Intel SBC-455 - Manual

Intel SBC-455

Intel SBC-455 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
77 Page 77
78 Page 78
79 Page 79
80 Page 80
81 Page 81
82 Page 82
83 Page 83
84 Page 84
85 Page 85
86 Page 86
87 Page 87
88 Page 88
89 Page 89
90 Page 90
91 Page 91
92 Page 92
93 Page 93
94 Page 94
95 Page 95
96 Page 96
97 Page 97
Page: / 97

Table of Contents:

  • Page 2 – FCC STATEMENT
  • Page 3 – is a registered trademark of Video Electronics Standards
  • Page 4 – Packing list; • 1 6-pin mini-DIN dual outlet adapter for keyboard and PS/2
  • Page 5 – Contents
  • Page 7 – Chpater 4: Flat Panel/CRT Controller Display Drivers and; Windows
  • Page 9 – • Card specifications; CHAPTER
  • Page 10 – Introduction
  • Page 11 – Features; the P24T Pentium OverDrive
  • Page 12 – Specifications; Bus interface: ISA bus
  • Page 14 – Board layout; ST; ALI
  • Page 15 – Card dimensions
  • Page 17 – Installation
  • Page 18 – Label
  • Page 19 – Locating jumpers and connectors
  • Page 20 – Setting jumpers
  • Page 21 – Safety precautions; Removing a CPU; Disconnect power from the chassis, and unplug all connections
  • Page 22 – Installing a CPU; Lubricate the pins on the CPU with lubricant for PGA devices.
  • Page 25 – Installing SIMMs; Note that the modules can only fit into a socket one way.; Removing SIMMs
  • Page 26 – Connecting the hard drive; Connect one end of the cable to the IDE connector. Make sure
  • Page 27 – Pin assignments
  • Page 28 – Connecting the floppy drive; Attach the appropriate connector on the other end of the cable; Pin
  • Page 29 – Installing the retaining bracket; Unscrew the plate that covers the end of the slot.; Strobe
  • Page 30 – DACK3; Power supply connector; GND
  • Page 34 – Serial ports
  • Page 35 – You can select the serial port IRQs by setting JP11 as follows:; COM A
  • Page 36 – Watchdog timer setup; Watchdog timer programming; This will enable the watchdog and set up its time-out interval.
  • Page 37 – Delay time
  • Page 38 – External switches and LEDs
  • Page 39 – Ground; Turbo
  • Page 40 – SMI; Pull low; Clear CMOS
  • Page 43 – AMI WinBIOS Setup; This chapter describes the card’s diagnos-
  • Page 44 – General information; WinBIOS Setup configures system information that is stored in; Starting WinBIOS setup; The WinBIOS setup screen appears as follows:
  • Page 45 – Using a mouse with WinBIOS setup; WinBIOS Setup can be accessed via keyboard, mouse, or pen. The; Using the keyboard with WinBIOS setup; WinBIOS Setup has a built-in keyboard driver that uses simple; Keystroke
  • Page 46 – Setup; Standard Setup; Pri Master, Pri Slave, Sec Master and Sec Slave
  • Page 47 – User
  • Page 48 – Advanced Setup; Select the Advanced icon from the WinBIOS Setup main menu to
  • Page 49 – Setting; D i s a b l e d; Off
  • Page 51 – Wait for F1 if Error:
  • Page 52 – External Cache; System BIOS Cacheable; Enabled; Numeric Processor Test; Enbable; Hard Disk Delay; Disabled
  • Page 53 – Shadow
  • Page 54 – Chipset Setup; The WinBIOS Setup options deccribed in this section are selected; Function; Auto Configuration Function
  • Page 56 – Power Management Setup; Power Management Mode/APM Funtion
  • Page 57 – Plug and Play Aware OS
  • Page 59 – PCI Slot1 IRQ Priority; Auto
  • Page 60 – Reserved Memory Size; This option specifies the size of the memory area reserved for; Reserved Memory Address; memory area. The specified ROM memory area is reserved for use
  • Page 61 – Onboard FDC; Onboard Serial Port 1; Peripheral Setup
  • Page 62 – Onboard Serial Port2; the base I/O port address for serial port 2. The settings are; Onboard Parallel Port; This option enables the parallel port on the motherboard and; Parallel Port Mode; This option specifies the parallel port mode. ECP and Epp are both; N o r m a l; E C P
  • Page 63 – Parallel Port DMA Channel; Parallel Port; Parallel Port IRQ
  • Page 64 – Utility; English
  • Page 65 – Security; Two Levels of Passwords
  • Page 66 – Always
  • Page 67 – Changing a password
  • Page 68 – Default; Original
  • Page 69 – Exiting WinBIOS; You can exit WinBIOS by pressing the key while in the
  • Page 71 – Controller Display Driv-; This chapter provides information about:
  • Page 72 – S o f t w a r e d r i v e r s; H a r d w a r e c o n f i g u r a t i o n; Change the display controller to CRT-only mode, rather than flat
  • Page 73 – N e c e s s a r y p r e r e q u i s i t e s; • Know how to copy files from a floppy disk to a directory on the hard; Before you begin
  • Page 74 – Driver installation
  • Page 75 – D r i v e r i n s t a l l a t i o n - W i n d o w s S e t u p; Install Windows as you normally would for a VGA display. Run; C h a n g i n g D i s p l a y D r i v e r s f r o m W i n d o w s
  • Page 76 – C h a n g i n g C o l o r S c h e m e s; DOS; D r i v e r i n s t a l l a t i o n - D O S S e t u p; SETUP
  • Page 77 – Follow the directions on the screen to complete the setup. In; Changing Display Drivers from DOS; VGA; P a n n i n g D r i v e r s; To install the drivers, follow these instructions:
  • Page 79 – D r i v e r d i s k e t t e c o p y; Copy all files on the OS/2 Display Driver Diskette as you
  • Page 80 – NT Display Driver Diskette in drive A.
  • Page 81 – Install Windows NT4.0 as you normally would for a VGA; Driver Installation
  • Page 82 – SOFTWARE UTILITIES; The CHIPSDSP utility; I n s t a l l i n g t h e u t i l i t y
  • Page 83 – • Interlaced; The refresh rate is available in CRT Mode only.; Note: 1. The refresh rates that are supported by the selected mon-; WINDOWS; refresh rate setting for the selected monitor in Windows
  • Page 85 – • CRT only
  • Page 87 – APPENDIX
  • Page 91 – Modules
  • Page 92 – Installing PC/104 modules
  • Page 93 – PC/104 Module Mounting Diagram
  • Page 95 – LCD Display BIOS
  • Page 96 – Usage; Configuring various LCD display; Follow the instructions below to modify the VGA BIOS:; Note : Before you execute the AAFLASH.COM utility; The VGA Tool Diskette allows OEMs to prepare the 65548
Loading the manual

