Page 2 - Revision History; Disclaimers
Intel Server Board SE7501CW2 Installation and Integration Guide Revision History Date Revision Notes Product Code 9/25/03 1 First Draft 10/6/03 2 Second Draft Disclaimers The information contained in this document is provided for informational purposes only and represents the current view of Intel C...
Page 3 - Table of Contents; Installing the Boxed Intel
Intel Server Board SE7501CW2 Installation and Integration Guide Table of Contents Introduction ......................................................................................5 Document Overview ................................................................................ 5 Target Audience ...
Page 4 - Administrator computers
Intel Server Board SE7501CW2 Installation and Integration Guide Making Optional Connections to the Server Board ................................. 17 Installing the Serial B Cable .................................................................. 18 Cable Routing – Intel Server Chassis SC5200 ..........
Page 5 - Introduction; Target Audience; Thank you
Intel Server Board SE7501CW2 Installation and Integration Guide Introduction Document Overview This guide outlines the procedures for integrating an Intel ® Server Platform using an Intel Server Board SE7501CW2 and Intel Xeon processors. This guide consists of the most essential information first-...
Page 6 - Troubleshooting Guide; Minimum Hardware Requirements
Intel Server Board SE7501CW2 Installation and Integration Guide Troubleshooting Guide In the unlikely event you do encounter issues, the troubleshooting guide will help you troubleshoot and identify possible areas of concern regarding the Intel Server Board SE7501CW2. It will also assist you in coll...
Page 7 - Hardware Integration; Prepare for Assembly
Intel Server Board SE7501CW2 Installation and Integration Guide Hardware Integration The following installation procedures enable you to prepare a chassis for integration, add the needed components to your server board, and install the server board. The procedures are condensed from the more compreh...
Page 8 - Important Safety Information; Safety Instructions and Information
Intel Server Board SE7501CW2 Installation and Integration Guide Important Safety Information Safety Instructions and Information To avoid personal injury or property damage, the following safety instructions apply whenever working inside the chassis: 1. Turn off all peripheral devices connected to t...
Page 9 - Chassis Preparation and Server Board Installation; Attaching the Gasket to the I/O Shield; Attaching the Label to the I/O Shield
Intel Server Board SE7501CW2 Installation and Integration Guide Chassis Preparation and Server Board Installation About the I/O Shield An ATX 2.03-compliant I/O shield is provided with your server board. The shield is required by Electromagnetic Interference (EMI) regulations. It minimizes EMI and h...
Page 10 - Installing Chassis Standoffs; Installing the Rubber Bumper
Intel Server Board SE7501CW2 Installation and Integration Guide Installing Chassis Standoffs If your chassis does not have standoffs placed as shown, you must rearrange them so they match the holes in the server board. Failure to properly rearrange the metal standoffs may cause the server board to m...
Page 11 - Installing Memory
Intel Server Board SE7501CW2 Installation and Integration Guide Installing Memory The server board supports only DDR266-compliant DIMMs. The minimum supported memory configuration is 128 MB, using one 128-MB DIMM. The maximum configurable memory size is 8 GB using 4 2-GB DIMMs. If a single DIMM is u...
Page 12 - Choosing the Processor Socket; Opening the Socket Lever
Intel Server Board SE7501CW2 Installation and Integration Guide Installing the Boxed Intel Xeon Processor Choosing the Processor Socket Use these instructions for installing your processor instead of the instructions that came with your boxed processor. • If only ONE processor is to be used, it ...
Page 14 - Installing the Processor Wind Tunnel; Attaching the Heat Sink Fan
Intel Server Board SE7501CW2 Installation and Integration Guide Installing the Processor Wind Tunnel The following instructions apply to the base Intel Server Chassis SC5200 and reference chassis installations. Direct the airflow from the processor wind tunnel toward the rear of the chassis as shown...
Page 15 - Attaching the Wind Tunnel
Intel Server Board SE7501CW2 Installation and Integration Guide Attaching the Wind Tunnel 1. Spread the tabs outward slightly (1a). Lower the wind tunnel assembly onto the retention mechanism (1b). 2. The tabs on the fan assembly (2a) slide into slots (2b) on the inner side of t 3. The tabs on fansu...
Page 16 - Making Required Connections to the Server Board
Intel Server Board SE7501CW2 Installation and Integration Guide Making Required Connections to the Server Board Make these connections regardless of the chassis used. Refer to your chassis documentation r Chassis SC5200 Base or Red to the system fan 3 and 4 Note: then they will run at a faster rate ...
Page 17 - Making Optional Connections to the Server Board
Intel Server Board SE7501CW2 Installation and Integration Guide Making Optional Connections to the Server Board These connections are required only when the corresponding component is installed. A Hot Swap Back Plane (HSBP) B System Fan 5 C Front Universal Serial Bus D Serial B 17
Page 18 - Installing the Serial B Cable
Intel Server Board SE7501CW2 Installation and Integration Guide Installing the Serial B Cable For the Intel Server Chassis SC5200, you can connect the Serial Port B cable to either the back of the chassis or, on a rack-mount system, to the front of the chassis. 1. 2. back pashown. 3. Attach the the ...
Page 19 - Cable Routing – Intel Server Chassis SC5200; Floppy and Front Panel Cables; Installing the Access Cover; IDE or SCSI Cables
Intel Server Board SE7501CW2 Installation and Integration Guide Cable Routing – Intel Server Chassis SC5200 routing guidelines below. sys 1. bles as shown. Floppy and Front Panel Cables Route the floppy drive and front panel cables as shown. Installing the Access Cover 1. Place the cover so the tabs...
Page 20 - Installing the Chassis Feet (Pedestal Mode)
Intel Server Board SE7501CW2 Installation and Integration Guide Installing the Chassis Feet (Pedestal Mode) 1. If you are installing this server into a rack system, skip these steps and go to “Installing into a Rack (Rack kbench. assis. The th only one set of holes in oot, the middle hole should fac...
Page 21 - Finishing Up; WARNING
Intel Server Board SE7501CW2 Installation and Integration Guide Finishing Up WARNING tall the chassis access cover before finishing ver” on page 19). An Ins up (see ”Installing the Access Co electrical shock hazard exists if the chassis access cover is wer. bles as shown. to the back panel and to an...
Page 22 - Software Installation; Updating the BIOS; Installing the Operating System
Intel Server Board SE7501CW2 Installation and Integration Guide Software Installation Updating the BIOS Intel highly recommends that you go to the Intel Server Board SE7501CW2 support Web ite and download and install the latest system BIOS update for your operating system. The Intel Server Board SE7...
Page 23 - LANDesk* Client Manager; ANDesk System Requirements; Installing LANDesk Client Manager
Intel Server Board SE7501CW2 Installation and Integration Guide LANDesk* Client Manager manage a computer and troubleshoot common computer problems. Use Client Manager to: nt computers (single, • Client: The client version enables an end user to view information and manage alerts for a local compute...
Page 24 - Intel Server Maintenance and Reference Training Tool CD
Intel Server Board SE7501CW2 Installation and Integration Guide Intel Server Maintenance and Reference Training Tool CD enance and Reference Training Tool CD (Intel SMaRT Tool) is an providing support information to assist with the maintenance and repair of Intel processor-based server systems and a...
Page 25 - Thank you for purchasing Intel products!
Intel Server Board SE7501CW2 Installation and Integration Guide Thank you for purchasing Intel products! For additional integration resources, please visit www.support.intel.com . 25
