Middleby Marshall PS300F - Manual

Page 2 - ENGLISH; can cause property damage, injury or death. Read the installation,; all warranty and liability.; Retain This Manual For Future Reference

ENGLISH 2 Middleby Cooking Systems Group 1400 Toastmaster Drive Elgin, IL 60120 USA (847)741-3300 FAX (847)741-4406 24-Hour Service Hotline: 1-(800)-238-8444 www.middleby.com NOTICE:This Owner's Operating and Installation Manual should be given to the user. The operator of the oven should ...

Page 3 - LOCATION AND DESCRIPTION OF CONTROLS .. 16

ENGLISH 3 SECTION 1 - DESCRIPTION .................................................... 4 I. OVEN USES ............................................................. 4 II. OVEN COMPONENTS ............................................. 4 A. Crumb Pans .......................................................

Page 4 - III. OVEN SPECIFICATIONS; SECTION 1 - DESCRIPTION

ENGLISH 4 III. OVEN SPECIFICATIONS A. Dimensions PS310 PS314 PS360/360Q/360S PS360 Tandem PS360WB PS360WB Tandem PS360EWB PS360WB70 Overall Height Lower oven, 45-1/2 45-1/2 45-1/2 45-1/2 45-1/2 45-1/2 45-1/2 45-1/2 with top & legs 1143mm 1143mm 1143mm 1143mm 1143mm 1143mm 1143mm 1143mm U...

Page 5 - IMPORTANT

ENGLISH 5 B. General specifications (per oven cavity) PS310 PS314 PS360/360Q/360S PS360WB PS360EWB PS360WB70 Weight 1165 lbs./529kg 1165 lbs./529kg 1285 lbs./583kg 1485 lbs./674kg 1620 lbs./733kg 1825 lbs./829kg Shipping Weight 1241 lbs./563kg 1241 lbs./563kg 1360 lbs./617kg 1560 lbs./708kg 1695 lbs...

Page 6 - PS360 Pre-Installation Procedures Manual

ENGLISH 6 SECTION 2 - INSTALLATION WARNING Keep the appliance area free and clear of combustibles. WARNING Do not obstruct the flow of combustion and ventilation air to and from your oven. There must be no obstructions around or underneath the oven. Constructional changes to the area where the oven ...

Page 7 - NOTE; B. Additional installation kit components for gas ovens

ENGLISH 7 Fig. 2-1 - Installation Kit I. INSTALLATION KIT SECTION 2 - INSTALLATION A. Installation kit components (one kit required per cavity) Item Description Part Number Lower Oven w/o Top Lower Oven w/Top Upper Oven 1 Legs, adjustable 22450-0028 4 4 - - 2* Caster, Swivel (with stud) 37115-0102 4...

Page 8 - C. Other ventilation concerns; CAUTION; II. VENTILATION SYSTEM; Where national or local codes require the; MOUNTING SUCH EQUIPMENT ON

ENGLISH 8 18" 458mm 18" 458mm 12" 305mm 3" 76mm 2"/51mm minimum B. Recommendations NOTE THAT THE HOOD DIMENSIONS SHOWN IN FIGURE 2- 2 ARE RECOMMENDATIONS ONLY. LOCAL AND NATIONAL CODES MUST BE FOLLOWED WHEN INSTALLING THE VENTILATION SYSTEM. ANY APPLICABLE LOCAL AND NATIONAL CODE...

Page 9 - IV. THERMOCOUPLE INSTALLATION; Figure 2-4 - Thermocouple Installation Locations

ENGLISH 9 IV. THERMOCOUPLE INSTALLATION 1. Install one thermocouple sensing bulb into each of the two holes in the rear panel of the oven, as shown in Figure 2-4. Fasten each thermocouple in place using one of the #10- 32 x 3/8" screws supplied in the Installation Kit. 2. Thread BOTH sets of the...

Page 10 - V. TANDEM OVEN ASSEMBLY; Oven Positioning and Alignment; on all mating ends

ENGLISH 10 Figure 2-8 - Cooling Fan Removal V. TANDEM OVEN ASSEMBLY NOTE For non-tandem oven installations, skip ahead to Section VI, Conveyor Installation. 1. Determine the proper position of the ovens by referring to Figure 2-7. Then, move the ovens to their approximate final locations. Figure 2-7...

Page 12 - VI. CONVEYOR INSTALLATION; Figure 2-15 - Checking the conveyor tension; Figure 2-12 - Removing the Conveyor Drive Sprocket

ENGLISH 12 VI. CONVEYOR INSTALLATION Refer to either Step A or Step B in this section, as appropriate, to install the conveyor and belt. A. Installing the Conveyor - All ovens EXCEPT Tandem modelsNOTE Split belt conveyors can only be installed from the end of the oven with the drive motor.Single-bel...