SBC-455

Half-size 486 CPU Card with

Flat Panel/CRT SVGA Interface

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - FCC STATEMENT

FCC STATEMENT THIS DEVICE COMPLIES WITH PART 15 FCC RULES.OPERATION IS SUBJECT TO THE FOLLOWING TWOCONDITIONS: (1) THIS DEVICE MAY NOT CAUSEHARMFUL INTERFERENCE. (2) THIS DEVICE MUSTACCEPT ANY INTERFERENCE RECEIVED INCLUDINGINTERFERENCE THAT MAY CAUSE UNDESIRED OPER-ATION. THIS EQUIPMENT HAS BEEN TE...

Page 3 - is a registered trademark of Video Electronics Standards

Copyright Notice This document is copyrighted, 1995, 1996, by AAEON Technol-ogy Inc. All rights are reserved. AAEON Technology Inc. reservesthe right to make improvements to the products described in thismanual at any time without notice. No part of this manual may be reproduced, copied, translated ...

Page 4 - Packing list; • 1 6-pin mini-DIN dual outlet adapter for keyboard and PS/2

Packing list Before you begin installing your card, please make sure that thefollowing materials have been shipped: • 1 SBC-455 CPU card • 1 6-pin mini-DIN dual outlet adapter for keyboard and PS/2 mouse • 1 Hard disk drive (IDE) interface cable (40 pin) • 1 Floppy disk drive interface cable (34 pin...

Other Intel Models

All Intel Other