JL Audio XD200/2 - Manual
JL Audio XD200/2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – PRODUCT DESCRIPTION; The XD200/2 can be operated with a wide; TYPICAL INSTALLATION SEQUENCE; The following represents the sequence
- Page 6 – INPUT SECTION
- Page 7 – To properly set the amplifier for maximum; Do not increase any “Input Sens.” setting for
- Page 8 – FILTER CONTROLS; Most speakers are not designed to reproduce
- Page 9 – PREOUTS; The preamp output delivers the same signal
- Page 10 – SPEAKER OUTPUTS; The XD200/2’s speaker outputs are designed; BRIDGING CONSIDERATIONS; Bridging is the practice of combining the
- Page 11 – STATUS LED / PROTECTION CIRCUITRY; There is a single multi-color LED on the top; SERVICING YOUR JL AUDIO AMPLIFIER; If your amplifier fails or malfunctions, please
- Page 12 – Following the directions below will allow the; Necessary Equipment; amplifier’s speaker output connectors.; Impedance; not recommended
- Page 13 – General Specifications:; Recommended Fuse Value:; Rated Power at 14.4V with less than; Signal to Noise Ratio:; “FILTER FREQ”; Detent Panel Actual
- Page 14 – contact with the input jacks on the amplifier.; APPENDIX D: TROUBLESHOOTING
- Page 20 – If you need service on your JL AUDIO product:; (do not send product for repair to this address); International Warranties:; by that country’s distributor and not by JL Audio, Inc.
Thank you for purchasing a JL Audio amplifier for
your automotive sound system.
Your amplifier has been designed and manufactured to exacting
standards in order to ensure years of musical enjoyment in your vehicle.
For maximum performance, we highly recommend that you have
your new amplifier installed by an authorized JL Audio dealer. Your
authorized dealer has the training, expertise and installation equipment
to ensure optimum performance from this product. Should you
decide to install the amplifier yourself, please take the time
to read this manual thoroughly so as to familiarize yourself
with its installation requirements and setup procedures.
If you have any questions regarding the instructions in this
manual or any aspect of your amplifier’s operation, please contact your
authorized JL Audio dealer for assistance. If you need further assistance,
please call the JL Audio Technical Support Department
at (954) 443-1100 during business hours.
OWNER’S MANUAL
200W 2-Channel Amplifier
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
4 | JL Audio - XD200/2 Owner’s Manual PRODUCT DESCRIPTION The JL Audio XD200/2 is a two-channel, full-range audio amplifier utilizing JL Audio NexD™ ultra-high speed switching technology to deliver outstanding fidelity and efficiency. The XD200/2 can be operated with a wide variety of source units a...
6 | JL Audio - XD200/2 Owner’s Manual TURN-ON LEAD The XD200/2 uses a conventional +12V remote turn-on lead, typically controlled by the source unit's remote turn-on output. The amplifier will turn on when +12V is present at its “Remote” input and turn off when +12V is switched off. If a source unit...
7 INPUT SENSITIVITY CONTROL The control labeled “Input Sens.” can be used to match the source unit’s output voltage to the input stage of the amplifier for maximum clean output. Rotating the control clockwise will result in higher sensitivity (louder for a given input voltage). Rotating the control ...
