LevelOne FSW-0507TX - Manual

Page 5 - ABOUT THIS GUIDE; LED I; CONNECTING THE SWITCH; PC

i T A B L E O F C O N T E N T S ABOUT THIS GUIDE ................................................. 1 P URPOSE ........................................................................................1 T ERMS /U SAGE ............................................................................1 O VERVI...

Page 6 - TECHNICAL SPECIFICATIONS

ii S WITCH TO SWITCH ( OTHER DEVICES ) ...........................10 P ORT S PEED & D UPLEX M ODE.........................................11 TECHNICAL SPECIFICATIONS ............... 13

Page 7 - Purpose; Switch; Overview of this User’s Guide

1 A B O U T T H I S G U I D E Congratulations on your purchase of the LeveOne 5/8 Port 10/100Mbps PalmCon Switch. This device integrates 100Mbps Fast Ethernet and 10Mbps Ethernet network capabilities in a highly flexible desktop package. Purpose This manual discusses how to install your LevelOne 5/8...

Page 9 - N T R O D U C T I O N; Features

7 I N T R O D U C T I O N This chapter describes the features of the Switch and some background information about Ethernet/Fast Features The Switch was designed for easy ins tallation and high performance in an environment where traffic on the network and the number of user increase continuously. Th...

Page 11 - Unpacking; Setup

9 U N P A C K I N G A N D S E T U P This chapter provides unpacking and setup information for the Switches. Unpacking Open the shipping cartons of the Switch and carefully unpacks its contents. The carton should contain the following items: One LevelOne 5/8 Port 10/100Mbps PalmCon Switch One externa...

Page 15 - Front Panel; Rear Panel

13 I D E N T I F Y I N G E X T E R N A L C O M P O N E N T S This section identifies all the major external components of the hub. Both the front and rear panels are shown, followed by a description of each panel feature. The indicator panel is described in detail in the next chapter. Front Panel Th...

Page 16 - LED Indicators

14 FSW-0507TX 7.5VDC/1A 1 2 3 4 5 6 7 8 FSW-0807TX DC Power Jack: Power is supplied through an external AC power adapter. Check the technical specification section for informatio n about the AC power input voltage. Since the switch does not include a power switch, plugging its power adapter into a p...

Page 19 - PC to Switch

9 C O N N E C T I N G T H E S W I T C H This chapter describes how to connect the Switch to your Fast Ethernet network. In each of the following figures, the LevelOne 5/8 Port 10/100Mbps PalmCon Switch is shown. PC to Switch A PC can be connected to the Switch via a two -pair Category 3, 4, 5 UTP/ST...

Page 20 - Hub to Switch

10 Hub to Switch A hub (10 or 100BASE-TX) can be connected to the Switch via a two -pair Category 3, 4, 5 UTP/STP cable. The connection is accomplished from the hub to any of the Switch RJ-45 ports. A. 10BASE-T Hub For a 10BASE-T hub, the Switch LED indicators should light up as the following: “Full...

Page 21 - Port Speed & Duplex Mode; duplex

11 Port Speed & Duplex Mode After plugging the selected cable to a specific port, the system uses auto -negotiation to determine the transmission mode for any new twisted-pair connection: If the attached device does not support auto -negotiation or has auto- negotiation disabled , an auto-sensin...

Page 23 - General

13 T E C H N I C A L S P E C I F I C A T I O N S General Standards IEEE 802.3 10BASE -T Ethernet IEEE 802.3u 100BASE -TX Fast Ethernet ANSI/IEEE 802.3 NWay Auto-negotiation IEEE 802.3x Full duplex Flow Control P r o t o c o l CSMA/CD Data Transfer Rate Ethernet: 10Mbps (half duplex) , 20Mbps (full-d...

LevelOne FSW-0507TX - Manual

Table of Contents:

Summary

Other LevelOne Models