Page 2 - The; Pulsar EX RT; Models that are covered in this manual are listed below.; Important safety instructions; Read before installing product; Introduction
SAVE THESE INSTRUCTIONS. This manual contains important instructions that should be followed duringinstallation and maintenance of the UPS and batteries. Thank you for selecting an MGE UPS SYSTEMS, Inc. product to protect your electrical equipment. The Pulsar EX RT range has been designed with the u...
Page 3 - CAUTION: Safety of persons; Do not lay tools or metal parts on top of batteries.; CAUTION: Product Safety; Never let a foreign body penetrate inside the UPS.; Special Precautions
3400753300/AE - Page 3 CAUTION: Safety of persons ◗ The UPS has its own internal power source (the battery). Consequently, the power outlets may be energized even if the UPSis disconnected from the AC-power source. ◗ Dangerous voltage levels are present within the UPS. It should be opened exclusivel...
Page 4 - Using this document; How to use this document; Icon Usage; Information may be found primarily by consulting:
Page 4 - 3400753300/AE Using this document How to use this document Icon Usage Information may be found primarily by consulting: ◗ The contents, ◗ The index. In the illustrations on the following pages, the symbols below are used: LED off. LED on. LED flashing. Audio indication. Action. Visual indic...
Page 5 - Connection to the RS232 or USB communication port; Operation; Operation on battery power; Contents
3400753300/AE - Page 5 1. Presentation 1.1 System configurations ................................................................................................................ 7 Rack setup ................................................................................................................
Page 7 - System configurations; Model
P U L S A R www.mgeups.com 10 0% 80 % 50 % 20 % te st % 1 2 % B Y P A S S E X 3400753300/AE - Page 7 Tower setup Rack setup 1.1 System configurations 1. Presentation www.mgeups. com P U L S A R 3.75 inches (2U) 25.75 inches (EX 2200RT)26.00 inches (EX 3200RT) 17.24 inches (19" Rack mount) 100% 8...
Page 10 - UPS Driver
Page 10 - 3400753300/AE 34 34 36 35 36 35 30 32 31 30 32 31 RS232 communication cable. USB communication cable. Telescopic rails for mounting in 19" bay with mounting hardware. CD-ROM with the Solution-Pac and UPS Driver software. Product documentation. Two supports for the upright position. 2.1...
Page 11 - Installation in rack position
3400753300/AE - Page 11 3 3 7 Stop-Notch Snap from inside of rails 2 6 4 5 5 2 1 CAUTION: Do not lean or place objects on top of unit at any time. Hazard of dismounting and disconnection canoccur with units. NOTE: (For step 5) it is possible to adjust the position of the front fixing bracket. Follow...
Page 12 - Pull out the MGE Logo and Model plates, then rotate them as shown.; Installation in tower position
Page 12 - 3400753300/AE Install the two supports for the upright position using provided hardware in the package. (see item 32 on page 10). Pull out the MGE Logo and Model plates, then rotate them as shown. 2. Installation 2.3 Installation in tower position P U L S A R P U L S A R www .m g e ups.c o...
Page 15 - Solution Pac; LEDs 24 to 27 provide three; All connected equipment is energized.
3400753300/AE - Page 15 27 26 25 18 17 16 24 20 19 21 22 23 27 26 25 18 17 16 Description of LED indicator status 20 and 21 for programmable outlets 1 and 2: ◗ OFF: the outlets are not supplied with power. ◗ Flashing: status change in progress. ◗ ON: the outlets are supplied with power.Outlets 1 and...
Page 16 - to turn the buzzer OFF.; The equipment is no longer supplied with power.; End of backup time; The low-battery warning threshold can be set by the user, with the; UPS; LED; Threshold for the low-battery warning; The AC-power source is outside tolerances, LED; The equipment connected to the UPS is supplied by the battery.; Transfer to battery power; Operation on battery power (following an AC input power failure)
Page 16 - 3400753300/AE 22 17 17 The UPS goes to sleep mode at the end of the battery backup time, until complete shutdown, due to tripping of thebattery-protection function against deep discharge. Return of AC input power:IMPORTANT: If, in spite of the return of AC input power, the UPS does not res...
Page 17 - Function
3400753300/AE - Page 17 "ON / OFF conditions" tab Options Once a day Once a month No test From 0% to 100% of the remaining battery backup time Disabled Default setting Every weeks 20% remaining battery backup time Enabled Personalization function Automatic "Battery test" intervals ...
Page 19 - Installation and test of the remote power off function; on the back of the
3400753300/AE - Page 19 38 37 12 1. Check that the UPS is shut off and disconnected from the AC power source.2. Remove the RPO connector 12 by undoing the screws 37 . 3. Connect an insulated dry contact (NC, 60 V DC, 30 V AC max., 20 mA max., cable size 0.75 mm) to the two terminals of the RPO conne...
Page 22 - - Remove the left part of the front panel.; Removal of; Use tools with insulated handles.; Replacement of the battery modules
C D P U L S A R 100% 80% 50% 20% test % 1 2 % BYPASS E X B A www.m geups.c om P U L S A R 100% 80% 50% 20% test % 1 2 % BYPA SS E X Page 22 - 3400753300/AE C - Remove the left part of the front panel. D - Disconnect the connector. A - Unclip the small plate with the MGE UPS SYSTEMS, Inc. Logo on the...
Page 23 - Reinstallation of the battery module; - Remove the screws securing the
3400753300/AE - Page 23 G - Remove the two battery modules and proceed with replacement. Reinstallation of the battery module s To reinstall the battery modules perform this procedure in reverse order e.g., “G”, “F”, “E”. ◗ To maintain an identical level of performance and safety, use battery module...
Page 24 - MGE Customer Care Center; contact our Technical Support Group at
Page 24 - 3400753300/AE This product has been designed to respect the environment: It does not contain CFC's or HCFC's. UPS recycling at the end of service life: MGE UPS SYSTEMS, Inc. undertakes to recycle, by certified companies and in compliance with all applicable regulations,all UPS products rec...
Page 25 - Technical characteristics; Pulsar EXB
Output power rating AC-input ◗ Voltage ◗ Frequency ◗ Power factor Output specification ◗ Voltage ◗ Frequency ◗ Harmonic distortion ◗ Overload capability Battery (sealed lead-acid, maintenance free) Environmental and safety ◗ Noise level ◗ Operating temperature ◗ Relative humidity ◗ Safety ◗ EMC ◗ Ag...
Page 27 - Connection
3400753300/AE - Page 27 O ON LINE mode ..................................................................9Overload ................................................................9-18-20 P Personalization ..............................................................17 Battery .........................
Page 28 - MGE; M G E
For service call:1 800 523-0142 Internet: www.mgeups.com T H E U N I N T E R R U P T I B L E P O W E R P R O V I D E R 3400753300-AE 1660 Scenic AvenueCosta Mesa, CA 92626, USAMain Number: 714 557-1636 MGE UPS SYSTEMS, INC. U P S S Y S T E M S M G E