Intel 325152002US - Manual
Intel 325152002US – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Ordering Information
- Page 3 – Contents
- Page 5 – Overview; Drive 320 Series (Intel
- Page 6 – Product Specifications; Capacity; User Addressable Sectors
- Page 7 – Electrical Characteristics; Operating Voltage and Power Consumption
- Page 8 – Product Regulatory Compliance; in; Product Regulatory Compliance Specifications
- Page 9 – Reliability; requirements as specified in the JESD218 specification.; Hot Plug Support; system without hardware device detection.; Reliability Specifications
- Page 10 – Mechanical Information; Figure 1
- Page 11 – Figure 2
- Page 12 – Figure 3
- Page 13 – Pin and Signal Descriptions; Pin Locations; Layout of Signal and Power Segment Pins; Signal Segment S1
- Page 14 – Signal Descriptions; Connector Pin Signal Definitions; Serial ATA Connector Pin Signal Definitions —
- Page 15 – Serial ATA Power Pin Definitions — 2.5-inch Form Factor
- Page 16 – Supported Command Sets; ATA General Feature Command Set; Power Management Command Set
- Page 17 – Security Mode Feature Set
- Page 18 – corresponding status flags and threshold settings.; SMART Attributes
- Page 19 – defines the SMART Attribute status flags.; SMART Attribute Status Flags
- Page 20 – SMART Logs; appropriate commands.; Device Statistics; Device Statistics log as defined in the ATA specification.; Device Statistics Log
- Page 21 – manipulate two SMART Logs:; Data Set Management Command Set; • DATA SET MANAGEMENT; Host Protected Area Command Set
- Page 22 – 8-Bit Address Command Set; Software Settings Preservation; preservation of software settings.
- Page 23 – Certifications and Declarations; Device Certifications and Declarations; Standards References
- Page 24 – Terms and Acronyms; defines the terms and acronyms used in this document.; Glossary of Terms and Acronyms
- Page 25 – Revision History
- Page 26 – Appendix A IDENTIFY DEVICE Command Data; Returned Sector Data
Order Number: 325152-002US
September 2011
Intel
®
Solid-State Drive 320 Series
Product Specification
1. Performance values vary by capacity.
2. 4 KB = 4,096 bytes.
3. Idle power measured with Device Initiated Power Management (DIPM) enabled.
Form Factors: 1.8-inch and 2.5-inch
Capacity:
— 80/160/300 GB (1.8-inch)
— 40/80/120/160/300/600 GB (2.5-inch)
Components:
— Intel
®
25nm NAND Flash Memory
— Multi-Level Cell (MLC)
Bandwidth Performance
1
(Iometer* Queue Depth 32)
— Sustained Sequential Read: Up to 270 MB/s
— Sustained Sequential Write: Up to 220 MB/s
Read and Write IOPS
1
(Iometer Queue Depth 32)
— Random 4 KB
2
Reads: Up to 39,500 IOPS
— Random 4 KB Writes: Up to 23,000 IOPS
Latency (average sequential)
— Read: 75 µs (TYP)
— Write: 90 µs (TYP)
AES 128-bit Encryption
Compatibility
— Intel
®
SSD Toolbox with Intel
®
SSD Optimizer
— Intel
®
Data Migration Software
— Intel
®
Rapid Storage Technology
— Intel
®
6 Series Express Chipsets
(with SATA 6Gb/s)
— SATA Revision 2.6
— ATA8-ACS
— SSD-enhanced SMART ATA feature set
— Native Command Queuing (NCQ)
command set
— Data Set Management Command
Trim attribute
Power Management
— 3.3 V (1.8-inch form factor) or
5 V (2.5-inch form factor) SATA Supply Rail
— SATA Interface Power Management
— OS-aware hot plug/removal
— Enhanced power-loss data protection
Power
— Active (MobileMark* 2007 Workload):
150 mW (TYP)
— Idle
3
: 100 mW (TYP)
Temperature
— Operating: 0
o
C to 70
o
C
— Non-Operating: -55
o
C to 95
o
C
Reliability
— Uncorrectable Bit Error Rate (UBER):
1 sector per 10
16
bits read
— Mean Time Between Failures (MTBF):
1,200,000 hours
Shock (operating and non-operating):
1,500 G/0.5 msec
Vibration
— Operating: 2.17 G
RMS
(5-700 Hz)
— Non-operating: 3.13 G
RMS
(5-800 Hz)
Weight
— 1.8-inch form factor: Up to 49
grams
— 2.5-inch 7mm form factor: Up to 82
grams
— 2.5-inch 9.5mm form factor: Up to 88 grams
Certifications and Declarations:
— UL*
— CE*
— C-Tick*
— BSMI*
— KCC*
— Microsoft* WHQL
— VCCI*
— SATA-IO*
Product Ecological Compliance
— RoHS*
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Intel ® Solid-State Drive 320 Series Product Specification September 2011 2 Order Number: 325152-002US L Ordering Information Contact your local Intel sales representative for ordering information. INFORMATION IN THIS DOCUMENT IS PROVIDED IN CONNECTION WITH INTEL PRODUCTS. NO LICENSE, EXPRESS OR IMP...
Intel ® Solid-State Drive 320 Series September 2011 Product Specification Order Number: 325152-002US 3 Intel ® Solid-State Drive 320 Series Contents 1.0 Overview ................................................................................................................... 5 2.0 Product Specific...
Intel ® Solid-State Drive 320 Series September 2011 Product Specification Order Number: 325152-002US 5 Intel ® Solid-State Drive 320 Series 1.0 Overview This document describes the specifications and capabilities of the Intel ® Solid-State Drive 320 Series (Intel ® SSD 320 Series). The Intel SSD 320...
