Page 2 - Notice
** Copyright (Copyright © 2001 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing exceptapproval of ownership of copyright and copyright law. ** Warranty The information in this document is subject to change without notice. HUMAX does no...
Page 4 - Safety Instructions and Precautions; CONNECTION TO THE AERIAL; Safety and Warning
** This digital terrestrial receiver has been manufactured to satisfy international safety standards.Please read the following safety precautions carefully. ** Safety Instructions and Precautions ** 1. MAINS SUPPLY ** AC 100 ~ 240V 50/60Hz Max 1.0AOperate this product only from the type of power sup...
Page 5 - Warning
** 10.LOCATION ** Place the receiver indoors to avoid exposing it to lightening, rain or sun.Do not place it near a radiator or heat register.Make sure it has more than 10 cm clearance from any appliances susceptible toelectromagnetic influences, such as TV and VCR.Do not block these openings with a...
Page 6 - Before Using the Receiver; Contents
** 1. Before Using the Receiver 1.1 Package Contents 1.2 Front Panel 1.3 Rear Panel 1.4 Remote Control GB7 ** GB7 GB8 GB9 GB10 2. Connecting 2.1 Connecting Aerial 2.2 Powering On GB12 ** GB12 GB14 3. Setup 3.1 Selecting a Language 3.2 Language Setting 3.3 Service Searching GB15 ** GB15 GB15 GB16 4. ...
Page 7 - System Information; Service and Support
** 7. Parental Control 7.1 Parental Control GB32 ** GB32 8. Installation 8.1 System Setting 8.2 Service Searching GB33 ** GB33 GB37 9. Software Update 9.1 OTA (Over the Air) 9.2 Software Upgrade from PC GB40 ** GB40 GB42 10. System Information 10.1 Status 10.2 Utility GB43 ** GB43 GB44 11. Manipulat...
Page 8 - Before Using the Receiver
** This chapter describes detail instructions on the product and its accessories. 1.1 Package Contents Please check all package contents before using your receiver. ** ** Remote Control (1) User's Manual (1) ** Batteries (2) RF Cable (1) Adaptor (1) ** Note: • Since faults may occur if the remote co...
Page 9 - Before Using the Receive
** 1.2 Front Panel ** 1. STANDBY LED ** Red light is displayed when the product is in the standby mode.Green light is displayed when the product is in operation. 2. CH- / CH + ** Moves the TV/Radio service up / down. 3. STANDBY Button ** Switches between operation and standby modes. ** 1. Before Usi...
Page 13 - Connecting Aerial; Connecting TV and VCR
** This chapter describes how to set up the receiver. Select the most appropriate procedure dependingon your case. Note: If you encounter any problem when setting up the receiver, please contact your localproduct distributor. 2.1 Connecting Aerial 1. Connecting TV and VCR Connect the cable of your T...
Page 16 - Selecting a Language; OK
** Please setup the language, and search for services when you use your receiver for the first timeafter purchase. Once the service setting has been completed, you can skip Chapter 3. 3.1 Selecting a Language You can select the language before you use the receiver. Select your desired language using...
Page 17 - Service Searching
** 3.3 Service Searching If your receiver is connected to the aerial and television, you can automatically or manually searchservices. 1. Press the MENU button 2. Select Installation using the button and press the OK button. 3. Select Service Searching using the button and press the OK button. 4. En...
Page 20 - Change a Audio Language; General Information
** 4.5 Change a Audio Language If the current programme is available in multiple audio languages, you can select the language thatyou wish to listen in. 1. Press the SOUNDTRACK button to display soundtrack list. 2. Select your desired audio language using the and OK button to change Audio immediatel...
Page 21 - Detailed Programme Information
** Displayed only if this programme is reserved. Represents parental level. It indicates the minimum level of ages that theprogramme is targeted at. Displayed only when the service is a locked service. Displayed only when the service is a scrambled service. Displayed only when subtitle information i...
Page 22 - Service Configuration; Add a channel to favourite group
** 4.8 Service Configuration You can view and confirm detailed information about the current channel and change the informationin necessary. 1. Press the MENU button. 2. Select Select Service using the button and press the OK or u button. 3. Select Simple or Advanced using the button and press the O...
Page 24 - Selecting the Simple or Advanced Service List
** 4 types of service lists are provided for easy and quick service finding. You can see the service listwhen you had searched before. To this menu, you should set service group you want in the ServiceOrganising menu. Note: • Press the EXIT button to save the changes and return to the previous menu,...
Page 27 - Organising Favourite Groups; Selecting Group, Favourite or Service mode
** You can also use four direction buttons. Standard Press the RED button to see the standard keyboard. Extend Press the GREEN button to see the extended keyboard. OK Press the YELLOW button to save the new name after entering a new name. Delete Press the BLUE button to delete the entered name. Note...
