InFocus IN5542 - Manual
InFocus IN5542 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Initial set signals; POSITION in the IMAGE menu.; Data
- Page 3 – MONITOR OUT; At RGB signal; COMPONENT VIDEO
- Page 5 – HDMI
- Page 6 – PJLink command; This projector is equipped with PJLink; protocol
- Page 7 – NOTE
- Page 8 – RS-232C Communication; Connecting the cable
- Page 9 – • Commands are not accepted during warm-up.
- Page 10 – Communication Port; The following two ports are assigned for command control.; Command Control Settings; Port Settings; and
- Page 11 – Command Format; Requesting projector status (Get command)
- Page 12 – Decreasing the projector setting value (Decrement command); ‘xxxxH’; When authentication error occurred.; is sent
- Page 13 – ‘xxH’; Automatic Connection Break; • During the transmission of the second or subsequent commands, the
- Page 14 – Communications setting; (3) Get the number of connected projectors; Protocol; Data chart; Daisy Chain Communication; Transmitting side
- Page 15 – Calculation of Checksum; Header; Group and ID Settings; identification and ID.; note
- Page 16 – Command data; Controlling projector
- Page 17 – Error Code
- Page 18 – Get the number of connected projectors; (1) Send the following request code from the PC to the projector.; Set the communication Group identification and; (1) Send the following setting code from the PC to the projector.
- Page 19 – Get the communication Group identification and; • During transmission of the second or subsequent commands, the
- Page 20 – RS-232C Communication / Network command table
1
Projector
IN5542/IN5542c/IN5544/IN5544c
User's Manual (Technical)
Resolution (H x V) H. frequency (kHz) V. frequency (Hz)
Rating
Signal mode
720 x 400
37.9
85.0
VESA
TEXT
640 x 480
31.5
59.9
VESA
VGA (60Hz)
640 x 480
37.9
72.8
VESA
VGA (72Hz)
640 x 480
37.5
75.0
VESA
VGA (75Hz)
640 x 480
43.3
85.0
VESA
VGA (85Hz)
800 x 600
35.2
56.3
VESA
SVGA (56Hz)
800 x 600
37.9
60.3
VESA
SVGA (60Hz)
800 x 600
48.1
72.2
VESA
SVGA (72Hz)
800 x 600
46.9
75.0
VESA
SVGA (75Hz)
800 x 600
53.7
85.1
VESA
SVGA (85Hz)
832 x 624
49.7
74.5
Mac 16” mode
1024 x 768
48.4
60.0
VESA
XGA (60Hz)
1024 x 768
56.5
70.1
VESA
XGA (70Hz)
1024 x 768
60.0
75.0
VESA
XGA (75Hz)
1024 x 768
68.7
85.0
VESA
XGA (85Hz)
1152 x 864
67.5
75.0
VESA
1152 x 864 (75Hz)
1280 x 960
60.0
60.0
VESA
1280 x 960 (60Hz)
1280 x 1024
64.0
60.0
VESA
SXGA (60Hz)
1280 x 1024
80.0
75.0
VESA
SXGA (75Hz)
*1280 x 1024
91.2
85.0
VESA
SXGA (85Hz)
*1600 x 1200
75.0
60.0
VESA
UXGA (60Hz)
1280 x 768
47.7
60.0
VESA
W-XGA (60Hz)
1400 x 1050
65.3
60.0
VESA
SXGA+ (60Hz)
1280 x800
49.7
60.0
VESA
1280 x 800 (60Hz)
NOTE
• Be sure to check the port type, signal level, timing and resolution
of the computer before connecting this projector to it.
• Some computers may have multiple display screen modes. Some of these
modes may not be supported by this projector.
• Depending on the input signal, full-size display may not be supported in some
cases. Refer to the number of display pixels above.
• Although the projector can display signals with resolutions up to UXGA
(1600x1200), the signal will be converted to the projector’s native resolution
before being displayed. The best display performance will be achieved if the
input signal and native projector resolutions are identical.
• Automatic adjustment may not function correctly with some input signals.
•
The image may not be displayed correctly when the input sync signal is a
composite sync or a sync on G.
• The HDMI input does not support signals marked with an "*".
Computer signal examples
009-1417-00
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Initial set signals Initial set signals The following signals are used for initial settings. The signal timing for some computer models may be different. In this case, adjust the V POSITION and H POSITION in the IMAGE menu. Back porch (B) Front porch (D) Back porch (b) Front porch (d) Display time...
3 Connection to the ports A COMPUTER IN1, B COMPUTER IN2, C MONITOR OUT D-sub 15pin mini shrink port • Video signal: RGB separate, Analog, 0.7Vp-p, 75Ω terminated (positive) • H/V. sync. signal: TTL level (positive/negative) • Composite sync. signal: TTL level At RGB signal Pin Signal Pin Signal 1 V...
5 I O HDMI DVI-D CONTROL IN CONTROL OUT REMOTE CONTROLIN OUT S-VIDEO COMPUTER IN2 COMPUTER IN1 VIDEO 1 BNC R/Cr/Pr G/Y B/Cb/Pb H V VIDEO 2 Y Cb/Pb Cr/Pr AC IN LAN MONITOR OUT Connection to the ports (continued) Q P O O HDMI • Type :Digital video connector Pin Signal Pin Signal Pin Signal 1 T.M.D.S. ...
