JL Audio A4300 - Manual
JL Audio A4300 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – FUSE REQUIREMENTS; PRODUCT DESCRIPTION; JL AUDIO
- Page 4 – FILTER CONTROLS; INPUT SECTION
- Page 5 – BASS BOOST CONTROLS
- Page 6 – Advanced Rollback Thermal protection; PM
- Page 8 – “FILTER FREQ” AMP FILTER; General Specifications:; ts; Necessary Equipment
Thank you for purchasing a JL Audio amplifier for
your automotive sound system.
Your amplifier has been designed and manufactured to exacting
standards in order to ensure years of musical enjoyment in your vehicle.
For maximum performance and extended warranty
coverage, we highly recommend that you have your new amplifier
installed by an authorized JL Audio dealer. Your authorized
dealer has the training, expertise and installation equipment to ensure
optimum performance from this product. Should you
decide to install the amplifier yourself, please take the time
to read this manual thoroughly so as to familiarize yourself
with its installation requirements and setup procedures.
If you have any questions regarding the instructions in this
manual or any aspect of your amplifier’s operation, please contact your
authorized JL Audio dealer for assistance. If you need further assistance,
please call the JL Audio Technical Support Department
at (954) 443-1100 during business hours.
OWNER’S MANUAL
A
4300
four-channel full-range amplifier
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
The A4300’s “ +12VDC ” and “ Ground ” connections are designed to accept 8 AWG - 4 AWG power wire. 8 AWG is a minimum power wire size for this amplifier. If you are installing the A4300 with other amplifiers and wish to use a single main power wire, use 4 AWG or larger main power wire (depending on ...
Do not increase any “Input Sens.” setting for any channel(s) of any amplifier in the system beyond the maximum level established during the procedure outlined in Appendix A (page 14). Doing so will result in audible distortion and possible speaker damage. FILTER CONTROLS Most speakers are not design...
SPEAKER OUTPUTS The A4300’s speaker outputs are designed to accept 16 AWG - 8 AWG wire. Each pair of the A4300’s channels are designed to deliver power into speaker loads equal to or greater than 2 ohms per channel when using a “stereo” configuration and speaker loads equal to or greater than 4 ohms...
