Page 2 - Page ii
Page 3 - Page iii; Notice; CE Compliance; WARNING; UL
Page iii Notice The material contained in this manual consists of information that is proprietary to JAI, Inc., and may only be used by the pur-chasers of the product. JAI, Inc. makes no warranty for the use of its product and assumes no responsibility for any errors which may appear or for damages ...
Page 4 - Page iv
Page 5 - Page v; Table of Contents; External VINIT With Pulse Width No-Delay Shutter and ROI
Page v Table of Contents Table of Contents Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . vList of Tables. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . viiList of Figures. . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 6 - Page vi
Page vi Table of Contents 3.6.5 External VINIT with Pulse Width (TM-1020-15 Only) . . . . . . . . . 25 3.7 Dynamic Range Control . . . . . . . . . . . . . . . . . . . . . . . . . . 26 3.7.1 Programmable Look-Up Table (LUT) and Knee Control . . . . . . . . 26 3.8 Scan Modes . . . . . . . . . . . . . ...
Page 7 - Page vii; List of Tables; Connector and Pin-out Configurations
Page vii List of Tables List of Tables TABLE 1. 12-Pin Connector (LVDS/RS-422 version) . . . . . . . . . . . . . . . . . . . . . . . . 6 TABLE 2. 12-Pin Connector (CL Version) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 TABLE 3. 31-Pin Connector (MP211-031-113-4300) . . . . ....
Page 8 - Page viii
Page 9 - Page ix; List of Figures
Page ix List of Figures List of Figures FIGURE 1. TM-1020 Series System Configuration . . . . . . . . . . . . . . . . . . . . . .4 FIGURE 2. CL (Camera Link) System Configuration . . . . . . . . . . . . . . . . . . . .4 FIGURE 3. Rear Panel View of Digital Connector. . . . . . . . . . . . . . . . . ...
Page 10 - Page x
Page 11 - TM-1020 Series Progressive Scan Shutter Cameras; Operation Manual; Introduction; Product Description
May 31, 2007 TM-1020 Series Progressive Scan Shutter Cameras TM-1020 Series Progressive Scan Shutter Cameras Operation Manual 1 Introduction 1.1 Product Description The JAI, Inc. TM-1020 series 1 consists of high-resolution, high-speed monochrome progressive scan CCD cameras. The interline-type CCD ...
Page 13 - Functional Option
Page 3 TM-1020 Series Progressive Scan Shutter Cameras Introduction - Internal shutter speed with Slow mode . The speed control varies from 1/125 to 1/1,000 sec. The video signal starts with internal V reset timing related to shutter speed. • Output The TM-1020 series has an 8-bit RS-644 digital out...
Page 14 - System Configuration; TM-1020 Series System Configuration
Page 4TM-1020 Series Progressive Scan Shutter Cameras Introduction 1.4 System Configuration FIGURE 1. TM-1020 Series System Configuration Figure 1 below presents a typical system configuration for the LVDS/RS-422 version. FIGURE 2. CL (Camera Link) System Configuration Figure 2 below presents a typi...
Page 15 - Installation; Camera-specific data sheet
Page 5 TM-1020 Series Progressive Scan Shutter Cameras Installation 2 Installation The following instructions are provided to help you to set up your camera quickly and easily. We suggest that you read through these instructions before you unpack and set up your camera system. 2.1 Getting Started 2....
Page 20 - no shutter
Page 10TM-1020 Series Progressive Scan Shutter Cameras Installation 2.2.3 Shutter Speed Control Dial (LVDS/RS-422 version) Shutter speed can be selected by switching the shutter dial to the appropriate setting (0 through 9). The factory default settings correspond to the shutter speeds as shown in T...
Page 23 - Power Supplies and Power Cable Setup; US Plug
Page 13 TM-1020 Series Progressive Scan Shutter Cameras Installation 2.2.7 Power Supplies and Power Cable Setup 2.2.7 (a) Power Supplies The TM-1020 series camera requires 12V DC power that is obtained through the 12-pin connector located on the rear panel of the camera. JAI, Inc. recommends the fol...
Page 24 - Press the connector into place until firmly seated.; Lead Color
Page 14TM-1020 Series Progressive Scan Shutter Cameras Installation FIGURE 8. 12P-02S Interface Cable (optional) Note: Make sure that the unused leads are not touching and that there is no possibility that exposed wires could cause the leads to short. 2.2.7 (c) Building Your Own Power Cable Refer to...
Page 26 - Operation
Page 16TM-1020 Series Progressive Scan Shutter Cameras Operation 3 Operation 3.1 Camera Rear Panel (LVDS/RS-422 Version) 3.1.1 Up/Down Switch The Mode Selection switch works in conjunction with the Up/Down switch. Refer to Table 6 above for information on the Up/Down switch. 3.1.2 Digital Output Con...
Page 28 - Progressive Scanning; CAMERA LINK
Page 18TM-1020 Series Progressive Scan Shutter Cameras Operation 3.2 Camera Rear Panel (CL Versions) 3.2.1 Digital Output Connector Refer to Section 2.2.6 on page 12 for information on digital output connectors. 3.2.2 Analog Output Connector The CL-version camera has a BNC connector on the rear pane...
Page 29 - Progressive-scanning digital and analog output; Electronic Shutter
Page 19 TM-1020 Series Progressive Scan Shutter Cameras Operation The TM-1020 series outputs the progressive-scanned image with an electronic shutter in two different formats: 1. Progressive-scanning digital and analog output The CCD signal goes through A/D and D/A converters and through 10-bit in, ...
