McIntosh C2300 - Manual
McIntosh C2300 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
C2300 Rear Panel Connections
2
A
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549
Part No. 04106100
Connect the C2300
power cord to a live
AC outlet. Refer to in-
formation on the back
panel of your C2300 to
determine the correct
voltage for your unit
MAIN POWER
CONTROL Out-
put sends a turn-on
signal to a McIntosh
Component when the
C2300 is turned on
DATA PORTS send
signals to McIntosh
Source Components
to allow control with
the C2300 Remote
Control
SRVR, CDR, CD, D/A, DVD and
TUNER INPUTS accept high
level program source signals
GND terminals
accept a ground
wire from a
turntable
SRVR OUT sends
signals to the input of
a recording device
Main Fuse holder,
refer to information on
the back panel of your
C2300 to determine
the correct fuse size
and rating
PHONO MM accepts
signals from a Mov-
ing Magnet Phono
Cartridge
CDR, CD, D/A and DVD IN-
PUTS (Balanced) accept high
level program source signals
EXT SENSOR con-
nector permits the
connection of a Mc-
Intosh IR Sensor for
remote operation
MAIN OUTPUTS
(Balanced) send
signals to a Power
Amplifier
MAIN OUTPUTS
send signals to a
Power Amplifier
POWER CONTROL ACC sends Turn-On signals
to McIntosh Source Components when the C2300
is On.
OUTPUT 2 and OUTPUT 1 send Turn-On signals
to McIntosh Power Amplifier(s) when activated.
POWER CONTROLS ACC, OUTPUT 2 and
OUTPUT 1 may be re-assigned as TRIGGERS
A - C to send Turn-On signals when a desired
Input Source is selected
OUTPUTS 1 and 2 (Balanced) send
signals to Power Amplifiers and
are switched On/Off with the Front
Panel Output 1 and 2 Push-Buttons
or Remote Control Push-Buttons
PASSTHRU Power
Control Input receives
a turn-on signal from
a McIntosh Home
Theater Controller
PHONO MC accepts
the low level signals
from a Moving Coil
Phono Cartridge
OUTPUTS 1 and 2 send signals to
Power Amplifiers and are switched
On/Off with the Front Panel Output
1 and 2 Push-Buttons or Remote
Control Push-Buttons
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
