Page 3 - CONTENTS; - READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING -
- READ AND SAVE THESE INSTRUCTIONS - CONTENTS IMPORTANT SAFETY INSTRUCTIONS.........................ERROR! BOOKMARK NOT DEFINED. COMPONENTS OF PACKAGE ................................................................................................. 3 INSTALLATION .......................................
Page 4 - other hidden utilities.
1 IMPORTANT SAFETY INSTRUCTIONS - PLEASE READ THIS SECTION CAREFULLY BEFORE INSTALLATION - WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL INJURY, OBSERVE THE FOLLOWING: 1) Installation and electrical wiring must be done by qualified professionals and in accordance with all applicabl...
Page 5 - CAUTION
2 What to Do In The Event Of a Range Top Grease Fire • SMOTHER FLAMES with a close fitting lid, cookie sheet, or metal tray, and then turn off the burner. KEEP FLAMMABLE OR COMBUSTIBLE MATERIAL AWAY FROM FLAMES. If the flames do not go out immediately, EVACUATE THE AREA AND CALL THE FIRE DEPARTMENT ...
Page 6 - COMPONENTS OF PACKAGE; (Must keep all material for returns or refunds); R ANG E HO O D BO X; S t a in le ss S t e e l S p a ce r; D UCT CO V E R K IT (S o l d S e pa r a te l y )
3 COMPONENTS OF PACKAGE (Must keep all material for returns or refunds) O P T I O NA L R E CI RC U LA T I NG K I T A LS O A V A I LA B LE . F O R M O RE I NF O RM A T I O N, P LE A S E V I S I T O UR W E B S I T E W W W . KO BE R AN G E HO O DS . CO M O R CO NT A CT K O B E RA NG E HO O DS A T ( 62 ...
Page 7 - INSTALLATION; PLEASE READ ENTIRE INSTRUCTION BEFORE PROCEEDING; C = Preferred Height of Counter Top to Hood
4 INSTALLATION PLEASE READ ENTIRE INSTRUCTION BEFORE PROCEEDING Calculation before Installation To calculate installation, please refer to Table 1. (All calculation in inches.) - FOR UNDER THE CABINET - TABLE 1 A = Height of Floor to Ceiling B = Height of Floor to Counter Top (Standard: 36”) C = Pre...
Page 8 - SAFETY WARNING; Installation Table of Contents
5 SAFETY WARNING HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES IF IT IS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING OR SERVICING. NOTE: BE CAREFUL WHEN USING ELECTRICAL SCREWDRIVER, DAMAGE TO THE HOOD MAY OCCUR. Installation Table of Contents UNDER THE CABINET INSTALLATION...
Page 9 - Figure 3
6 UNDER THE CABINET INSTALLATION Preparation Before Installation NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING. • Decide the location of the venting pipe from the hood to the outside. Refer to Figure 1. • A st ra ig ht, sho rt ve nt run will a llo w the hood to pe...
Page 10 - S A F E T Y W A R N I N G; AND; Final Assembly; Slide forward into recess at front of hood.
7 Ductwork Installation 7. Use 8” aluminum or steel pipe (follow building codes in your area) to connect the ducting transition on the hood to the ductwork above. Use duct tape to seal and secure joints as shown in Figure 5. Wiring to Power Supply S A F E T Y W A R N I N G TO PREVENT THE RISK OF ELE...
Page 11 - Turn power ON in control panel. Check all lights and
8 15. Install heating lamps (not provided), 120 Volts 175 Watts max. each. 16. Turn power ON in control panel. Check all lights and fan operation. 17. Make sure to leave this manual for the homeowner Figure 8
Page 12 - CAUTION: If moving the cooking range is; Figure 10
9 STAND ALONE INSTALLATION ***F ollow these installations only if installing with an optional duct cover: Preparation Before Installation NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING. • Decide the location of the venting pipe from the hood to the outside. Refer t...
Page 13 - W i ri ng t o Po we r S up p l y; . Co n ne ct th e e le ct rica l wire s.
10 2. Align hood-mounting bracket to the two screws on the wall and hook hood into place. Tighten screws to secure hood to the wall. 3. For safety purpose, extra knockout holes on the back of the hood are provided for a more secure installation. Knock out as many holes as needed and secure with scre...
