Midea MDWISS - User Manual

Disposal For disposing of package and the appliance please go to a recycling centre. Therefore cut off the power supply cable and make the door closing device unusable. Cardboard packaging is manufactured from recycled paper and should be disposed in the waste paper collection for recycling.By ensur...

PRODUCT OVERVIEW To get the best performance from your dishwasher, read all operating instructions before using it for the first time. upper spray arm Upper basket Lower basket Top spray arm Dispenser Filter assembly Lower spray arm Inner pipe Cup rack IMPORTANT: Pictures are only for reference, dif...

USING YOUR DISHWASHER 1. Loading the basket 2. Fill the rinse aid dispenser (Please check the section 1 of PART Ⅱ : Special Version) 3. Fill in detergent (Please check the section 1 of PART Ⅱ : Special Version) 9 Adjusting the upper basket The height of the upper basket can be easily adjusted to acc...

MAINTENANCE AND CLEANING External Care The door and the door seal Clean the door seals regularly with a soft damp cloth to remove food deposits.When the dishwasher is being loaded, food and drink residues may drip onto the sides of the dishwasher door.These surfaces are outside the wash cabinet and ...

Spray arms Wash the arms in soapy and warm water and use a soft brush to clean the jets. Replace them after rinsing them thoroughly. It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm jets and bearings. To clean the spray arms, follow the instructions ...

Caring For The Dishwasher Frost precaution please take frost protection measures on the dishwasher in winter. Every fter washing cycles,please operate as follows: 1. Cut off the electrical power to the dishwasher at the supply source. 2. Turn off the water supply and disconnect the water inlet pipe ...

INSTALLATION INSTRUCTION Ensure the voltage and frequency of the power being corresponds to those on the rating plate. Only insert the plug into an electrical socket which is earthed properly. If the electrical socket to which the appliance must be connected is not appropriate for the plug , replace...

Water Supply And Drain Cold water connection Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear...

Connection Of Drain Hoses Please securely fix the drain hose in either position A or position B B A MAX 1000mm Counter Drain hose Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the sink, making sure to avoid bending or crimping it. The height of drain pip...

Position The Appliance Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can be positioned either to the right or the left sides to fa...

Underneath existing work top ( when fitting beneath a work top) In most modern fitted kitchens there is only one single work top under which cabinets and electrical appliances are fitted. In this case remove the work top of the dishwasher by unscrewing the screws under the rear edge of the top ( a )...

Step 2. Aesthetic panel's dimensions and installation 2. If dishwasher is in stalled at the corner of the cabinet, thereshould be some space when the door is opened. Cabinet Dishwasher Door of dishwasher Minimum space of 50mm NOTE : Depending on where your electrical outlet is, you may need to cut a...

Step 3. Tension adjustment of the door spring 1. The door springs are set at the factory to the proper tension for the outer door. If aesthetic wooden panel are installed, you will have to adjust the door spring tension. Rotate the adjusting screw to drive the adjustor to strain or relax the steel c...

Step 4. Dishwasher installation steps 1. Affix the condensation strip under the work surface of cabinet. Please ensure the condensation strip is flush with edge of work surface. (Step 2) 2. Connect the inlet hose to the cold water supply. 3. Connect the drain hose. 4. Connect the power cord. 5. Plac...

UP DOWN Check level front to back Check level side to side Step 5. Levelling the dishwasher Dishwasher must be level for proper dish rack operation and wash performance. Place a spirit level on door and rack track inside the tub as shown to check that the dishwasher is level.Level the dishwasher by ...

24 TROUBLESHOOTING TIPS Before Calling For Service Reviewing the charts on the following pages may save you from calling for service. Problem Possible Causes What To Do Dishwasher doesn't start Fuse blown, or the circuit break tripped. Replace fuse or reset circuit breaker. Remove any other applianc...

