INSTEON 2444A2WH8 - Manual

2444A2xx8 Rev. 7/16/2012 12:31 PM / See Owner’s Manual for Warranty Information, Patented

© Copyright 2012, INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845

Power

Switch

(Left=Off,

Right=On)

Status LED

Set button

Micro-USB

Charging

Jack

Quick Start Guide

RemoteLinc

™

2 - INSTEON

®

Wireless Keypad

Model: 2444A2WH8

Introduction

Conveniently control your home’s INSTEON network with the compact and

versatile RemoteLinc 2 wireless keypad controller.

What's Included

•

RemoteLinc 2

Getting Started

Fully charge RemoteLinc 2 prior to programming (or anytime the unit is not

responding) using a Type A to Micro-B USB cable (sold separately). The

red Charging LED will turn off once the battery is fully charged

(approximately one hour). Slide the power switch to the ON position.

Note: RemoteLinc 2 requires an INSTEON dual-band or RF device to

communicate with other devices on your INSTEON network.

RemoteLinc 2 uses a subtle beeper sound to assist setup. It is

recommended that you program the unit in a quiet area.

Using RemoteLinc 2

Each scene button (a-h) controls its own scene, sending commands to devices linked specifically to that button.

Dimmable responders may behave differently, depending on whether you tap, double-tap or press and hold a

button. Non-dimming responders will only turn full-on or full-off, no matter what method you use.

Last Command Sent

Tap

Press and hold

Double-tap

Off or Dim

Turn scene on

Brighten scene members until

released

Turn scene members full-on

instantly

On or Bright

Turn scene off Dim scene members until released

Turn scene members full-off

instantly

The RemoteLinc 2 Status LED will flash green once for each on/brighten command sent and red once for each

off/dim command sent

Warning:

RemoteLinc 2 is permanently sealed. Do not attempt to open case. Doing so will damage the remote

and void the warranty.

Add RemoteLinc 2 (Button) as an INSTEON Controller

1) Tap the scene button of choice on the RemoteLinc 2
2) Adjust the responder to the state you want when the scene is activated from RemoteLinc 2

1

3) Press and hold RemoteLinc 2's Set button until RemoteLinc 2 beeps

RemoteLinc 2 status LED will begin blinking green

4) Press and hold the responder’s Set button until the responder beeps or its LED flashes

RemoteLinc 2 will double-beep and its LED will stop blinking
Responder LED will stop blinking (it may also double-beep)

5) Confirm that scene addition was successful by tapping the programmed scene button on RemoteLinc 2

The responder will toggle between the scene’s preset on-level and off

1

If the responder is a multi-scene device such as a KeypadLinc, tap the scene button you wish to control until its LED is in the desired state (on or off)

8 Scene Buttons

(Tap=On/Off;

Press and

hold=dim/brighten)

Charging LED

(inside case)

Owner’s Manual and Tech Support

Owner’s Manual and current Quick Start Guide:

http://www.insteon.com/support

Call: INSTEON Support Line at 800-762-7845