Metra JP-JLKT - User Manual
Metra JP-JLKT Camera – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – CAMERA REMOVAL
- Page 4 – Use the 3 bolts to help push the
- Page 5 – ASSEMBLY; Place the camera between the
- Page 6 – Run the wire through the boot into the vehicle.; Figure A; WIRING
- Page 7 – SPECIFICATIONS
- Page 8 – ©COPYRIGHT 2020 METRA ELECTRONICS CORPORATION; Metra Electronics Corp.; INSTALLATION INSTRUCTIONS; Contact our Tech Support line at:
©COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
Metraonline.com
Metra Electronics Corp.
®
REV. 10/20/2020 INSTJP-JLKT
Attention!
When testing the aftermarket
equipment, ensure that all factory equip-
ment is connected before cycling the key to
ignition.
JP-JLKT
INSTALLATION INSTRUCTIONS
Camera Removal ................................................ 2-4
Assembly ................................................................ 5
Wiring .....................................................................6
Specifications ......................................................... 7
TABLE OF CONTENTS
TOOLS REQUIRED
• 3/16 Allen bit
• Phillips bit
• Reciprecating saw or other cutting device
Jeep
Wrangler JL 2018-UP*
Replacement Camera Kit
*Visit
Metraonline.com
for more detailed informatuon about the product and up-to-date vehicle specific
applications.
Part Components
A) Camera B) Housing Front/back C) Harness and Hardware
A
B
C
Product Features
• Designed to replace the LVDS camera on Jeep Wranglers
• Direct OE replacement
• ABS housing
• Resolution: 500 TV lines
• Viewing Angle: 160 degrees
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
386-257-1187 | Metraonline.com 2 1. Remove the interior panel. It is held on with panel clips. (Figure A) 2. Disconnect the two connectors shown. (FIg-ure B) Pop out the grommet behind these two connectors and run the harness outside. This will allow easier access when removing the spare tire mount ...
386-257-1187 | Metraonline.com 4 Figure A Figure B Figure A CAMERA REMOVAL (CONT.) 1. Use the 3 bolts to help push the camera mount out of the back of the spare tire mount. Push the bolts down. Some force may be needed. 2. Remove the three T-8H torx screws to remove the camera from the mount. (Figur...
REV. 10/20/2020 INSTJP-JLKT 5 Figure A Figure B ASSEMBLY 1. Place the camera between the front and rear housings like shown in Figure A. Make sure to notice and properly place the camera using the small top ledge as an indicator. 2. Run the assembly through the jeep spare tire housing and secure wit...