Page 14 - WARNING

ENGLISH 14 Figure 2-24 - Utility Connection Locations Electrical Junction Box Figure 2-23 - Oven Serial Plate Gas oven: 3/4" (19mm) pipe for gas utility connection Electric oven: 1-1/2" (38mm) conduit for electric utility connection Figure 2-25 - Flexible Gas Hose Installation Appliance Conn...

Page 15 - Gas Meter

ENGLISH 15 IX. GAS SUPPLY (gas ovens only) Figure 2-26 - Gas Burner and Piping Assembly Manual shutoff valve Pilot pressure tap (where pilot gas pressure is measured) Combination Gas Control Valve (Safety Regulator) Inlet pressure tap (where incoming gas pressure is measured) Manifold pressure tap (...

Page 16 - I. LOCATION AND DESCRIPTION OF CONTROLS; Conveyor Speed Controller:

ENGLISH 16 SECTION 3 - OPERATION I. LOCATION AND DESCRIPTION OF CONTROLS Fig. 3-1 - Control Panel "BLOWER" Switch: Turns the blowers and cooling fans on and off. The HEAT Switch has no effect unless the BLOWER Switch is in the ON position. All ovens except PS360EWB and PS360WB70 PS360EWB a...

Page 17 - A. DAILY STARTUP PROCEDURE; The burner will not operate and gas will not flow through; or; B. DAILY SHUTDOWN PROCEDURE; or

ENGLISH 17 A. DAILY STARTUP PROCEDURE 3. Turn the "CONVEYOR" (or ) switch to the ON (or "I") position. 4. If necessary, adjust the conveyor speed setting by turning the three thumbwheels to change the displayed bake time. 5. Adjust the temperature controller to a desired set temper...

Page 18 - III. QUICK REFERENCE: DIGITAL TEMPERATURE CONTROLLER

ENGLISH 18 III. QUICK REFERENCE: DIGITAL TEMPERATURE CONTROLLER Display S h o w s t h e S e t Point or the Actual Temperature in degrees Fahren- heit (F) or Celsius (C). "SP LOCK" Light Lights when the set point is locked out from changes. This setting can only be changed by service personne...

Page 19 - SYMPTOM

ENGLISH 19 V. QUICK REFERENCE: TROUBLESHOOTING SYMPTOM PROBLEM SOLUTION The oven temperature ex- ceeded 650°F (343°C), and the burner was automati- cally shut down. Follow the procedures under Daily Shutdown Procedures in this section to shut down the oven. Contact your Middleby Marshall Authorize...

Page 20 - properly on the floor.; Authorized Service Agent.; BLOWER switch or any other circuit of the oven switched on.; aluminized bake chamber surfaces.; performed ONLY by a Middleby Marshall Authorized Service Agent.; SECTION 4 - MAINTENANCE

ENGLISH 20 WARNING Before ANY cleaning or servicing of the oven, perform the following procedure:1. Switch off the oven and allow it to cool. Do NOT service the oven while it is warm.2. Turn off the electric supply circuit breaker(s) and disconnect the electric supply to the oven.3. If it is necessa...

Page 21 - All ovens; except

ENGLISH 21 I. MAINTENANCE - DAILY A. Check that the oven is cool and the power is disconnected, as described in the warning on Page 20. B. Clean the outside of the oven with a soft cloth and mild detergent. C. Clean ALL of the cooling fan grills and vent openings with a stiff nylon brush. Refer to F...

Page 23 - DO NOT lubricate the shafts using WD40 or a similar

ENGLISH 23 III. MAINTENANCE - EVERY 3 MONTHS A. Check that the oven is cool and the power is disconnected, as described in the warning on Page 20. B. Vacuum both of the blower motors, and their surrounding compartments, using a shop vacuum. C. Tighten all electrical control terminal screws. D. For s...

Page 24 - page; B. Additional Key Spare Parts Kit components for gas; An electrical wiring diagram for the oven is located inside the

24 ENGLISH FRANÇAIS ES PAÑOL page 1 page 25 página 49 Middleby Cooking Systems Group 1400 Toastmaster Drive Elgin, IL 60120 USA (847)741-3300 FAX (847)741-4406 24-Hour Service Hotline: 1-(800)-238-8444 www.middleby.com V. KEY SPARE PARTS KIT - Available separately. See Figure 4-9. A. Key S...

Middleby Marshall PS300F - Manual

Table of Contents:

Summary

Other Middleby Marshall Models