Jackson JPX-300H - Manual - manualsarea.com

Page 2 - MANUFACTURERS WARRANTY; ONE YEAR LIMITED PARTS & LABOR WARRANTY

ALL NEW JACKSON DISHWASHERS ARE WARRANTED TO THE ORIGINAL PURCHASER TO BE FREE FROMDEFECTS IN MATERIAL OR WORKMANSHIP, UNDER NORMAL USE AND OPERATION FOR A PERIOD OF (1) ONEYEAR FROM THE DATE OF PURCHASE, BUT IN NO EVENT TO EXCEED (18) EIGHTEEN MONTHS FROM THE DATEOF SHIPMENT FROM THE FACTORY. Jacks...

Page 5 - ii; NOMENCLATURE FOR THE MODELS COVERED IN THIS MANUAL

ii NOMENCLATURE FOR THE MODELS COVERED IN THIS MANUAL JPX-300HN JPX-300H = High temperature, hot water sanitizing, with a booster tank.JPX-300HC = High temperature, hot water sanitizing, with a booster tank, and a cycle counter.JPX-300HN = High temperature, hot water sanitizing, with no booster tank...

Page 6 - TABLE OF CONTENTS

TABLE OF CONTENTS iii SECTION DESCRIPTION PAGE I. SPECIFICATION INFORMATION Specifications JPX-300H/HC/HN 2 Specifications JPX-300L 3 Dimensions JPX-300H/HC 4 Dimensions JPX-300HN 5 Dimensions JPX-300L 6 II. INSTALLATION/OPERATION INSTRUCTIONS Installation Instructions 8 Electrical Installation Inst...

Page 7 - SPECIFICATION INFORMATION

Page 8 - SECTION 1: SPECIFICATION INFORMATION

JPX-300 Installation/Operation Manual 7610-002-71-26 Rev. J Issued: 03-09-2006 Revised: N/A 2 SECTION 1: SPECIFICATION INFORMATION SPECIFICATIONS of the JPX-300H/JPX-300HC/JPX-300HN PERFORMANCE/CAPABILITIES OPERATING CAPACITY (RACKS/HOUR) RACKS PER HOUR 30 DISHES PER HOUR 600 GLASSES PER HOUR 600 OP...

Page 10 - DIMENSIONS; LEGEND

JPX-300 Installation/Operation Manual 7610-002-71-26 Rev. J Issued: 03-09-2006 Revised: N/A SECTION 1: SPECIFICATION INFORMATION JPX-300H/HC DIMENSIONS 4 DIMENSIONS Height (minimum): 33 1/4” (84.5 cm) Inside Clearance Height: 14 1/2” (36.8 cm) Height (maximum): 34 1/4” (87 cm) Inside Clearance Width...

Page 14 - SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS; INSTALLATION INSTRUCTIONS

JPX-300 Installation/Operation Manual 7610-002-71-26 Rev. J Issued: 03-09-2006 Revised: 09-14-2006 SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS 8 INSTALLATION INSTRUCTIONS VISUAL INSPECTION: Before installing the unit, check the container and machine for damage. A damaged container is an indi- cat...

Page 15 - CHEMICAL CONNECTIONS:; ELECTRICAL INSTALLATION INSTRUCTIONS

SHOCK ABSORBER: It is also recommended that a shock absorber (not supplied with the JPX-300 series models) be installed in the incoming water line. This prevents line hammer (hydraulic shock), induced by the solenoid valve as it operates, fromcausing damage to the equipment. CONNECTING THE DRAIN LIN...

Page 18 - DETERGENT CONTROL

JPX-300 Installation/Operation Manual 7610-002-71-26 Rev. J Issued: 03-09-2006 Revised: N/A SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS 12 Detergent usage and water hardness are two factors that contribute greatly to how efficiently your dishmachine will operate.Using detergent in the proper amou...

Page 19 - FILLING THE WASH TUB:

JPX-300 Installation/Operation Manual 7610-002-71-26 Rev. J Issued: 03-09-2006 Revised: N/A SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS PREPARATION: Before proceeding with the start-up of the unit, verify the following: 1. The strainer is in place and is clean. 2. That the wash and rinse arms are...

