Knoll C16 - Manual - manualsarea.com

Page 2 - Important Safety Instructions:; WARNING; cause birth defects or other reproductive harm.

2 Important Safety Instructions: 1) Read these instructions. 2) Keep these instructions. 3) Read all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacturer’s in...

Page 3 - FCC Warning; Reorient or relocate the receiving antenna.; Canada

3 FCC Warning Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, ...

Page 6 - Speaker connections

6 Speaker connections The CI6 has six stereo 50 watts per channel amplified outputs. Channels 5 and 6 also have line level outputs to connect to larger powered amplifiers. To ensure that the high quality signals produced by your amplifier are carried to your speakers without loss of clarity or resol...

Page 9 - Keypad Connection; If you daisy chain one zone and; Each

9 All Channels Vol up (avlu) “All zones volume levels increased” All Channels Vol dn (avld) “All zones volume levels decreased” Channel Vol up (#vlu) “Zone # volume increased” Channel Vol down (#vld) “Zone # volume decreased” Bass adjustment (#b$) “Bass successfully set to $” Treble adjustment (#t$)...

Page 10 - Note: MR164 keypad installer programming, see MR164; Up to fourteen (one for each active source) RCA patch cords

10 We recommend the T568A wiring method, which is shown below. The functions of each wire connection are also shown. future use brown future use white/brown Infrared orange ground white/blue +12 vdc blue future use white/orange SDA green SCL white/green Run CAT5 wire from the keypad location to the ...

Page 11 - The procedure to connect the two controller amplifiers is:; Page Inputs; Programming; Source input labels; Room or zone keypad identification; . Now that the system has been installed and powered; M U TE; VOL; IN PU T; ALL; L in e 2; LCD displ ay

11 The procedure to connect the two controller amplifiers is: 1. Connect the “Data Out” jack on CI6 #1 to the “Data In” jack on CI6 #2.using the 3.5mm stereo patch cord. 2. Connect all of the up to seven sources using short as possible good quality RCA patch cords to CI6 #1 source inputs. 3. Connect...

Page 13 - RB12 Remote control functions; Knoll Systems service information

13 The LCD display then displays: Source 2 Press the UP or DOWN buttons next to the INPUT buttons again to scroll through the label selections for source 2 on the bottom row of the LCD display. When the correct selection is displayed press the INPUT button to confirm this choice. Continue programmin...

Page 14 - Troubleshooting; Problem

14 www.knollsystems.com/contact.html, or by phone at 800 566-5579. It is extremely important that only an authorized service dealer make any repairs. This will ensure proper service and preserve the protection of your warranty. Keep your receipt in a safe place so that it will be available to verify...

Page 16 - Knoll shall have no further obligation under the; DISCLAIMER OF UNSTATED WARRANTIES; THE WARRANTY PRINTED ABOVE IS THE ONLY; LIMITATION OF LIABILITY; IT IS UNDERSTOOD AND AGREED THAT KNOLL’S LIABILITY; Knoll Systems; Made in Canada

16 Limited Warranty Knoll Systems, Inc. (“Knoll”) warrants that each CI6 and MR164 (“the Product”) sold hereunder will conform to and function in accordance with the written specifications of Knoll. Said limited warranty shall apply only to the first person or entity that purchases the Product for p...

Knoll C16 - Manual

Table of Contents:

Summary

Other Knoll Models