Lathem ATDDC4 - Manual
Lathem ATDDC4 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Disclaimer; ATX
- Page 3 – One Year Limited Warranty; Introduction; When the ATDDC4 series Wall Clock is connected to 120vAC (24vAC; Front Panel
- Page 4 – Page 2; Clock Installation; 2 Hour Format; Specifications
- Page 5 – Note: the inside of the lens has a paper; Page 3; Mounting the Enclosure
- Page 6 – Page 4; Mounting to a Wall; Note: If mounting near a ceiling, make sure the holes; Mounting to a Single Gang Box; Note: If mounting near a ceiling, make sure the holes are at least 2-; Page 9; Double Mount - Ceiling; Note: If the ATDDC4 clocks will be mounted too near a wall on one
- Page 7 – Page 8; Page 5; six; Conduit access is not available from the bottom.; allowing sufficient length to attach the wires; including the ground; Power Cord Installation
- Page 8 – Page 6; Attaching Conduit; top; Making the Connection; Page 7; Double Mount – Wall
Wireless Digital Wall Clock
Model ATDDC4
Installation & User’s Guide
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS PURSUANT SUBPART J OF PART-15 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, includi...
ATDDC4 Series Installation & User’s Guide Page 12 One Year Limited Warranty Lathem warrants the hardware products described in this guide against defects in material and workmanship for a period of one year from date of original purchase from Lathem or from an authorized Lathem reseller. The con...
ATDDC4 Series Installation & User’s Guide Page 2 Clock Installation Tools required for mounting the clock: • Drill with a 5/16" bit • Hammer • Phillips head screwdriver • Wall anchors • Pencil Separate the electronics from the enclosure and to set the Time Display Format (12hr / 24hr). To do...
