JBL 2.4G AW - Manual - manualsarea.com

Page 2 - FCC Radiation Exposure Statement

2 This equipment has been tested and found to comply with the limitsfor a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiate ...

Page 3 - English; IMPORTANT SAFETY INSTRUCTIONS; Do not expose this apparatus to

3 English IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings.Install in accordance with themanufactur...

Page 4 - UNPACKING THE SYSTEM; Included; THANK YOU FOR CHOOSING JBL; CODE; RIGHT-CHANNEL SPEAKER

4 For more than 60 years, JBL has been involved in every aspect ofmusic and film recording and reproduction, from live performances to the recordings you play in your home, car or office. We’re confident that the JBL system you have chosen will provideevery note of enjoyment that you expected – and ...

Page 5 - Application 1; CONNECTIONS; Surround Channel

5 English Notes: For the sake of simplicity, throughout this manual we have used the term “source” when describing connections and operation.This would apply to any device such as an A/V receiver, audiocomponent, computer or portable music player. The JBL On Air may be connected to your source in se...

Page 6 - Preamp Outputs

6 Step 3. Connect the speaker wire (included) to the push terminals on the active speaker and the push terminals on the rear of the passive speaker . See Figure 3. Please note that the speaker wire supplied features apolarity stripe to help distinguish its two conductors. Use thispolarity stripe to ...

Page 7 - Connection Option B

7 English When connected properly, the top LED on the front of the activespeaker should be green. When first plugged in, it will sometimestake several seconds for the Control 2.4G AW active speaker toinitialize and “wake up.” Until then, the top LED will be in red. Oncethe top LED is green, the bott...

Page 8 - OPERATION

8 Adjusting the Volume Application 1 Adding surround speakers to a home theater system: In this application, the output level of your Control 2.4G AW activespeakers will not only be dependent on the volume setting of yourA/V source, it will also need to be properly adjusted after installationand bef...

Page 9 - Important safety note:; WALL AND STAND PLACEMENT

9 English Adjustable wall brackets are included for the two speakers andtransmitter module. The included bracket are for wall-mounting only. It is not to be used for ceiling mounting. Ceiling mounting of theControl 2.4G AW transmitter and/or speakers is not recommended,regardless of bracket used. Wa...

Page 10 - DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY; MAINTENANCE AND SERVICE

10 Wall-Mounting the Speakers Using Third-Party Wall Brackets Each JBL On Air Control 2.4G AW wireless speaker contains a 1/4"-20 threaded insert on the back to facilitate the use of third-partywall brackets. Please consult your JBL dealer or distributor forrecommendations. NOTES: Customer is re...

Page 11 - 5 Watts per channel; RF Operating Frequency:; SPECIFICATIONS

11 English Frequency Range (±3dB): 80Hz – 20kHz Amplifier Output: 15 Watts per channel Low-Frequency Driver: 100mm (4") Magnetically shielded High-Frequency Driver: 12mm (1/2") Titanium-laminate, magnetically shielded Operating Range: Up to 21m (70') depending upon conditions RF Operating Fr...

Page 12 - PRO SOUND COMES HOME

JBL and Control Series are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries. Pro Sound Comes Home are trademarkof Harman International Industries, Incorporated. ® PRO SOUND COMES HOME ™ Harman Consumer Group, Inc., 250 Crossways Park...

JBL 2.4G AW - Manual

Table of Contents:

Summary

Other JBL Models