Page 2 - so they can be easily identified at recycling or waste recovery
DO NOT DISCARD THE BLANK DESIGNATION CARD The voice terminal is shipped with a blank button designation card in place under the transparent cover. Do not discard this button designation card. Instead, place the preprinted designation card over the blank button designation card which comes with the v...
Page 3 - Use; Read and understand all instructions.
IMPORTANT USER SAFETY INSTRUCTIONS The most careful attention has been devoted to quality standards in the manufacture of your new voice terminal. Safety is a major factor in the design of every set. But, safety is YOUR responsibility too. Please read carefully the helpful tips listed below and on t...
Page 4 - Service; SAVE THESE INSTRUCTIONS
• Never push objects of any kind into the equipment through housing slots since they may touch hazardous voltage points or short out parts that could result in a risk of electric shock. Never spill liquid of any kind on the telephone. If liquid is spilled, however, refer servicing to proper service ...
Page 6 - ADDITIONAL INSTALLATION WARNING; Figure 1; in
ADDITIONAL INSTALLATION WARNING FAILURE TO FOLLOW THESE INSTRUCTIONS CAN CAUSE DAMAGE TO THE TERMINAL OR CAUSE THE ASSOCIATED PBX CIRCUIT PACK TO REMOVE POWER TO THE TERMINAL. IN EITHER CASE THE TERMINAL WILL NOT FUNCTION CORRECTLY. The design of this product allows it to operate on either 2-wire or...
Page 7 - INSTALLING YOUR VOICE TERMINAL; PassageWay and Analog Adjunct Status Indications; LABELING THE DESIGNATION CARD; Selecting Whether the I-1 Channel or the I-2 Channel; OTHER 8400-SERIES VOICE TERMINALS
INSTALLING YOUR VOICE TERMINAL . . . . . . . . . . . . . . . . . . . . . . . . . 1 Distance Limitations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Auxiliary Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 8 - Administration, and Programming the Options; Distance Limitations; In; Auxiliary Power; (These sets require auxiliary
1 INSTALLING YOUR VOICE TERMINAL IMPORTANT: For a fuller description of installing the 8400-Series voice terminals and procedures on administering these sets and programming such options as enabling/disabling the speakerphone or one-way speaker, enabling/disabling the Mute function, selecting ringin...
Page 9 - During the desktop installation procedure, refer to
2 • 1145B1 Bulk Power Supply (PEC: 2404-010)Battery for the 1145B1 (2 amp battery = PEC: 24700; or 5 amp battery = PEC: 24701) • KS-22911 L2 (replaced by the MSP-1 Power Supply and 1151A1/A2 Power Supplies) — This power supply cannot be used with the 8411. NOTES: The MSP-1, the 1151A1 and A2, and th...
Page 12 - Analog Adjunct jack
5 FIGURE 2: Line, Adjunct, and Handset Cord Routing for Desktop Installation on the 8411 Voice Terminal FIGURE 3: Connecting a PC for Use with PassageWay and Connecting an Analog Adjunct (These Jacks Are on the Rear of the 8411) Analog Adjunct jack RS-232-D jack
Page 13 - Test
6 FIGURE 4: Line, Adjunct, Handset, and Expansion Module Cord Routing on the 8434DX Voice Terminal 7. Turn the voice terminal right side up, with the front facing you. 8. Snap the free end of the handset cord into the handset and place the handset in the cradle. 9. Snap the free end of the line cord...
Page 14 - Adjusting the 8405 and 8410 Voice Terminal Desktop Stand; to provide a better viewing angle of the terminal display.
7 on, the voice terminal may not have power. In this case, check the connections and then verify that the particular voice terminal is administered on the DEFINITY switch.) Adjusting the 8405 and 8410 Voice Terminal Desktop Stand To provide better display visibility on the 8405D, 8405D Plus, and 841...
Page 16 - Wall Installation; The 8411 and the 8434DX voice terminals CANNOT be wall-mounted.; Reversing the Handset Hook; retainer
9 Wall Installation NOTE: The 8403, 8405, and 8410 voice terminals can be wall-mounted. The 8411 and the 8434DX voice terminals CANNOT be wall-mounted. For wall-mounting, you need a 1-foot D8W line cord (not supplied with the voice terminal; Comcode: 103786760). To wall-mount the 8403, 8405, and 841...
