Lux WTR064 - Manual
Lux WTR064 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Before you begin, make sure that the time on the LUXPRO
®
thermostat is set.
If not, set the time before starting the installation.
INSTALLATION INSTRUCTIONS
1. Install the included 2 AA batteries by removing the 4 screws located at the back of the
transmitter. The LED on the transmitter will flash every 6 seconds.
Do not close the
battery compartment yet.
2. Remove the top cover of the thermostat and plug the receiver into the white connector
located to the bottom left under the touch screen. (
A
)
3. Place the antenna wire into the 4th vent as shown (
B
).
Clip the receiver into the 1st vent (
C
).
4. Press the “RESET” button (
D
) on the receiver module for 10 seconds to activate the
transmitter and receiver. The outdoor temperature will appear on your thermostat within
5 minutes. Make sure that the dot to the left of the outdoor temperature (
E
) flashes
approximately every 15 seconds. If after 5 minutes the outdoor temperature is not
displayed on the thermostat or if the dot to the left of the outdoor temperature (
E
) is not
flashing, unplug the receiver module from the thermostat, remove batteries from the
transmitter and start the installation procedure again.
5. Close the battery compartment and position the transmitter in a permanent location that
is sheltered from the elements. After placing the transmitter in a permanent location,
ensure that the dot to the left of the temperature (
E
) flashes approximately every 15
seconds. If the dot to the left of the temperature (
E
) is not flashing, change the
transmitter location.
6. Use the chart below as a reference for the recommended humidity settings.
WARNING:
Adjusting the humidity control higher than the recommended setting may cause
condensation, resulting in possible damage to the home.
Part No. WTR064
Accurately Displays
Current Outdoor Temperature and
Enables Dual Fuel* and
Automatic Humidity* Capability
on the LUXPRO
®
Thermostat
* SELECTED MODELS ONLY
52079
B
C
D
E
A
© 2009 LUX PRODUCTS CORPORATION. ALL RIGHTS RESERVED
H U M I D I T Y S E T T I N G R E C O M M E N D AT I O N S
At Outside Temperatures Of:
-20°F (-29°C)
-10°F (-23°C)
0°F (-17°C)
+10°F (-12°C)
+20°F (-6°C)
Over +32°F (0°C)
Humidity Setting:
15 %
20 %
25 %
30 %
35 %
40 %
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
