Lennox RDI-42-H - Manual
Lennox RDI-42-H – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; Optional Equipment Considerations . page 14
- Page 3 – Figure 1; TYPICAL INSTALLATION; PRECAUTIONS; Circulating Model Shown; CHIMNEY SYSTEM
- Page 5 – Note: The “Z” type safety strip is not supplied.; CLEARANCES; Install optional outside combustion air kit.; Study the three dimensional illustration (; PRE-INSTALLATION NOTES; Figure 7
- Page 6 – FIREPLACE SPECIFICATIONS; Consult all local codes.
- Page 7 – FRAMING SPECIFICATIONS
- Page 8 – INSTALLING THE CHIMNEY SYSTEM; refer to; Figures 15 and 16 and charts Fram-
- Page 9 – OFFSET THROUGH FLOOR; when passing through the floor or ceiling; Figures 22 and 23. Support the; For Canada Only; installation is required only for use in Canada.
- Page 11 – TEN FOOT RULE SUMMARY; The effective heights of the components are:; The Fireplace; SPECIAL OFFSET INSTRUCTIONS; offset and return elbows. Use two elbows -; MULTIPLE TERMINATIONS
- Page 12 – FTF8 VERTICAL ELEVATION CHART; cannot; Figure 39 ). Be sure to drill only through the; Maximum offset of chimney system is 30; OFFSET CALCULATIONS; stabilizers as shown in
- Page 13 – OFFSET ELEVATION CHART
- Page 14 – FIGURES
- Page 15 – Combustion
- Page 16 – Figure 45 shows typical; Glass Doors
- Page 17 – Table 1; Methods of Determini
- Page 18 – FINISH TO YOUR TASTE; brick; x T; mortar; marble; x T; mortar; x T
- Page 19 – INSTALLATION COMPONENTS; Shipping Weight
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
1
42" Wood Burning Fireplaces
P/N 850,047M REV. B 12/2008
RDI-42
HCI-42
RDI-42-H
HCI-42-H
MODELS
OMNI Report No. 116-F-52-2
This installation manual will enable you to obtain a safe, efficient and
dependable installation of your fireplace system. Please read and under-
stand these instructions before beginning your installation.
Do not alter or modify the fireplace or its components under any
circumstances. Any modification or alteration of the fireplace system,
including but not limited to the fireplace, chimney components and
accessories, may void the warranty, listings and approvals of this system
and could result in an unsafe and potentially dangerous installation.
IMPORTANT! TO ASSURE PROPER ALIGNMENT OF GLASS DOORS:
INSTALL THIS FIREPLACE IN A SQUARE AND PLUMB CONDITION,
USING SHIMS AS NECESSARY AT SIDES AND/OR BOTTOM.
INSTALLATION
INSTRUCTIONS
MERIT
®
SERIES
US
Portland
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 2 TABLE OF CONTENTS Safety Rules .................................... page 2 Tools and Building Supplies ............ page 2 Precautions ..................................... page 3 Introduction ..................................... page 3 Clearances/...
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 3 Figure 1 TYPICAL INSTALLATION *Construction Materials: • framing materials • paneling • particle board • flooring • dry wall • etc. • plywood PRECAUTIONS Note: These fireplace systems are not difficultto install. However, in the interest of safety, ...
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 5 Note: Install the hearth extension only as illus-trated. The safety strips should extend from front ofthe fireplace at least 1-1/2" and should extend tobe at least flush with the sides. In the event awooden support is used to elevate the firepla...
