Page 2 - Copyright Notice; st Edition
MIC-3321 User Manual ii Copyright Notice This document is copyrighted, 2004. All rights are reserved. The original manufacturer reserves the right to make improvements to the products described in this manual at any time without notice.No part of this manual may be reproduced, copied, translated or ...
Page 3 - Product Warranty; product, and any helpful information readily available.; CE Notification
iii Product Warranty Advantech warrants to you, the original purchaser, that each of its products will be free from defects in materials and workmanship for two years from the date of purchase.This warranty does not apply to any products which have been repaired or altered by persons other than repa...
Page 4 - Technical Support and Assistance; Step 1. Visit the Advantech web site at; Packing List
MIC-3321 User Manual iv Technical Support and Assistance Step 1. Visit the Advantech web site at www.advantech.com/support where you can find the latest information about the product. Step 2. Contact your distributor, sales representative, or Advantech's cus- tomer service center for technical suppo...
Page 5 - Contents; Chapter
v Table of Contents Contents Chapter 1 Hardware Configuration ................................ 2 1.1 Introduction ....................................................................... 2 1.2 Specifications .................................................................... 3 1.2.1 Standard SBC Fun...
Page 8 - Chapter 1 Hardware Configuration; Compact Mechanical Design; soldered DDR2 SDRAM, 4HP width
MIC-3321 User Manual 2 Chapter 1 Hardware Configuration 1.1 Introduction MIC-3321 is a 3U, all-in-one, controller board, compliant with PICMG 2.0 R2.1 CompactPCI specifications. For high computing performance, MIC-3321 uses an Intel Pentium M 760 2.0GHz CPU and Intel 915GM chipset. This CPU provides...
Page 9 - CompactPCI Compliance:
3 Chapter 1 1.2 Specifications 1.2.1 Standard SBC Functions • CPU: MIC-3321 supports Intel Pentium M 2.0 GHz • Optional: Celeron M 1.0GHz/ Celeron M 800MHz (non cache) • BIOS: Award 4 Mb flash memory • Chipset: Intel 915GM Graphics and Memory Controller Hub (GMCH) Intel 82801FBM I/O Controller Hub (...
Page 10 - Intel Graphics Media Accelerator 900; Mechanical and Environmental Specifications; Operating Temperature:; Function Block Diagram
MIC-3321 User Manual 4 1.2.2 Display • Controller: Intel Graphics Media Accelerator 900 • VRAM: DVMT3.0 128MB • Resolution: Up to 2048x1536 with 32-bit color at 75Hz 1.2.3 Mechanical and Environmental Specifications • Board Size (W x H) : 160 x 100 mm (3U) • Operating Temperature: 0 ~ 50° C (MIC-332...
Page 11 - Board Dimensions
5 Chapter 1 1.4 Board Dimensions Figure 1.2: MIC-3321 Board Dimensions 1.5 Dip Switch Settings Since MIC-3321 is composed of one main board and one daughter board, for ease of understanding and a convenient naming, we will use 1F (1st level) to represent the main board, and 2F (2nd level) to represe...
Page 13 - Safety Precautions
7 Chapter 1 Figure 1.4: MIC-3321 S2 Location (2F) 1.6 Safety Precautions Follow these simple precautions to protect yourself and the products.1. To avoid electrical shock, always disconnect the power from your PC chassis before you work on it. Don't touch any components on the CPU card or other card...
Page 16 - Chapter 2 Connecting Peripherals
MIC-3321 User Manual 10 Chapter 2 Connecting Peripherals 2.1 Connectors Figure 2.1 and 2.2 show MIC-3321 connector locations. Figure 2.3 shows MIC-3521 connector location. Figure 2.1: MIC-3321 Connector Locations (1F) Figure 2.2: MIC-3321 Connector Locations (2F)
Page 19 - Card Installation; Lift the lower handle up to push the card into place.