Page 15 - OPERATING INSTRUCTIONS
12 OPERATING INSTRUCTIONS This KOBE hood is equipped with touch-sensor screen and features 3 minute delay shutoff, powerful centrifugal squirrel cage with baffle filters, bright 12-volt 20-watt halogen lights and heating lamp capability (heating lamps not included). The touch-sensor screen has Heat ...
Page 17 - MAINTENANCE
14 MAINTENANCE SAFETY WARNING NEVER PUT YOUR HAND INTO AREA HOUSING THE FAN WHILE THE FAN IS OPERATING. For optimal operation, clean range hood and all baffle/spacer/filter/oil tunnel/oil container regularly. To Clean Hood Surface CAUTION: NEVER USE ABRASIVE CLEANERS, PADS, OR CLOTHS. *** Regular ca...
Page 18 - HALOGEN LIGHT UNIT MAY BE HOT! WAIT UNTIL UNIT IS COOL.; to remove cover
15 To Replace Light Bulb CAUTION: HALOGEN LIGHT UNIT MAY BE HOT! WAIT UNTIL UNIT IS COOL. 1. Make sure all controls are off, and range hood is unplugged. 2. Place a flat-head screwdriver between light cover and housing to remove cover . 3. Gently pull defective bulb straight out and discard. Light b...
Page 19 - SPECIFICATIONS
16 SPECIFICATIONS CH0130SQB / 30” CH0136SQB / 36” CH0142SQB / 42” MODEL / SIZE CH0148SQB / 48” DESIGN 18-Gauge Seamless Commercial Stainless Steel CONSUMPTION / AMPERE 702W / 5.85A – 30”, 36” 722W / 6.02A – 42”, 48” VOLTAGE 120V 60Hz NUMBER OF MOTORS 1 FAN TYPE: CENTRIFUGAL Squirrel Cage EXHAUST Top...
Page 20 - MEASUREMENTS & DIAGRAMS; - F O R U N D E R T H E C A B I N E T -
17 MEASUREMENTS & DIAGRAMS *** Inch measurements converted from millimeter. Inch measurements are estimated. - F O R U N D E R T H E C A B I N E T - MODEL NO: CH0130SQB CH0136SQB CH0142SQB CH0148SQB 30 " / 36" / 4 2" / 4 8" 3 - 1/ 8" ( 79 .5 ) 1 8 " (4 5 7 ) 24" ( 610...
Page 25 - PARTS LIST; Optional Duct Cover
22 PARTS LIST MODEL NO: CH0130SQB CH0136SQB CH0142SQB CH0148SQB BODY COMPONENTS NO. DESCRIPTION MODEL/SIZE PART NO. 1 Hood Casing CH101-1 2 Ducting Transition CH101-2 3 Screws (3/16” x 3/8”) CH101-3 4 Blower Assembly CH101-4 5 Field Wiring Box Cover CH101-5 6 Field Wiring Box CH101-6 7 Heat Lamp Soc...
Page 30 - CIRCUIT DIAGRAM
Page 33 - rendered illegible or removed
30 WARRANTY WARRANTY CERTIFICATE KOBE Range Hoods, Inc. warrants all products manufactured or supplied by it to be free from defects in workmanship and materials. Its obligations pursuant to this warranty are limited to a period of two years from the date of purchase and to the repair or replacement...
Page 34 - SERVICE; For service contact:
31 h) for damage by or resulting from attempted repairs conducted by anyone other than our Authorized Service Agent. 3) The purchaser shall be responsible for any expenses involved in making the range hood readily accessible for servicing and where the range hood is installed outside the main sales ...
Page 35 - PRODUCT REGISTRATION; Register Your Product!; Purchased Date
32 PRODUCT REGISTRATION Register Your Product! Any covered failure occurring within two years of original purchase arising from defective workmanship or material in manufacture will be repaired or at our option the unit will be replaced free of charge by an authorized KOBE Range Hoods Agent or KOBE ...
Page 36 - KOBE Range Hoods
KOBE Range Hoods 10505 Valley Blvd Suite # 302 El Monte, CA 91731 USA http://www.KOBERangeHoods.com This KOBE hood is made for use in the USA and CANADA only. We do not recommend using this hood overseas as the power supply may not be compatible and may violate the electrical code of that country. U...