Page 30 - Asynchronous Reset; Internal Shutter Speed with Fast Mode
Page 20TM-1020 Series Progressive Scan Shutter Cameras Operation 3.6 Asynchronous Reset The TM-1020 series's asynchronous reset is flexible and accepts external horizontal drive (HD) for phase locking. When the VINIT pulse is applied, it resets the camera's scanning and purging of the CCD. For async...
Page 34 - and the second internal VINIT signal is delayed to set
Page 24TM-1020 Series Progressive Scan Shutter Cameras Operation 3.6.4 Internal Shutter Speed with Slow Mode (TM-1020-15 Only) FIGURE 13. Internal Shutter Speed with Slow Mode (TM-1020-15 Only) The speed control ranges from 1/120 to 1/950 sec. The video signal starts with internal VINIT. Select a di...
Page 36 - Dynamic Range Control
Page 26TM-1020 Series Progressive Scan Shutter Cameras Operation 3.7 Dynamic Range Control The typical interline transfer CCD has fixed noise levels based on dark current (thermal or KT noise), pattern noise, and the operating clock speed. In general, the level of the 20 MHz pixel clock CCD at room ...
Page 37 - The TM-1020 series supports the following scan modes:; Scan Modes
Page 27 TM-1020 Series Progressive Scan Shutter Cameras Operation FIGURE 15. Look-Up Table 3.8 Scan Modes The TM-1020 series supports the following scan modes: FIGURE 16. Scan Modes 256 224 192 160 128 96 64 32 0 128 256 384 512 640 768 896 1024 KneeTable 01234567 LUT #7 LUT #3 LUT #5 LUT #4 LUT #6 ...
Page 38 - External Sync and Pixel Locking
Page 28TM-1020 Series Progressive Scan Shutter Cameras Operation 3.8.1 Full Progressive Scan Normal scanning mode the TM-1020 series is for 1008 x 1018 pixels. The standard speed with single-channel output is 15 frame/sec at the pixel clock of 20 MHz. The progressive scan reads every line from top t...
Page 39 - Camera Timing Charts; Operation Mode: 15 fps; Pixel Clock and Digital Data; Horizontal Signals
Page 29 TM-1020 Series Progressive Scan Shutter Cameras Operation 3.10 Camera Timing Charts Model: TM-1020-15 Operation Mode: 15 fps Master Clock: 40.0 MHz, M= 25 nsecPixel Clock: 20.0 MHz, P= 50 nsec 1. Pixel Clock and Digital Data Tcd Tdc Thd Tcd: Clock to Data ReadyTdc: Data Ready to Next ClockTh...
Page 40 - External Reset Timing; sec
Page 30TM-1020 Series Progressive Scan Shutter Cameras Operation Model: TM-1020 Operation Mode: 15 Frames/Second Master Clock: 40 MHz, M= 25 nsec Pixel Clock: 20 MHz, P = 50 nsec 3. External Reset Timing 4. Async Reset Timing External VD Internal VD FDV Digital Data Analog Video VINIT Trigger Intern...
Page 41 - Operation Mode: 30 fps
Page 31 TM-1020 Series Progressive Scan Shutter Cameras Operation Model: TM-1020-30 Operation Mode: 30 fps Master Clock: 80.0 MHz, M= 12.5 nsecPixel Clock: 40.0 MHz, P= 25 nsec 1. Pixel Clock and Digital Data Tcd Tdc Thd Tcd: Clock to Data ReadyTdc: Data Ready to Next ClockThd: Data Hold Time Pixel ...
Page 43 - Serial Communication Kit; The LVDS/RS-422 version’s functions can be controlled by a PC via RS-; Camera Link; Camera Control software.
Page 33 TM-1020 Series Progressive Scan Shutter Cameras Operation 3.11 Serial Communication Kit • LVDS/RS-422 Version The LVDS/RS-422 version’s functions can be controlled by a PC via RS- 232C communication using the CS-232E serial communication kit. This kit consists of the RS-232B-12 cable, softwa...
Page 46 - Troubleshooting; Problems and Solutions
Page 36TM-1020 Series Progressive Scan Shutter Cameras Troubleshooting 5 Troubleshooting 5.1 Problems and Solutions Following are troubleshooting tips for common problems. In general, problems can easily be solved by following these instructions. If the following remedies fail to offer a solution to...
Page 47 - Information and Support Resources; For further information and support:
Page 37 TM-1020 Series Progressive Scan Shutter Cameras Troubleshooting 5.2 Information and Support Resources For further information and support: Phone: (408) 383-0300 (800) 445-5444 Fax: (408) 383-0301 E-mail: [email protected] Mail: JAI, Inc.Sales Department625 River Oaks ParkwaySan Jose, CA 95134A...
Page 48 - Appendix; Internal/external auto switch
Page 38TM-1020 Series Progressive Scan Shutter Cameras Appendix 6 Appendix 6.1 Specifications TABLE 8. TM-1020 Series Camera Specifications Table Feature TM-1020-15 TM-1020-15CL TM-1020A-15 TM-1020-30 TM-1020-30CL Imager 1" (9.1mm x 9.2mm) progressive scan interline transfer CCD Pixels 1024 (H) ...
Page 49 - increasing temperature.; Feature
Page 39 TM-1020 Series Progressive Scan Shutter Cameras Appendix Power supply PD-12UUP (includes power connector) Functional options RS-644 (LVDS/RS-422) output. I/O 26CL-02-26 digital output cable (CL models) *. Refer to Section 2.2.2 on page 6 for information on camera heat dissipation. Image qual...
