothe residual moisture content of theload. Approx. drying times are given inthe "Consumption data" chart. Woollens Hand c...
Page 16 - Delay start
Short For drying fabrics which canwithstand high temperatures, e.g.pure linens and cottons. Do not useon minimum iron or delicate fabrics. – Because the heater rating is increased clothes dry faster thusshortening drying times. Low temperature For drying delicate fabrics with thesymbol r (e.g. acryl...
Page 17 - Starting a programme; After drying; Additional notes
F Starting a programme ^ Press the Start button. The drying cycle begins. The drying stage reached is shown bythe sequence indicator lamps on theright hand side of the control panel. At the end of the drying phase, acooling down phase commences tocool the laundry down (the Cool air indicator lamp li...
Page 18 - Brief instructions
Brief instructions These instructions are designed as abrief guide only. Please make sure thatyou also read the detailed instructionsat the beginning of this section. A Sort the laundry B Load the dryer and switch it on ^ Press the Door button to open the door. ^ Load the drum. ^ Close the door. ^ S...
Page 19 - To change a programme; To interrupt a programme
To change a programme Programmes cannot be changed afterthe start button has been pressed. Ifthe programme selector is turned to adifferent programme after a programmehas begun, this will not affect theprogramme. The Anti-crease / Finish indicator lamp will flash. The indicatorlamp will go out when ...
Page 20 - Electronic system lock
The system lock prevents anyonefrom interfering with the dryer. If the system lock has been activated itis not possible to start a programme. The following steps ( A , B , C ...) must be carried out in the correct order . Please proceed step by step: To activate the system lock A Ensure that the doo...
Page 21 - or as soon as the; indicator lamp; indicator lamp; Empty out container; indicator lamp will go out.; Cleaning and care
Emptying the condensedwater container The condensed water will be collectedin the condensed water containerunless the machine has been fitted witha drain hose (see installation). The condensed water containershould be emptied after every drying cycle or as soon as the Empty out container indicator l...
Page 22 - Cleaning the fluff filters; each
Cleaning the fluff filters The fluff which is created by the dryingprocess is collected by the fluff filters inthe door and the door opening. Cleanthe filters after each drying programme. Cleaning them whilst dry ^ Open the door and pull the fluff filterout of the door as illustrated. ^ Use your fin...
Page 23 - Cleaning them with water; Dry the filters thoroughly with care.; Cleaning the tumble dryer; Do not; use solvents, abrasive
Cleaning them with water If there is a great deal of compactedfluff on any of the filters, they can beremoved and cleaned under hotrunning water. ^ To remove the fluff filter from the doorholder see previous page. ^ Grip the holder and push the filter inthe door opening upwards in thedirection of th...
Page 24 - Cleaning the condenser unit; Check; the condenser unit at least; Removing the condenser unit; Then place it to one side.
Cleaning the condenser unit Detergent residue, hair and fine flufffrom the dryer can get through the flufffilters and block the condenser unit. Dust from the room in which the dryer isinstalled can also get into thecondenser unit and cause a blockage. Check the condenser unit at least twice a year. ...
Page 25 - If you cannot see any fluff:
^ Pull the condenser unit out of itshousing by the handle. Checking the condenser unit ^ Hold the condenser unit up to thelight as shown . ^ Check to see if there is any fluffinside it.The arrows in the illustration aboveindicate where to look. If you cannot see any fluff: ^ Replace the condenser un...
Page 26 - Replacing the condenser unit
^ Then flush the unit through from thefront. ^ Check the condenser unit again forany visible fluff and if necessary flushit through again until it has all gone. ^ Remove any soiling still visible insidethe housing unit. ^ Also make sure the rubber seals areclean. The rubber seals must not beremoved ...
Page 27 - Problem solving guide
With the help of the following notes minor faults in the performance of themachine, some of which may result from incorrect operation, can be put rightwithout contacting the Service Department. , Repair work to electrical equipment should only be carried out by a suitably qualified person in accorda...
Page 29 - : Before attempting to remedy one of the
Problem Possible cause Remedy The drying processgoes on too long oreven switches off. Important : Before attempting to remedy one of the following causes, switch the dryer off and switch on againto start the programme again. Ventilation to and from thedryer may be insufficient(e.g because it is inst...
