Husqvarna 232L - Manual

English – 7 SAFETY INSTRUCTIONS 6. Cutting equipment The section describes how through correct maintenance andthrough using the right type of cutting equipment you can:• Obtain maximum clearing capacity.• Increase the service life of the cutting equipment. Two basic rules: 1)Only use the cutting and...

8 – English SAFETY INSTRUCTIONS General safety instructions Transport and storage • Store and transport the machine and fuel so that any leakage or fumes do not risk coming into contact with sparks ornaked flames. For example, electric machines, electricmotors, electrical switches/power switches, he...

English – 9 ! General working instructions SAFETY INSTRUCTIONS Basic working techniques • Always trim at full throttle. • Always drop to idling speed after each working operation. Longer periods running at full throttle without loading theengine (that is without resistance, which the engine feelsfro...

English – 11 26 25 ¥ ¢ 27 = WHAT IS WHAT? What is what on the trimmer? 1. Trimmer head 2. Grease filler cap 3. Angle gear 4. Spray guard 5. Shaft 6. Loop handlebar 7. Throttle 8. Stop switch 9. Throttle trigger lock 10. Suspension for harness (not on 225L Lite) 11. Cylinder cover 12. Starter handle ...

12 – English Assembling the loop handlebar ASSEMBLY • Unscrew the handle and plastic cover from thehandlebar bracket. • Place the loop handlebar with the handlebar holderon the handlebar bracket.Fit the handle and plasticcover. Do not tighten tootight. • Put on the harness and hang the trimmer in th...

14 – English FUEL HANDLING Fuel mixture • Clean around the fuel cap. Contamination inthe tank can disruptoperations. • Ensure that the fuel is well mixed by shaking thecontainer before fillingthe tank. WARNING!Always provide good ventilation whenhandling fuel. ! Fuelling WARNING!The following precau...

English – 15 START AND STOP Control before starting For reasons of safety followthese recommendations! • Check that the support flange is not cracked dueto fatigue or due to beingtightened too much.Discard the supportflange if it is cracked. • Ensure the locking nut has not lost its captiveforce. Th...

16 – English Carburettor Your Husqvarna product has been designed andmanufactured to specifications that reduce harmfulemissions.After your unit has been run 8-10 tanks of fuel the enginehas broken in. To ensure that your unit is at peakperformance and producing the least amount of harmfulemissions ...

English – 17 Final setting of the idling speed T Adjust the idling speed withthe screw T, If it is necessaryto readjust. First turn theidle speed adjusting screw Tclockwise until the cuttingattachment starts to rotate/move.Then turn, counter-clockwise until the cuttingattachment stops. A correctlyad...

18 – English MAINTENANCE Cooling system To maintain as low opera-ting temperature as possiblethe engine is equipped witha cooling system.The cooling system consistsof:1. An air intake on the starter unit. 2. Cooling fins on the flywheel. 3. Cooling fins on the cylinder 4. Cylinder cover (leads cold ...

English – 19 MAINTENANCE Two-part shaft The end of the drive axle inthe lower shaft should belubricated with grease every30 hours. There is a riskthat the drive axle ends(splined coupling) on two-part shafts jam if they arenot lubricated regularly. Angle gear The angle gear is filledwith a sufficien...

20 – English MAINTENANCE NOTE: Use only HUSQVARNA replacement parts. Use ofother brands of replacement parts can cause damage to yourunit or injury to the operator or others. Your warranty doesnot cover damage or liability caused by the use of accessoriesand/or attachments not specifically recommend...

English – 21 TECHNICAL DATA Technical data Engine Cylinder capacity, cu. in/cm 3 Cylinder bore, inch/mmStroke length, inch/mmRecommended max. speed, rpmMax. speed, should not be exceeded. rpmIdling speed, rpmSpeed of output axle, rpmMax. engine output, acc. to ISO 8893 Ignition system Manufacturer/t...

22 – English YOUR WARRANTY RIGHTS AND OBLIGATIONS The EPA (U.S. Environmental Protection Agency), Carb(California Air Resources Board) and Husqvarna Forest &Garden are pleased to explain the emissions control systemwarranty on your 1997 and later Lawn and GardenEquipment Engine. In U.S., new uti...