KitchenAid KFEG500EWH - Installation Manual

Page 2 - RANGE SAFETY; You; Your safety and the safety of others are very important.; DANGER; WARNING

2 RANGE SAFETY You can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don't follow All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what canhappen if the instructions are n...

Page 3 - INSTALLATION REQUIREMENTS; Tools and Parts; Tools Needed; Location Requirements; Mobile Home - Additional Installation Requirements; Mobile home installations require:

3 INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Needed Parts Supplied Check that all parts are included. ■ 10-32 hex nuts (attached to terminal block) (3) ■ Termi...

Page 4 - Product Dimensions; Cabinet Dimensions

4 Product Dimensions IMPORTANT: Range must be level after installation. Follow the instructions in the “Level Range” section. Using the cooktop as a reference for leveling the range is not recommended. * Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs. ** Front of do...

Page 5 - Electrical Requirements; Electrical Connection; Amps

5 Electrical Requirements If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and wire gauge are in accordance with local codes. Do not use an extension cord. Be sure that the electrical connection and wire size a...

Page 6 - INSTALLATION INSTRUCTIONS; Unpack Range; On Ranges Equipped with a Storage Drawer:; Install Anti-Tip Bracket; Excessive Weight Hazard; Tip Over Hazard

6 INSTALLATION INSTRUCTIONS Unpack Range 1. Remove shipping materials, tape and film from range. 2. Remove oven racks and parts package from inside oven. 3. Do not remove the shipping base at this time. 4. On Ranges Equipped with a Storage Drawer: Remove the storage drawer. See the “Storage Drawer” ...

Page 8 - Style 1: Power Supply Cord Strain Relief; Power Supply Cord

8 Electrical Connection 1. Disconnect power. 2. Remove the terminal block cover screws located on the back of the range. Pull cover down and toward you to remove cover from range. 3. Remove plastic tag holding three 10-32 hex nuts from the middle post of the terminal block. 4. Add strain relief. Sty...

Page 9 - Style 2: Direct Wire Strain Relief; Electrical Connection Options

9 Style 2: Direct Wire Strain Relief ■ Remove the knockout as needed for the flexible conduit connection. ■ Assemble a UL listed conduit connector in the opening. ■ Tighten strain relief screw against the flexible conduit. 5. Complete installation following instructions for your type of electrical c...

Page 10 - Direct Wire Installation: Copper or Aluminum Wire

10 5. Use ³⁄₈ " nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10–32 hex nuts. 6. Connect line 2 (red) and line 1 (black) wires to the outer terminal block posts with 10-32 hex nuts. 7. Securely tighten hex nuts. NOTE: For power supply cord repla...

Page 11 - Bare Wire Torque Specifications; Wire Awg

11 1. Cut out and remove part of metal ground strap, as shown. 2. Use a Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground link under the screw. 3. Pull the wires through the strain relief on bottom of range. Allow en...

Page 14 - Warming Drawer or Premium

14 Style 2: Ranges Equipped with a Warming Drawer or Premium Storage Drawer: Use a wrench or pliers to adjust leveling legs up or down until the range is level. Push range back into position. Check that rear leveling leg is engaged in the anti-tip bracket. NOTE: Range must be level for satisfactory ...

Page 15 - Complete Installation; If range does not operate, check the following:; Moving the Range; Electrical Shock Hazard

15 3. Slowly push the drawer into the range. NOTE: When properly installed, the rear slides on the bottom of the drawer will engage the base rails and the drawer will not tip when items are placed in the drawer. Complete Installation 1. Check that all parts are now installed. If there is an extra pa...

KitchenAid KFEG500EWH - Installation Manual

Table of Contents:

Other Manuals for KitchenAid KFEG500EWH

Summary

Other KitchenAid Ranges Models