28 1.Upper basket: 2.Lower basket: 1 2 3 Cups Saucers Glasses Item Number 7 8 9 Dinner plates Soup plates Dessert dishes Item Number LOADING THE BASKETS ACCORDING TO AS/NZS 2007.1: 4 4 1 1 1 1 1 1 1 1 1 1 1 1 2 2 3 3 3 3 3 3 3 3 5 5 2 2 6 6 6 6 6 6

CONTENTS ERROR CODES NOTE : If you cannot solve the problems by yourself, please ask for help from a professional technician.The manufacturer, following a policy of constant development and updating of the product, may make modifications without giving prior notice.If lost or out-of-date, you can re...

5 QUICK USER GUIDE Please read the corresponding content on the instruction manual for detailed operating method. 2 Removing the larger residue on the cutlery 3 Loading the baskets 4 Filling the dispenser Selecting a program and running the dishwasher Inside Outside 3 1 Install the dishwasher (Pleas...

4 USING YOUR DISHWASHER Control Panel Operation (Button) Power Delay Program Press this button to turn on your dishwasher, the screen lights up. Press the Delay button to increase the delay start time. Delay a cycle for up to 24 hours in one-hour increments. After setting the delay time, press the S...

Preparing And Loading Dishes Consider buying utensils which are identified as dishwasher-proof.For particular items, select a program with the lowest possible temperature.To prevent damage, do not take glass and cutlery out of the dishwasher immediately after the program has ended. Cutlery with wood...

Load hollow items such as cups, glasses, pans etc. With the opening facing downwards so that water cannot collect in the container or a deep base.Dishes and items of cutlery must not lie inside one another, or cover each other.To avoid damage, glasses should not touch one another.The upper basket is...

Loading the upper basket The upper basket is designed to hold more delicate and lighter dishware such as glasses, coffee and tea cups and saucers, as well as plates, small bowls and shallow pans (as long as they are not too dirty). Position the dishes and cookware so that they will not get moved by ...

The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes, which can leave spots and streaks. It also improves drying by allowing water to roll off the dishes. Your dishwasher is designed to use liquid rinse aids. When to refill the rinse aid dispenser WA...

3 Replace the cap by inserting it aligned with "open" arrow and turning it to the closed (right) arrow. NOTE : Clean up any spilled rinse aid with an absorbent cloth to avoid excessive foaming during the next wash. 1 2 To open the dispenser, turn the cap to the "open" (left) arrow an...

Filling The Detergent Dispenser 1 2 Press the release catch on the detergent dispenser to open the cover. Push latch to open A A B Add detergent into the larger cavity (A) for the main wash cycle . For more heavily soiled wash loads, also add some detergent into the smaller cavity (B) for the pre-wa...

12 PROGRAMMING THE DISHWASHER Wash Cycle Table The table below shows which programs are best for the levels of food residue on them and how much detergent is needed. It also show various information about the programs. ( )Means: need to fill rinse into the Rinse-Aid Dispenser. Program Running Time(m...

AS/NZS 2007.1 This program is the test cycle. The information for comparability test in accordance with AS/NZS 2007.1. : NOTE : Starting A Cycle Wash 1. Draw out the lower and upper basket, load the dishes and push them back. It is commended to load the lower basket first, then the upper one. 2. Pou...

Forget To Add A Dish? A forgotten dish can be added any time before the detergent dispenser opens. If this is the case, follow the instructions below: 1. 2. 3. Add the forgotten dishes. 4. Close the door. 5. The dishwasher will start run after 10 seconds. Open the door a little to stop the washing. ...

TECHNICAL INFORMATION Height (H) Width (W) Depth (D1) Depth (D2) 815mm 598mm 550mm (with the door closed) 1150mm (with the door opened 90 ° ) W W D 1 D 1 H H 16 D 2 D 2

17 Product fiche Manufacturer Type / Description Standard place settings Energy efficiency class Energy consumption of the standard cleaning cycle Water consumption of the standard cleaning cycle Program duration of the standard cleaning cycle Noise level Mounting Power consumption Water pressure (f...