13 Chapter 2 2.2 Card Installation The CompactPCI connectors are firm and rigid, but require careful han-dling while plugging and unplugging. Improper installation of a card can easily damage the backplane of the chassis.The inject/eject handle of MIC-3321 helps you install and remove the card easil...
Page 21 - Software Configuration
Page 22 - Chapter 3 Software Configuration; Utilities and Drivers; Intel Chipset Software Installation Utility
MIC-3321 User Manual 16 Chapter 3 Software Configuration 3.1 Overview MIC-3321 has a CD-ROM with utilities and drivers. Please install the Chipset INF driver, VGA graphics driver, and LAN driver. 3.2 Utilities and Drivers The following utilities and drivers are provided with the MIC-3321 series. You...
Page 23 - Award BIOS Setup
Page 24 - Chapter 4 Award BIOS Setup
MIC-3321 User Manual 18 Chapter 4 Award BIOS Setup 4.1 Introduction Once you enter the Award BIOS CMOS Setup Utility, the Main Menu (Figure 4-1) will appear on the screen. The Main Menu allows you to select between nine setup functions and two exit choices. Use the arrow keys to select among the ite...
Page 25 - Date; Press “Enter” to select this option for automatic device detection.; None; : Select this when no IDE device is used. The system will skip the
19 Chapter 4 4.2.1 Standard CMOS Setup Figure 4.2: Standard CMOS Setup Screen. Date The date format is <week>, <month>, <day>, <year>. Time The time format is <hour> <minute> <second>, based on the 24-hour clock. IDE Primary Master/ Secondary Master/ Seconda...
Page 26 - Figure 4.3: Advanced BIOS features setup screen
MIC-3321 User Manual 20 Halt On This category determines whether system start-up will halt when an error is detected during power up.The options are: No Errors/All Errors/All, But Keyboard/All, But Dis-kette/ All, But Disk/Key Memory This category displays base, extended, and total memory detected d...
Page 27 - Hard Disk Boot Priority; Set hard disk boot device priority.; CPU Thermal Monitor; : When Intel Thermal Monitor 1 is enabled, and a high temperature; Virus Warning
21 Chapter 4 Hard Disk Boot Priority Set hard disk boot device priority. CPU Thermal Monitor The Intel Thermal MonitorAutomatic Mode. There are two Automatic modes called Intel Thermal Monitor 1 (TM1) and Intel Thermal Monitor 2 (TM2). And MIC-3321 Auto dete C-M or P-M.When CPU was C-M BIOS running ...
Page 28 - Second boot device; Boot Up NumLock Status
MIC-3321 User Manual 22 CPU L1 & L2 Cache Enabled (default) Enable cacheDisabled Disable cacheNote: The internal cache is built into the processor. Quick Power On Self Test This category speeds up Power On Self Test (POST) after you power on the computer. If this is set to Enabled, BIOS will sho...
Page 29 - Typematic Rate Setting
23 Chapter 4 Typematic Rate Setting Keystrokes repeat at a rate determined by the keyboard controller. When enabled, the typematic rate and typematic delay can be selected. The set-tings are: Enabled/Disabled. The default setting is Disabled. Typematic Rate (Chars/Sec) Set the number of times a seco...
Page 30 - Figure 4.4: Advanced Chipset Features setup screen; DRAM Timing Configuration
MIC-3321 User Manual 24 4.2.3 Advanced Chipset Features Setup The Advanced Chipset Features Setup option is used to change the values of the chipset registers. These registers control most of the system options in the computer. Choose the "Advanced Chipset Features" from the main menu and th...
Page 31 - System Memory Frequency
25 Chapter 4 DRAM RAS# to CAS# Delay This field is used to insert a timing delay between the CAS and RAS strobe signals, used when DRAM is written to, read from, or refreshed. Fast gives faster performance; and Slow gives more stable performance.This field applies only when synchronous DRAM have bee...
Page 33 - IDE HDD Block Mode
27 Chapter 4 IDE HDD Block Mode Block mode is also called block transfer, multiple commands, or multiple sector read/write. If your IDE hard drive supports block mode (most new drives do), select Enabled for automatic detection of the optimal number of block read/writes per sector the drive can supp...