Page 31 - There is no obvious cause.; Clean out; Check the drain hose.
Problem Possible cause Remedy The Clean outairways lamp comeson. The fluff filters may beblocked. Remove any fluff (see"Cleaning and care"). The condenser unit may beblocked with fluff anddetergent residues. Please note that thecondenser unit must becleaned regularly (see"Cleaning and ca...
Page 32 - This might be because:
Problem Possible cause Remedy The programme hasbeen interrupted,the indicator lampfor Hand iron orMachine iron isflashing, and thebuzzer sounds. No obvious cause. – Switch the dryer off andthen on again. – Then start the programmeagain. If the programme stopsagain and an indicator lampflashes, there...
Page 34 - After sales service; Repairs; – Your Miele Dealer or; Optional accessories
After sales service Repairs In the event of any faults which youcannot remedy yourself, please contact – Your Miele Dealer or – The nearest Miele Service Department (see back cover foraddress). When contacting the ServiceDepartment, please quote the Modeland Serial numbers both of which arelocated o...
Page 35 - Front view; Condensed water container; Installation
Front view a Supply cable for electricalconnection b Condensed water container c Control panel d Door e Service panel for condenser unit f Four height-adjustable screw feet g External drainage options (e.g. viawash basin, wash basin drain outlet,or gully). Installation 35
Page 36 - Installation site; Make sure the dryer door can be; building under kit; – The electrical socket must be; Replacing the lid
Installation site , Make sure the dryer door can be opened without hindrance afterinstallation. Transporting the machine to itsinstallation site When moving the machine you canhold it by the lid where it protrudes tothe rear of the dryer.To manoeuvre the dryer out of itspacking case to its installat...
Page 37 - Aligning the machine; The ventilation gaps in the plinth; Room in which the dryer is located; programme for
Aligning the machine The machine must be perfectly level toensure safe and proper operation. ^ The screw feet can be adjusted tocompensate for any unevenness inthe floor. , The ventilation gaps in the plinth must not be covered over as thiswould prevent a sufficient intake ofair. Room in which the d...
Page 40 - Blue; Electrical connection
Electrical connection U.K. All electrical work should be carried outonly by a suitably qualified andcompetent person, in strict accordancewith national and local safetyregulations. Ensure power is not supplied to themachine while installation work is beingcarried out. The machine is supplied with a ...
Page 41 - or coloured green, or
If the colours of the wires in the mainslead of this machine do not correspondwith the coloured markings identifyingthe terminals of your plug, proceed asfollows: ^ The wire which is coloured green andyellow must be connected to theterminal in the plug which is markedwith the letter E or by the eart...
Page 42 - Consumption data
Programme Capacity Final spin speed (in a domestic washing machine) Electricityconsump- tion Drying time incl. cooling down time kg rpm kWh Minutes COTTONS Extra dry 5.0 120014001600 3.253.102.85 868376 Normal + 5.0 120014001600 2.802.652.40 767366 Normal (1) 5.0 800 (70 % residual moisture) 3.40 89...
Page 43 - Technical data
Height 85 cm (adjustable +0.7/- 0.7 cm) Height without lid 82 cm Width 59.5 cm Depth 58 cm Depth with door open 106 cm Weight 54 kg Drum volume 100 litres Maximum capacity 5 kg dry weight Capacity of condensedwater container approx. 3.5 litres Length of connection cable 1.60 m Maximum delivery head ...
Page 46 - Increased drying level; off; Programmable functions
Increased drying level The Sensitive System aims to dryusing as little energy as possible.However, if you require the laundry tobe drier, it is possible to reduce thefinal moisture level in the COTTONSand MINIMUM IRON programmes. The machine is delivered with thisprogrammable function switched off. ...
Page 47 - Memory
Memory The additional options selectedpreviously for specific programmesare stored in the machine’s memory. The machine is delivered with thisprogrammable function deactivated. Itcan be activated if wished. Programming andstoring in memory The programmable functions areactivated to call up further f...
