Knoll HDMIDA2 - Manual
Knoll HDMIDA2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Specifications:
Models and Dimensions
HDMIDA2 one input two outputs
2.5” w x 3/4” h x 2-3/8” deep (6.3 x 1.9 x 6 cm)
HSMIDA4 one input and four outputs
6.5” w x 1” h x 3-1/4” deep (16.5 x 2.5 x 8.3 cm)
HDMIDA8 one input and eight outputs
12-5/8 w x 1.75” h x 4-1/8” deep (32 x 4.5 x 10.6 cm)
Power:
5 VDC 2000 mA.
Warranty
Knoll Systems warrants its products sold in the USA and Canada by authorized
Knoll dealers to be free of defects in materials and workmanship. This warranty
extends for three full years from the date of purchase by the original consumer.
Any products returned to Knoll Systems and found to be defective by Knoll
Systems within the warranty period will be repaired or replaced at Knoll Systems
option, at no charge. Knoll Systems will not be responsible for the actual cost of
installation or removal of the product, nor for any incidental or consequential
damages. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation may not apply to you. This
warranty gives you specific legal rights. You may have additional legal rights
that vary from state to state.
Knoll Systems www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
15-7163 Vantage Way, Delta Bc V4G 1N1
Tel. (604) 940 1689, fax (855) 734 3363
Made in China Knoll Systems All Rights Reserved
HDMIDA4
FOUR OUTPUT
DISTRIBUTION
AMPLIFIER
Installation Instructions v1.2
Warning
: To be installed and/or used in accordance with
appropriate electrical codes and regulations.
If you are not sure
about any part of these instructions, consult a qualified
electrician.
Introduction:
Thank you for your purchase of a Knoll HDMI
distribution amplifier. This DA will take any HDMI signal and
distribute it to up to 4 outputs. Up to 4 HDMIDA8’s (8 output
distribution amps) can be plugged into one HDMIDA4 giving as
many as 32 outputs. Knoll HDMI distribution amplifiers can be
cascaded twice for up to 512 outputs from 73 HDMIDA8’s.
The maximum wire length for HDMI cables is about 15 meters
or 50 feet. If longer wire runs are needed so the Knoll HDMI
balun solutions to allow wire runs up to 35 meters or 120 feet.
Features:
Newest version is 8 bit 3D capable with wider
bandwidth.
Tabletop box design.
Will safely send 480i/p, 720p and 1080i/p signals.
Easy to use. Installs in seconds and there are no user
adjustments.
Can be cascaded two times to give a maximum of 512
HDMI outputs
Supports all HDCP forms.
Power supply included.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