Page 35 - Init Display Fiest
29 Chapter 4 4.2.5 PNP/PCI Configuration Setup This section describes configuring the PCI bus system. PCI, or Personal Computer Interconnect, is a system that allows I/O devices to operate at speeds nearing the speed the CPU itself uses when communicating with its own special components. This sectio...
Page 37 - Figure 4.7: PC Health Status setup screen; CPU Warning Temperature
31 Chapter 4 Figure 4.7: PC Health Status setup screen CPU Warning Temperature This item will prevent the CPU from overheating. The choices are “Dis-abled”, “50C/122F”, “53C/127F”, “56C/133F”, “60C/140F”, “63C/145F”, “66C/151F”, “70C/158F”, “75C/167F”, “80C/176F”, “85C/185F”, “90C/194F”, and “95C/20...
Page 38 - Figure 4.8: PC Health Status setup screen; Spread Spectrum
MIC-3321 User Manual 32 4.2.7 Spread Spectrum Control Figure 4.8: PC Health Status setup screen Spread Spectrum This allows the enable spread spectrum function. Default is "Dis-abled." 4.2.8 Load Optimized Defaults When you press <Enter> on this item, you get a confirmation dialog box ...
Page 41 - APPENDIX
Page 42 - Appendix A Watchdog Timer Programming; Data Time Interval
MIC-3321 User Manual 36 Appendix A Watchdog Timer Programming To program the watchdog timer, you must write a program which writes a value to I/O port address 443 (hex). This output value represents time interval. The value range is from 01 (hex) to FF (hex), and the related time interval is 0.25 se...
Page 43 - Pin Assignment
Page 44 - Appendix B Pin Assignment; Number
MIC-3321 User Manual 38 Appendix B Pin Assignment This chapter shows the pin assignments of MIC-3321 series CPU cards. Table B.1: MIC-3321 Connectors Overview Number Function Description 1F-CN1 USB1 USB1 Type-A Female on Front side panel. 1F-CN3 USB2 USB2 Type-A Female on Front side panel. 1F-CN2 CF...
Page 45 - B.1 CompactFlash Interface; The socket accepts an IDE-compatible CompactFlash memory card.
39 Appendix B B.1 CompactFlash Interface The socket accepts an IDE-compatible CompactFlash memory card. *LOW ACTIVE Table B.2: CompactFlash Interface Pin Definitions Pin Signal Pin Signal 1 GND 26 N/C 2 PDD3 27 PDD11 3 PDD4 28 PDD 12 4 PDD5 29 PDD 13 5 PDD6 30 PDD 14 6 PDD7 31 PDD 15 7 PDCS* 32 PDCS...
Page 47 - PS/2 keyboard and mouse port pin definitions
41 Appendix B B.4 COM port B.5 PS/2 Keyboard and Mouse Connector PS/2 keyboard and mouse port pin definitions Table B.4: COM Port Pin Definitions PIN RS-232 1 NDCD 2 NRX 3 NTX 4 NDTR 5 GND 6 NDSR 7 NRTS 8 NCTS 9 NRI Table B.5: PS/2 Keyboard & Mouse Port Pins Pin Signal 1 KB DATA 2 MS DATA 3 GND ...
Page 49 - Pin
43 Appendix B *LOW ACTIVE Table B.7: Secondary IDE Connectors (2.5" HDD) Pin Signal Pin Signal 1 IDERST* 2 GND 3 SDD7 4 SDD8 5 SDD6 6 SDD9 7 SDD5 8 SDD10 9 SDD4 10 SDD11 11 SDD3 12 SDD12 13 SDD2 14 SDD13 15 SDD1 16 SDD14 17 SDD0 18 SDD15 19 GND 20 N/C 21 SDDREQ 22 GND 23 SDIOW* 24 GND 25 SDIOR* ...
