Kenmore 7.0 cu. ft. Double-Oven Electric Range w/ Convection - Stainless Steel- Installation Manual

Kenmore 7.0 cu. ft. Double-Oven Electric Range w/ Convection - Stainless Steel

Kenmore 7.0 cu. ft. Double-Oven Electric Range w/ Convection - Stainless Steel– Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
Page: / 12
Loading the manual

1

30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS

29-7/8”

25-3/4”

49”

Maximum

42”

Door open

30”

36 1/8”

1. Clearances and Dimensions

a. Provide adequate clearances between the range and adjacent combustible surfaces.

b. Location—Check location where the range will be installed. Check for proper electrical supply and the stability of

fl

oor.

c. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface

must be solid and level.

*

30" minimum clearance between the top of the cooking surface

and the bottom of an unprotected wood or metal cabinet; or 24

" minimum when bottom of wood or metal cabinet is protected

by not less than ¼"

fl

ame retardant millboard covered with not

less than no. 28 MSG sheet steel, 0.015" stainless steel, 0.024"

aluminum or 0.020" copper. The minimum clearance is 0" for the

rear of the range. Follow all dimension requirements provided

above to prevent property damage, potential

fi

re hazard, and

incorrect countertop and cabinet cuts.

Avoid locating cabinet storage space above the surface units to

eliminate the possibility of cabinets catching on

fi

re, or personal

burns from reaching for the cabinets over the heated units. If

cabinet storage is to be provided, risk can be reduced by installing

a range hood that projects horizontally a minimum of 5" beyond

the bottom of the cabinets.

Printed in Canada

318201736 (1201) Rev. A

FRONT

VIEW

BACK

VIEW

FRONT

VIEW

TYPICAL CABINET INSTALLATION

SIDE

VIEW

Important Notes to the Installer

1. Read all instructions contained in these installation

instructions before installing the appliance.

2. Remove all packing material before connecting the electrical

supply to the appliance.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the consumer.

Important Note to the Consumer

Keep these instructions with your Use and

Care Guide for future reference.

All dimensions for

electrical outlet location are

maximum.

Cubed area shows
where the electrical
outlet must be installed
for the range to be

fl

ush to the wall.

Wall

Edge

Terminal

Block

Location

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other

fl

ammable vapors and liquids in the vicinity of this or any other appliance.

United States

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Kenmore Models