Page 3 - REGISTER THE PRODUCT; SAFETY HAZARDS; CAUTION; SAFETY DEFINITIONS
3 REGISTER THE PRODUCT Please register your new Power Pack with Husqvarna Construction Products by mailing in the registration card that came with the machine or you can register on the internet site www.husqvarnawarranty.com Registration will allow us to contact in case of any critical updates or r...
Page 4 - CONTENTS; Content; Lifting Eyelet; LIFTING AND LOADING
CONTENTS Content Page I ntroduction, personal safety ...................... 2 Registration of the product ………………… 3General safety message............................. 3 Table of contents ………………………….. 4What is what? ............................................ 5 Decals ..................................
Page 5 - WHAT IS WHAT
WHAT IS WHAT B A C F D E G K P M N H O L Q S T U J R V W What is what? More information on page A. Lifting eyelet................................................ 4 B. Rack for hydraulic hosesC. Fuel gauge/fuel cap.................................... 8 D. Choke lever E Lock for handle F. Transport ha...
Page 6 - DECALS AND LOCATIONS
6 DECALS AND LOCATIONS HYDRAULIC OIL ISO-46 HYDRAULIC OIL ISO-46 Part number:542 16 90-65 Part number:541 20 76-21 Part number:541 20 76-22 Part number:501 98 70-01 Part number:510 19 10-01 Part number:510 19 09-01 Part number:510 19 09-02 Part number:510 19 08-01 Part number:510 04 40-01
Page 7 - WHAT TOOLS CAN BE POWERED; HYDRAULIC HOSES AND COUPLERS
7 WHAT TOOLS CAN BE POWERED The PP 418 power pack is equipped with an adjustable fl ow hydraulic pump which produces hydraulic power more effi ciently than a more commonly used fi xed displacement gear pump. The PP 418 power pack is suited to power any hydraulic tool with the following specifi catio...
Page 8 - OIL HANDLING; WARNING; NOTICE; ENGINE OIL; HYDRAULIC OIL
8 FUEL HANDLING PROPER FUEL Taking the following precautions will lessen the risk of injury and property damage: - Use extreme care in handling gasoline. It is extremely fl ammable and the vapors are explosive.- Extinguish all cigarettes, cigars, pipes, and other sources of ignition.- Use only appro...
Page 9 - ASSEMBLY
9 ASSEMBLY NOTICE The PP 418 power pack must be serviced before use. In some markets the power pack will be delivered fi lled with both engine oil and hydraulic oil. Remove the power pack from its shipping material and place it on a level surface. Step 1 Check the engine oil level. If no oil is pres...
Page 10 - SERVICING THE BATTERY
10 SERVICING THE BATTERY Use the following procedure when removing, installing and attaching the battery cables. The battery is located in the support foot of the power pack. To access the battery you will need another person helping you. Step 1 Remove the two M8 bolts using a 10 mm wrench. Keep the...
Page 12 - STARTING CHECKLIST
12 STARTING CHECKLIST BEFORE YOU OPERATE THE POWER PACK, PLEASE REVIEW THE FOLLOWING CHECKLIST: - Have you read and do you understand ALL instructions and warnings in this manual? - Is the battery properly charged and installed? (page 10) - Are the tires properly infl ated? (page 9) - Is the engine ...
Page 13 - ADJUSTING THE AUTOMATIC THROTTLE
13 ADJUSTING THE AUTOMATIC THROTTLE GENERAL DESCRIPTION The AUTOMATIC THROTTLE function is triggered by an adjustable pressure switch located on the hydraulic manifold. When the fl ow selector is set to (for example) 40 liters (10 gal), that amount of oil will circulate through the hoses and through...
Page 14 - Engine Oil; Checking, Adding and Changing Oil; Changing the Oil and Filter; ENGINE MAINTENANCE; Oil Pressure
14 Engine Oil Checking, Adding and Changing Oil Always check the oil level before starting the engine.Keep oil level at FULL. Do not overfi ll. Check level daily, or after every eight (8) hours of use. Note: Engine holds approximately 1.4 liters (1.5 quart) when changing oil and oil fi lter. Always ...
Page 15 - HYDRAULIC MAINTENANCE
HYDRAULIC MAINTENANCE SYSTEM MAINTENANCEDaily 1. Check hydraulic oil level. Make sure that the oil level on the sight glass is above the lower limit indicated. Add oil as needed. HYDRAULIC SYSTEM SPECIFICATIONS Oil Tank volume: 10 liter (2.6 gal) Oil Type: ISO 46 (see page 8) Hydraulic Filter (large...
Page 16 - TECHNICAL SPECIFICATIONS
16 TECHNICAL SPECIFICATIONS Weight and Dimensions PP 418 Weight – dry without hoses 127 kg 280 lbs Weight with oil but without gasoline 135 kg 298 lbs Weight - hose set ½” x 7.5 m (25 feet) – dry 8.5 kg 19 lbs Weight - hose set – with oil 10 kg 22 lbs Length (handle folded in) 895 mm 35 inch Length ...
Page 17 - WARRANTY; HUSQVARNA EQUIPMENT WARRANTY
17 WARRANTY HUSQVARNA EQUIPMENT WARRANTY New Hydraulic Power Packs sold by Husqvarna Construction Products are warranted to be free from manufactur-ing defects in normal service for a period of one (1) year from date of purchase by the original consumer purchas-er. Please see the enclosed warranty r...
Page 18 - CONFORMITY CERTIFICATES
18 CONFORMITY CERTIFICATES CALIFORNIA AIR RESOURCES BOARD (CARB): This machine is considered a preempt Off-Road Ap plication as relating to CARB standards. Under construction equipment, and in particular, as a Hydraulic Power Pack (Power pack: hydraulic), with engine power less than 19KW (25hp), CAR...