Husqvarna PG530 - Manual

English - 7 What is what 1. Hour counter 2. Electrical cabinet 3. Planetary head motor 1.5kW/1Hp 4. Grinding/Satellite heads motor 3kW/4Hp 5. Lifting lugs 6. Cover/Shroud 7. Skirt 8. Chassis/Frame 9. Handle bars 10. Control Panel 11. Handle bar adjuster What is what 2. 1. 3. 4. 5. 6. 7. 11. 10. 9. 8...

English - 11 Changing the diamonds As different applications require different selections of diamond tools, there will be many occasions when the grinding discs need to be changed. Following is a guide for this procedure. Preparation 1. Ensure STOP/RUN switch is in STOP position and the power-plug d...

12 - English Variable speed drives/frequency converters Each Husqvarna PG 530 is equipped with 1 variable speed drive or frequency converter. This unit is incor-porated into the machine for the following reasons: 1. Functional Manipulate incoming power to enable increase/decrease in speed & dire...

English - 15 Faults and trouble shooting When either one of the variable speed drives or frequency converters in the machine experience a fault and “trip” out, they will cease to run and an error message will appear fl ashing on the keypad display (see picture below). The following list are the most...

English - 17 Diamonds Background Diamond abrasives usually consist of 2 components: 1. Diamond powder (also known as diamond crystals or grit). By changing the size of the diamond powder or grit, we can change how coarse or fi ne the scratches will be that are left behind from the grinding process. ...

18 - English Diamond selection The following section covers important factors to consider when selecting the diamond segment you are going to use for a given application. Grinding disc set-up They way diamond segments are set-up on the grind-ing heads of the machine will also greatly infl uence the ...

22 - English Maintenance Used correctly, the machine is an extremely low-maintenance and reliable. This section covers the general maintenance items that need attention on a periodic basis. There are three main mechanical items to check: 1. Grinding Heads. 2. Planetary drive system. 3. Planetary sea...

English - 25 Maintenance schedule Item Action Frequency Check that head lock are tight. Tighten head locks and re-set in thread-locking com-pound if required (Suggested thread-locking compound Loctite 680) Daily Inspect heads for slop/ broken “fi ngers” if using spring steel heads. Examine machine h...

26 - English Technical Data PG 530 Grinding width 530mm (21") Grinding disc 3x240mm (9.5") Weight 200kg (440lbs) Grinding pressure total 134kg (295lbs) Grinding pressure per disc 44.7kg (98lbs) Motor Power 3.75kW (5.0hp) Power per grinding disc 1.25kW (1.7hp) Grinding disc speed 200 - 710rpm...

English - 27 Technical Data EC-declaration of conformity (Applies to Europe only) Husqvarna Construction Products, SE-433 81 Göteborg, Sweden, tel: +46-31-949000, declares under sole responsibil-ity that the Husqvarna PG530 dating from 2007 serial numbers and onwards (the year is clearly stated on t...