Page 28 - Organising Networks
** 5.5 Organising Networks You can edit the service using the network unit. The provider name is displayed on the left side ofscreen and the TV/Radio service included in the highlighted network is displayed on the right side ofscreen. Only the Delete, Move, and Rename function can be used in Network...
Page 29 - Viewing Programme Guide Information; Main menu to enter the TV Guide.; Viewing Guide Information by Now or Next mode
** The TV Guide displays the programme information. You can reserve it in the TV Guide menu. Not:e: Press the GUIDE button to exit the Guide screen. Press the button to move the cursor to the next page. ** TV Guide mode includes five buttons to do four different modes : Now/Next Press the RED button...
Page 31 - Viewing Guide Information by Quick mode; Red vertical line; Reserving a Programme
** 4. Viewing Guide Information by Quick mode You can view a simple TV Guide like an information box. 1. Press the BLUE button to display the service list by quick mode. 2. Select your desired service using the or CH-/CH+ button and press the OK button. 3. The programme for selected service is displ...
Page 32 - Reserving New Programme; Once; Editing the Reserved Programme
** 1. Reserving New Programme You can reserve programmes. Select Once, Daily or Weekly using the button and press the OK button to save. Once Reserve once. Daily Reserve everyday. Weekly Reserve each once a week. Note: • You can reserve or a programme in the I-plate using WHITE button. • You can res...
Page 33 - Setting Censorship; No block
** You can set all other items suitable for your environment. Note: • Press the EXIT to save the changes and return to the previous menu. Press the MENU button to exit the Menu screen. • The Default PIN code is 0000. If you have forgotten your PIN code, please contact your localproduct distributor. ...
Page 37 - Opaque
** • PAL StandardSelect a PAL Standard according to the above range of channels. Select one option amongPAL I, PAL B,PAL G, PAL D, PAL K . ** • OffsetYou can adjust fine tuning setting. Select a range between -4~+4. 5. Other Setting 1. Select OSD Transparency, Info. Box Display Time, Changing to Res...
Page 38 - Service Searching
** 8.2 Service Searching 1. Press the MENU button. 2. Select Installation using the button and press the OK button. 3. Select Service Searching using the button and press the OK button. 4. When prompting message is displayed to ask PIN code, enter the PIN code using the NUMERICAL(0~9) button.The def...
Page 40 - On; Off
** 4. Antenna Power When you connect an active antenna to the ANTENNA IN connector on the rear of the receiver. Select On or Off using the button. On 5V power supply from the active antenna cable. Off No power supply. ** ** GB 39 ** ** ** ** ** ** ** ** ** ** ** ** ** **
Page 42 - If new software is found when powering on
** 1. If new software is found when powering on 1. A message will be displayed to notify that new software is found. 2. Select Yes and press the OK button to upgrade the software. 3. Starts downloading new software. Please wait until the upgraded is completed. 4. When completing the software upgrade...
Page 43 - Software Upgrade from PC
** 9.2 Software Upgrade from PC You can connect your receiver to the PC directly and upgrade your software by transferring the newsoftware from the PC. Follow these steps to download new software from PC to this product. 1. Download new software file(HDF files) equivalent for this product model from...
Page 44 - Status and Utility
** 10.1 Status You can view all system information, and signal detection. 1. Press the MENU button. 2. Select Installation using the button and press the OK button. 3. Select Status using the button and press the OK button. 4. Select STB Status or Signal Detection using the button and press the OK b...
Page 46 - TV code setting; Manipulating your TV using Remote Control
** You can manipulate TV using the remote control provided by Humax. Note: This function may not be supported depending on TV model. TV code setting Note: While you are setting TV code, please keep pressing TV button. 1. Point remote control towards the remote control receiving parts of TV. 2. Press...
Page 58 - Memory; Physical Specification
** Memory Flash Memory 1 Mbytes Graphics (MPEG) & System Memory 16 Mbytes EEPROM 8 Kbytes RF-Modulator RF/Loop-through Output Connector 75 , IEC 169-2 Frequency 470 ~ 862 MHz Output Channel CH 21 ~ 69 TV standard PAL I/G/B Preset Channel CH 36 Power Supply Input Voltage DC 12V 1.4A Type Switchin...
Page 60 - Homepage
** You can get information such as a troubleshooting guide, software upgrades and product supportguide from the following web sites and call center (Hotline). Please try to contact to your local dealers first when you have any problem. Web site and e-mail Homepage http://www.humaxdigital.com English...
Page 61 - Call Center
** Call Center Humax Middle East Call Center (Dubai, UAE) Tel: +971 (0)4 359 2323 (Open: 9:00 - 20:00 / close on Friday) E-mail: [email protected] Open: Local Time in Dubai (GMT+4) 9:00 - 20:00 (Saturday - Thursday, close on Friday) Support Language: English/Arabic ** Humax Hotline (Germ...
