Metra TE-2PSK - User Manual
Metra TE-2PSK Camera – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Figure A; TECHNICAL TIP
- Page 3 – INSTALLATION; Finding a reverse signal; Figure C; Select this symbol on the meter
- Page 4 – Mounting of Sensors
- Page 5 – Running the wiring; Figure B
- Page 6 – CALIBRATION; Calibration
- Page 7 – WIRING DIAGRAM AND SPECS
- Page 8 – ©COPYRIGHT 2021 METRA ELECTRONICS CORPORATION; iBEAM Vehicle Safety Sytems; SAFETY; Contact our Tech Support line at:
©COPYRIGHT 2021 METRA ELECTRONICS CORPORATION
iBEAM Vehicle Safety Sytems
®
REV. 04/18/2022 INSTTE-2PSK
Attention!
When testing the aftermarket
equipment, ensure that all factory equip-
ment is connected before cycling the key to
ignition.
TE-2PSK
INSTALLATION INSTRUCTIONS
#IBEAM
SAFETY
Technical Tip............................................................2
Installation ......................................................... 3-5
Calibration ..............................................................6
Wiring digrams and specs ................................ 4-5
TABLE OF CONTENTS
TOOLS REQUIRED
• Wire stripper
• Tape
• Digital Multi-meter
• Cutter
• Alcohol wipes/cleaning pads
Universal
2 Sensor No Drill
Parking Sensor Kit
Visit
for more detailed informatuon about the product and up-to-date vehicle specific
applications.
Product Features
• 2 sensor parking solution
• No need to drill into the bumper
• Audible 3-zone alerts
• No additional control box needed
• Use for plastic bumpers only
• Easy to install
Part Components
A) 2 Sensors B) Wiring harness C) Accessories
A
B
C
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
386-257-1187 | iBEAMUSA.com 2 InstallationNOTE: This installation may require the removing of the bumper to get the proper sensor alignment. 1. Before removing of the bumper (if it is needed) iBEAM suggests measuring the placement of the sensors on the outside of the bumper with the provided ruler a...
REV. 04/18/2022 INSTTE-2PSK 3 INSTALLATION Finding a reverse signal 1. Remove the tail light from the vehicle to allow access to the light bulbs wiring. (If help is needed, review the vehicles owners manual section on replacing the tail light bulbs.) (Figure A) 2. Find the wiring that connects to th...
386-257-1187 | iBEAMUSA.com 4 Figure A GROUND 10-20 in 10-20 in 15-24 in 15-24 in 1 2 2 Mounting of Sensors (Figure A) NOTE: This installation may require the removing of the bumper to get the proper sensor alignment. 1. Using the painters tape on the outside of the bumper as a guide, re-measure the...
