Kenwood TK-8180- Manual

Kenwood TK-8180

Kenwood TK-8180– Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
77 Page 77
78 Page 78
79 Page 79
80 Page 80
81 Page 81
82 Page 82
83 Page 83
84 Page 84
85 Page 85
Page: / 85

Table of Contents:

  • Page 2 – INTRODUCTION; SCOPE OF THIS MANUAL; ORDERING REPLACEMENT PARTS; LICENSING REQUIREMENTS; GENERAL
  • Page 3 – SERVICE; NOTE
  • Page 4 – How to Enter Each Mode; REALIGNMENT
  • Page 5 – Firmware Programming Mode
  • Page 6 – Firmware Version Information; Clock Adjustment Mode
  • Page 7 – INSTALLATION
  • Page 11 – GPS Receiver Connection; ANI Board Connection; Voice Scrambler Board Connection
  • Page 13 – Removing the speaker hardware fixture; Precautions on Disassembly; DISASSEMBLY FOR REPAIR
  • Page 14 – Precautions on Reassembly
  • Page 15 – D-sub cap installation procedure
  • Page 16 – CIRCUIT DESCRIPTION; Receiver circuit
  • Page 17 – Transmitter Circuit; -3. Driver and Final Power Amplifier Circuit; Microphone and modultion level adjustment circuit
  • Page 18 – Frequency Synthesizer Unit; PLL block diagram
  • Page 19 – Power Supply Circuit; Power supply circuit
  • Page 20 – SEMICONDUCTOR DATA
  • Page 22 – COMPONENTS DESCRIPTION
  • Page 24 – PARTS LIST
  • Page 33 – EXPLODED VIEW; Display unit; Parts with the exploded numbers larger than 700 are not supplied.
  • Page 34 – PACKING
  • Page 35 – ADJUSTMENT
  • Page 36 – Panel Tuning Mode; B A L
  • Page 37 – Flow chart
  • Page 38 – Test Equipment Required for Alignment; Check Jig for the VGS-1
  • Page 39 – Common Section; Transmitter Section (K market model skips adjustment of Wide 4k)
  • Page 43 – Receiver Section (K market model skips adjustment of Wide 4k)
  • Page 45 – Adjustment Points
  • Page 46 – TERMINAL FUNCTION
  • Page 49 – Solder Land
  • Page 50 – PC BOARD
  • Page 61 – SCHEMATIC DIAGRAM
  • Page 62 – Note : The components marked with a dot (
  • Page 74 – INTERCONNECTION DIAGRAM
  • Page 75 – BLOCK DIAGRAM
  • Page 77 – LEVEL DIAGRAM; Receiver Section
  • Page 79 – External View; Parts List; Components Description
  • Page 80 – Exploded View and Packing
  • Page 81 – PC Board
  • Page 82 – Schematic Diagram
  • Page 83 – Terminal Function
  • Page 84 – OPTIONAL ACCESSORIES
  • Page 85 – KENWOOD CORPORATION; SPECIFICATIONS
Loading the manual

© 2004-7 PRINTED IN JAPAN
B51-8692-00 (N) 1007

UHF FM TRANSCEIVER

TK-8180

SERVICE MANUAL

Panel assy
(A62-1094-23)

Key top
(K29-9312-21)

Cabinet
(A01-2194-11)

Microphone
(T91-0639-05)

GENERAL .................................................................. 2

SYSTEM SET-UP ...................................................... 3

REALIGNMENT ......................................................... 4

INSTALLATION ......................................................... 7

DISASSEMBLY FOR REPAIR ................................. 13

CIRCUIT DESCRIPTION .......................................... 16

SEMICONDUCTOR DATA ...................................... 20

COMPONENTS DESCRIPTION .............................. 22

PARTS LIST ............................................................. 24

EXPLODED VIEW .................................................... 33

PACKING ................................................................. 34

ADJUSTMENT ........................................................ 35

TERMINAL FUNCTION ........................................... 46

PC BOARD

DISPLAY UNIT (X54-3480-10) ............................ 50

TX-RX UNIT (X57-6990-10) (A/3, C/3) ............... 52

TX-RX UNIT (X57-6990-10) (B/3) ....................... 54

SCHEMATIC DIAGRAM

DISPLAY UNIT (X54-3480-10) ............................ 58

TX-RX UNIT (X57-6990-10) ................................ 60

INTERCONNECTION DIAGRAM ............................ 69

BLOCK DIAGRAM ................................................... 70

LEVEL DIAGRAM .................................................... 72

OPTIONAL ACCESSORIES

KRK-10 (Control Head Remote Kit: 23ft/7m) ...... 74

KAP-2 (Horn Alert/P.A. Relay unit) ................... 79

KCT-40 (Radio Interface Cable) .......................... 79

KCT-46 (Ignition Sense Cable) ........................... 79

KMC-35 (Microphone) ........................................ 79

KMC-36 (Keypad Microphone) .......................... 79

SPECIFICATIONS ................................. BACK COVER

CONTENTS

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Manuals for Kenwood TK-8180

Summary

Page 2 - INTRODUCTION; SCOPE OF THIS MANUAL; ORDERING REPLACEMENT PARTS; LICENSING REQUIREMENTS; GENERAL

TK-8180 2 INTRODUCTION SCOPE OF THIS MANUAL This manual is intended for use by experienced techni- cians familiar with similar types of commercial grade commu-nications equipment. It contains all required service informa-tion for the equipment and is current as of this publicationdate. Changes which...

Page 3 - SERVICE; NOTE

TK-8180 3 SERVICE This radio is designed for easy servicing. Refer to the schematic diagrams, printed circuit board views, and align-ment procedures contained in this manual. NOTE • If you do not intend to use the speaker 3.5-mm jack and the D-sub 25-pin connector, fit the supplied speaker-jackcap a...

Page 4 - How to Enter Each Mode; REALIGNMENT

TK-8180 4 1. Modes Mode Function User mode For normal use. Panel test mode Used by the dealer to check the funda- mental characteristics. Panel tuning mode Used by the dealer to tune the radio. PC mode Used for communication between the radio and PC (IBM compatible). Data programming Used to read an...

Other Kenwood Models