McCulloch 250CXL - Manual - manualsarea.com

Page 2 - IDENTIFICATION OF SYMBOLS

2 IDENTIFICATION (WHAT IS WHAT?) Primer Bulb Assist Handle Throttle Trigger Start Lever Spark Plug Shield Trimmer Head Shaft Muffler ON/STOP Switch Coupler Starter handle Throttle lock-- out Wrench Manual IDENTIFICATION OF SYMBOLS A. WARNING! This trimmer can be dangerous! Careless or improper use c...

Page 3 - SAFETY RULES; OPERATOR SAFETY

3 SAFETY RULES WARNING: When using gardening appliances, basic safety precautions should al- ways be followed to reduce the risk of fire and serious injury. Read and follow all instructions. This power unit can be dangerous! Operator is responsible for following instructions and warn- ings on unit a...

Page 4 - ADDITIONAL SAFETY RULES; FOR OPTIONAL ATTACHMENTS

4 S Use only 2 mm diameter McCulloch brand line. Never use wire, rope, string, etc. S Install required shield properly before using the unit. Use only specified trimmer head; make sure it is properly installed and se- curely fastened. S Make sure unit is assembled correctly as shown in this manual. ...

Page 6 - HEDGE TRIMMER SAFETY; HANDS AWAY FROM BLADE; POLE PRUNER SAFETY

6 WARNING: Inspect the area to be cultivated before starting the unit. Remove all debris and hard and sharp objects such as rocks, vines, branches, rope, string, etc. S Avoid heavy contact with solid objects that might stop the tines. If heavy contact oc- curs, stop the engine and inspect the unit f...

Page 7 - SNOW THROWER SAFETY; ASSEMBLY; INSTALLING TRIMMER ATTACHMENT

7 S Always stop the unit when work is delayed or when walking from one cutting location to another. S If you strike or become entangled with a for- eign object, stop the engine immediately and check for damage. Have any damage repaired by an authorized service dealer before attempting further operat...

Page 8 - OPERATION

8 6. Before using the unit, tighten the knob se- curely by turning clockwise. Coupler Primary Hole Upper Shaft Locking/ Release Button Attachment Guide Recess WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. ...

Page 11 - MAINTENANCE

11 Tip of the Line Does The Cutting Right Wrong Line Crowded Into Work Area S The line will easily remove grass and weeds from around walls, fences, trees and flower beds, but it also can cut the tender bark of trees or shrubs and scar fences. S For trimming or scalping, use less than full throttle ...

Page 12 - REPLACE SPARK PLUG; SERVICE AND ADJUSTMENTS; REPLACING THE LINE

12 Button Air Filter Cover Air Filter REPLACE SPARK PLUG Replace the spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at 0,6 mm. Ignition timing is fixed and nonadjustable. 1. Twist, then pull off spark plug boot. 2. Remove spark plug from cylinder and dis-...

Page 13 - Idle Speed Adjustment; STORAGE; SEASONAL STORAGE

13 Make adjustments with the unit supported so the cutting attachment is off the ground and will not make contact with any object. Hold the unit by hand while running and making ad- justments. Keep all parts of your body away from the cutting attachment and muffler. Idle Speed Adjustment Allow engin...

Page 15 - DECLARATION OF CONFORMITY

15 DECLARATION OF CONFORMITY EC Declaration of Conformity (Only applies to Europe) We, Husqvarna AB , SE-561 82 Huskvarna, Sweden, tel: +46--36--146500, as authorised representative in the Community, declare that the grass trimmer model McCulloch 250CXL with serial numbers dating from 2009 and onwar...

Page 16 - TECHNICAL DATA SHEET

16 TECHNICAL DATA SHEET M ODEL: 250CXL ENGINE Cylinder displacement, cm 3 25 At maximum engine power, rpm 8000 Maximum rotational frequency of the spindle, rpm 10000 Engine speed at recommended maximum spindle rotational frequency, rpm 7400 Recommended speed idling, rpm 3000 Maximum engine power, me...

McCulloch 250CXL - Manual

Table of Contents:

Summary

Other McCulloch Models