Page 18 - Placing the Voice Terminal onto the Wall Jack Mounting Studs; The handset hook you repositioned will hold the handset in place.; Wall jack
11 FIGURE 8: Placing the Voice Terminal onto the Wall Jack Mounting Studs 11. Snap the free end of the handset cord into the handset and place the handset in the cradle. NOTE: The handset hook you repositioned will hold the handset in place. 12. Lift the handset and listen for dial tone. If there is...
Page 19 - Attaching Adjunct Equipment; User’s Guide
12 Attaching Adjunct Equipment If you are installing a speakerphone (Lucent Technologies models S101A, S201A, or QUORUM ® CS201A), a headset adapter (Lucent Technologies model 500A1), or other adjunct that may be offered, follow these steps to connect the adjunct equipment to your voice terminal. Th...
Page 20 - Ex Mod
13 FIGURE 9: Connections for the 8434DX and All Telephones with Adjuncts Using an Individual Power Supply 84xx Terminal D8AC Linecord D8W MSP-1 or the 1151A1/A2power supplies Walljack = Jack = Cord connections Line Other Phone ADJ Line Adjunct Ex Mod 8434DX D6AP Module Expansion 84xx D8AC D6AP ADJ L...
Page 21 - Important Notes for the 8411; must; To connect your 8411 to the PassageWay PC; Make sure that the PC is turned off.; To connect an Analog Adjunct to the 8411
14 USING THE RS-232-D JACK AND ANALOG ADJUNCT JACK ON THE 8411 See Figure 3 in the front of this manual for a drawing of the rear of the 8411 voice terminal. You can use the RS-232-D jack for connecting the 8411 to a PC for use with PassageWay Solution software. The Analog Adjunct jack can be used f...
Page 22 - PassageWay and Analog Adjunct Status Indications on the 8411; Shift
15 WARNING: Do NOT connect the Analog Adjunct to the wall jack. It will cause equipment damage. NOTE: When an 8411 voice terminal is administered at a DEFINITY G3V4, Issue 3, switch, the voice terminal must be administered to use the appropriate analog telephone line. For more information on adminis...
Page 23 - analog; Flash
16 PassageWay Status Indications On 8411 voice terminals, the GREEN and RED lights next to Button #9 provide the following status indications for the PassageWay connection: Analog Adjunct Status Indications On 8411 voice terminals, the GREEN and RED lights next to Button #10 provide the following st...
Page 24 - Do not discard the blank button designation card.; For the 8403 Voice Terminal; Feature
17 LABELING THE DESIGNATION CARD The designation card is a removable card placed behind a transparent protective cover on which the user can type or print call appearance or feature assignments. In most cases, the voice terminal’s designation card is filled out before the user begins to use the set....
Page 25 - To label the designation card; 400-Series Voice Terminals Instructions for Installation,; Note on 8411 Administration:
18 For the 8434DX Voice Terminal There are two Call Appearance/Feature Button Designation Cards for the 8434DX voice terminal: • The smaller card contains two columns with five buttons in each column: the first column is labeled a through e ; the second column is labeled f through j . • The larger c...
Page 26 - PassageWay; field on the first administration screen.
19 • If a PC used for the PassageWay Solution software is connected to the 8411, type a “y” in the PassageWay field on the first administration screen. • If an analog adjunct is connected to the 8411, type “analog” in the Data Option: field on the first administration screen. • On the last administr...
Page 30 - Lucent Technologies BCS Publications Center
23 Write: Lucent Technologies BCS Publications Center P.O. Box 4100 Crawfordsville, IN 47933 Call: 1 800 457-1235 Outside US: 1 317 361-5353 When ordering any of these documents, be sure to specify the title and the “555” ordering number. — 8400-Series Voice Terminals Instructions for Installation, ...
Page 31 - Copyright
24 — DEFINITY Communications System Generic 2 and System 85 8411 Voice Terminal Quick Reference Guide , 555-104-770 — DEFINITY Communications System Generic 1 and Generic 3 and System 75 8434DX Voice Terminal User’s Guide , 555-230-856 — DEFINITY Communications System Generic1 and Generic 3 and Syst...