Page 20 - SHUTDOWN AND CLEANING:

JPX-300 Installation/Operation Manual 7610-002-71-26 Rev. J Issued: 03-09-2006 Revised: 09-14-2006 SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS 14 SHUTDOWN AND CLEANING: At the end of the workday, close the door. Start a cycle. Wait approximately five seconds after the green auto light comes on an...

Page 21 - PREVENTATIVE MAINTENANCE

Page 22 - SECTION 3: PREVENTATIVE MAINTENANCE

JPX-300 Installation/Operation Manual 7610-002-71-26 Rev. J Issued: 03-09-2006 Revised: N/A SECTION 3: PREVENTATIVE MAINTENANCE 16 The dishmachines covered in this manual are designed to operate with a minimum of interaction with the operator. However,this does not mean that some items will not wear...

Page 23 - ELECTRICAL SCHEMATICS

Page 24 - SECTION 4: ELECTRICAL SCHEMATICS

JPX-300 Installation/Operation Manual 7610-002-71-26 Rev. J Issued: 03-09-2006 Revised: N/A SECTION 4: ELECTRICAL SCHEMATICS 18 JPX-300HN 115 VOLT - 60 HERTZ - SINGLE PHASE

Page 44 - SECTION 5: JACKSON MAINTENANCE & REPAIR CENTERS; ALABAMA TO GEORGIA

ALABAMA: JONES-McLEOD APPLIANCE SVC 1616 7TH AVE. NORTH BIRMINGHAM, AL 35203 (205) 251-0159 800-821-1150 FAX: (205) [email protected] JONES-McLEODAPPLIANCE SVC 854 LAKESIDE DRIVE MOBILE, AL 36693 (251) 666-7278 800-237-9859 FAX: (251) 661-0223 ALASKA: RESTAURANT APPLIANCESERVICE 7219 ...

Page 45 - HAWAII TO MINNESOTA

HAWAII: FOOD EQMT. PARTS & SER-VICE CO. 300 PUUHALE RD. HONOLULU, HI 96819 (808) 847-4871 FAX: (808) [email protected] IDAHO: RESTAURANT APPLIANCESVC. 7219 ROOSEVELT WAY NE SEATTLE, WA 98115 (206) 524-8200 800-433-9390 FAX: (206) [email protected] RON'S SERVICE 703 E 44TH STREET ST...

Page 46 - MISSISSIPPI TO NEW YORK

MISSISSIPPI: GCS SERVICE INC. JACKSON, MS (601) 956-7800 800-274-5954 FAX: (601) 956-1200 GCS SERVICE INC. MEMPHIS, TN (901) 366-4587 800-262-9155 FAX: (901) 366-4588 MISSOURI: GCS SERVICE INC. KANSAS CITY, MO (816) 920-5999 800-229-6477 FAX: (816) 920-7387 GCS SERVICE INC. ST. LOUIS, MO (314) 638-7...

Page 47 - NORTH DAKOTA TO UTAH

NORTH DAKOTA: GCS SERVICE INC. MINNEAPOLIS, MN (612) 546-4221 800-345-4221 FAX: (612) 546-4286 OHIO: CERTIFIED SERVICE CENTER 890 REDNA TERRACE CINCINNATI, OH 45215 (513) 772-6600 800-543-2060 FAX: (513) [email protected] CERTIFIED SERVICE CENTER 171J-K NORTH HAMILTON RD. COLUMBUS, OH...

Page 48 - CANADA; VERMONT TO WYOMING/CANADA

VERMONT: NORTHERN PARTS & SVC. 4874 S. CATHERINE STREETPLATTSBURGH, NY 12901 (518) 563-3200 800-634-5005 FAX: (800) 782-5424 [email protected] GCS SERVICE INC. CHELSEA, MA(617)889-9393 800-225-1155 FAX: (617) 889-1222 VIRGINIA: DAUBERS, INC. 7645 DYNATECH COURTSPINGFIELD, VA 22153 (703) 866...

Jackson JPX-300H - Manual

Table of Contents:

Summary

Other Jackson Models