Page 2 - Notice Page; TM-1400 Series Progressive Scan Shutter Camera; Notice; CE Compliance; WARNING; TM-1400 Series Operation Manual; UL
i Notice Page TM-1400 Series Progressive Scan Shutter Camera Notice The material contained in this manual consists of information that is proprietary to JAI PULNiX, Inc., and may only be used by the purchasers of the product. JAI PULNiX, Inc. makes no warranty for the use of its product and assumes ...
Page 4 - TM-1400 Series Progressive Scan Shutter Cameras
Page ii Table of Contents TM-1400 Series Progressive Scan Shutter Cameras 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.1 Product Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11.2 Features . . . . . . . . . . . ....
Page 8 - Operation Manual; Introduction; Product Description
May 2, 2005 TM-1400 Series Progressive Scan Shutter Cameras TM-1400 Series Progressive Scan Shutter Cameras Operation Manual 1 Introduction 1.1 Product Description The PULNiX TM-1400 series consists of high-resolution, high-speed progressive scan CCD cameras. * The progressive interline-type CCD per...
Page 9 - x 4.65 μm square pixels for precise dimensional measurement.
Page 2Introduction TM-1400 Series Progressive Scan Shutter Cameras 1.2 Features • Miniaturized and lightweight The printed circuit boards in the TM-1400 have been arranged based on a design philosophy that creates modular electronics for the camera, giving it flexibility. In addition, the use of min...
Page 10 - Functional Options
Page 3 Introduction TM-1400 Series Progressive Scan Shutter Cameras • Integration The TM-1400 is capable of capturing high-resolution integration images. Its CCD imager can be exposed for longer than the normal scan timing of 1/30 sec. This integration feature provides extra sensitivity for applicat...
Page 11 - System Configuration; TM-1400 System Configuration
Page 4Introduction TM-1400 Series Progressive Scan Shutter Cameras 1.4 System Configuration FIGURE 1. TM-1400 System Configuration Figure 1 below presents a typical system configuration for the TM-1400 camera. FIGURE 2. TM-1400CL System Configuration Figure 2 below presents a typical system configur...
Page 12 - Installation; Digital output cable (not required for “CL” version)
Page 5 Installation TM-1400 Series Progressive Scan Shutter Cameras 2 Installation The following instructions are provided to help you to set up your camera quickly and easily. We suggest that you read through these instructions before you unpack and set up your camera system. 2.1 Getting Started 2....
Page 13 - material like plastic.; 2-Pin Connector on Rear Panel of Camera
Page 6Installation TM-1400 Series Progressive Scan Shutter Cameras recommends using a cooling fan to set up a positive air flow around the camera, and following the precautions below: • Mount the camera on a large heat sink (camera bracket) made out of a conductive material such as aluminum. • Make ...
Page 15 - SerToFG: Differential Serial Communication to frame grabber.; Description
Page 8Installation TM-1400 Series Progressive Scan Shutter Cameras 2.2.2 (d) Camera Link Connector The TM-1400CL has a 26-pin MDR26 connector (3M part number 10226-6212VC) on the rear panel to output Camera Link data. The connector pin-out is shown in Table 4 below. Note: SerTC: Differential Serial ...
Page 16 - Shutter Speed Control Dial; Normal; Ext. pulse width control
Page 9 Installation TM-1400 Series Progressive Scan Shutter Cameras 2.2.3 Shutter Speed Control Dial (TM-1400 only) Shutter speed can be selected by switching the shutter dial to the appropriate setting (0 through 9). The factory default settings correspond to the shutter speeds as shown in below. 2...
Page 18 - Power Supplies and Power Cable Setup; A universal power supply with European plug
Page 11 Installation TM-1400 Series Progressive Scan Shutter Cameras 2.2.6 Camera Link Cable (CL Versions Only) The MDR26 cable assembly (26CL-02-26) from 3M (part number 10226-6212VC) has been standardized as the Camera Link cable. This cable has the 26-pin MDR26 connector on both ends. This is a s...
Page 19 - All connections must be properly insulated to prevent shorting.
Page 12Installation TM-1400 Series Progressive Scan Shutter Cameras When wiring the PD-12UU power supply directly, please note the following: • The lead ends must be twisted together and tin-soldered for strength and electrical continuity. • Shrink tubing or a similar insulator should be used to pre...
Page 21 - Operation
Page 14Operation TM-1400 Series Progressive Scan Shutter Cameras 3 Operation 3.1 Camera Rear Panel (TM-1400) 3.1.1 Up/Down Switch The Mode Selection switch works in conjunction with the Up/Down switch. Refer to Table 6 on page 15 for information on the Up/Down switch. 3.1.2 Digital Output Connector ...
Page 22 - Mode Selection Switch
Page 15 Operation TM-1400 Series Progressive Scan Shutter Cameras the RS-232 interface will override the rear panel switch settings of the camera. The table below shows details on various modes. TABLE 6. Mode Selection Switch Mode Selection Switch Position Mode Information Up/Down Switch Functions 0...
Page 23 - Progressive Scanning; CAMERA LINK
Page 16Operation TM-1400 Series Progressive Scan Shutter Cameras 3.2 Camera Rear Panel (CL Versions) 3.2.1 Digital Output Connector Refer to Section 2.2.2 (d on page 8 for Camera Link information. 3.2.2 Analog Output Connector The TM-1400CL camera has a BNC connector on the rear panel to output anal...
Page 24 - Progressive scanning digital and analog output; Electronic Shutter
Page 17 Operation TM-1400 Series Progressive Scan Shutter Cameras The TM-1400 outputs the progressive scan image with an electronic shutter in two different formats: • Progressive scanning digital and analog output The CCD signal goes through A/D and D/A converters and through 10-bit in, 8-bit out l...
Page 26 - Dynamic Range Control
Page 19 Operation TM-1400 Series Progressive Scan Shutter Cameras 3.6 Dynamic Range Control The typical interline transfer CCD has fixed noise levels based on dark current (thermal or KT noise), pattern noise, and the operating clock speed. In general, the level of the 50 MHz pixel clock CCD at room...
Page 27 - Variable Gamma
Page 20Operation TM-1400 Series Progressive Scan Shutter Cameras LUT selections: (a standard LUT is 10 sets of knee-control LUT) • Variable Gamma • Variable knee curve • Direct input LUT 3.7 Scan Modes The TM-1400 supports the following scan modes: 3.7.1 Full Progressive Scan The normal scan mode pr...
Page 30 - information but cannot be interpolated as a Bayer CFA.; LDV
Page 23 Operation TM-1400 Series Progressive Scan Shutter Cameras The following diagram is an example of the TMC-1400 (same as TM-1400). It is important to meet the exact starting pixel at LDV and the starting line of FDV. If the starting pixel or line is shifted due to the image capture configurati...
Page 31 - Frame Grabber Interpolation Software List; Manufacturer; Green
Page 24Operation TM-1400 Series Progressive Scan Shutter Cameras 3.9.6 Interpolation Software Major frame grabber manufacturers with digital capability (Camera Link, RS-644) provide color interpolation software. Some independent image process software suppliers provide software as well. The followin...
Page 32 - Camera Timing Charts; ec; Horizontal Signals
Page 25 Operation TM-1400 Series Progressive Scan Shutter Cameras 3.10 Camera Timing Charts Model: TM-1400 Operation Mode: 30 Frame /sec Master Clock: 100 MHz, M=10 nsecPixel Clock: 50 MHz, P= 20 nsec ec 1. Pixel Clock and Digital Data Tcd TdcT hd Tcd: Clock to Data ReadyTdc: Data Ready to Next Cloc...
Page 33 - External Reset Timing; Delay of internal VD depends on the shutter speed.
Page 26Operation TM-1400 Series Progressive Scan Shutter Cameras Model: TM-1400 Operation Mode: 30 Frames/Second Master Clock: 100.00MHz, M = 10 nsecPixel Clock: 50 MHz, P = 20 nsec 3. External Reset Timing 4. Async Shutter Reset Timing External VD Internal VD FDV Digital Data Analog Video VINIT Tri...
Page 34 - Pixel Clock and Digital Data
Page 27 Operation TM-1400 Series Progressive Scan Shutter Cameras Model: TM-1400 Operation Mode: 15 Frame /sec Master Clock: 50 MHz, M= 20 nsecPixel Clock: 25 MHz, P= 40 nsec 1. Pixel Clock and Digital Data Tcd TdcT hd Tcd: Clock to Data ReadyTdc: Data Ready to Next ClockThd: Data Hold Time Pixel Cl...
Page 38 - Camera Link cable. No additional accessories are required.
Page 31 Operation TM-1400 Series Progressive Scan Shutter Cameras 3.11 Serial Communication Kit CS-232C (not required for “CL” version) The TM-1400’s functions can be controlled by a PC via RS-232C communication using the CS-232E serial communication kit. This kit consists of the RS-232B-12 cable, s...
Page 39 - Troubleshooting; Problems and Solutions
Page 32Troubleshooting TM-1400 Series Progressive Scan Shutter Cameras 4 Troubleshooting 4.1 Problems and Solutions Following are troubleshooting tips for common problems. In general, problems can easily be solved by following these instructions. If the following remedies fail to offer a solution to...
Page 40 - Information and Support Resources; For further information and support:
Page 33 Troubleshooting TM-1400 Series Progressive Scan Shutter Cameras 4.2 Information and Support Resources For further information and support: Phone: (408) 747-0300 (800) 445-5444 Fax: (408) 747-0660 E-mail: [email protected] Mail: JAI PULNiX, Inc.Sales Department1330 Orleans DriveSunnyvale,...
Page 41 - Appendix; TM-1400 Series Product Specifications Table; Model
Page 34Appendix TM-1400 Series Progressive Scan Shutter Cameras 5 Appendix 5.1 Specifications TABLE 8. TM-1400 Series Product Specifications Table Model TM-1400 series Imager 1/2" progressive scan interline transfer CCD Active Area 7.60mm (H) x 6.20mm (V) Active Pixels 1392 (H) x 1040 (V) Cell s...
Page 42 - Physical Dimensions
Page 35 Appendix TM-1400 Series Progressive Scan Shutter Cameras 5.2 Physical Dimensions FIGURE 9. Physical Dimensions (TM-1400) Optional Functions(must be ordered separately) OP 89-3 Differential Input, VINITOP 89-4 Differential Input, VDOP 93 RS-422OP 93-1 10-bit output Optional Accessories (must ...
Page 43 - Spectral Response
Page 36Appendix TM-1400 Series Progressive Scan Shutter Cameras FIGURE 10. Physical Dimensions (TM-1400CL) 5.3 Spectral Response FIGURE 11. Spectral Response 25.4 [1.00] 7.0 [0.28] 14.7 [0.58] 63.0 [2.48] 75.7 [2.98] 34.0 [1.34] 22.0 [0.87] 18.0 [0.71] 2X M6 1/4-20 SOC HD CAP SCR 2X M3 X 6.0 [0.24] ...
Page 44 - I m a g i n g P r o d u c t s
JAI PULNiX, Inc.1330 Orleans DriveSunnyvale, CA 94089 Tel: 408-747-0300Tel: 800-445-5444Fax: 408-747-0660 w w w . j a i p u l n i x . c o m I m a g i n g P r o d u c t s 69-0115Rev. C Email: [email protected]
