HP XZ930UT - Manual

Keyboard Table 1-4 Keyboard Components 1 Function Keys Perform special functions depending on the software application being used. 2 Editing Keys Includes the following: Insert, Home, Page Up, Delete, End, and Page Down. 3 Status Lights Indicate the status of the computer and keyboard settings (Num ...

Using the Windows Logo Key Use the Windows Logo key in combination with other keys to perform certain functions available in theWindows operating system. Refer to the Keyboard on page 5 section to identify the Windows Logo key. Table 1-5 Windows Logo Key Functions The following Windows Logo Key func...

Serial Number Location Each computer has a unique serial number and product ID number that are located on the top cover ofthe computer. Keep these numbers available for use when contacting customer service for assistance. Figure 1-3 Serial Number and Product ID Location ENWW Serial Number Location 7

2 Hardware Upgrades Serviceability Features The computer includes features that make it easy to upgrade and service. No tools are needed for mostof the installation procedures described in this chapter. Warnings and Cautions Before performing upgrades be sure to carefully read all of the applicable ...

Removing the Computer Access Panel 1. Remove/disengage any security devices that prohibit opening the computer. 2. Remove all removable media, such as compact discs or USB flash drives, from the computer. 3. Turn off the computer properly through the operating system, then turn off any external devi...

Removing the Front Bezel 1. Remove/disengage any security devices that prohibit opening the computer. 2. Remove all removable media, such as compact discs or USB flash drives, from the computer. 3. Turn off the computer properly through the operating system, then turn off any external devices. 4. Di...

Removing Bezel Blanks On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch external drive bays thatneed to be removed before installing a drive. To remove a bezel blank: 1. Remove the access panel and front bezel. 2. To remove a bezel blank, push the two retaining tabs that hol...

Installing Additional Memory The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3-SDRAM) dual inline memory modules (DIMMs). DIMMs The memory sockets on the system board can be populated with up to four industry-standard DIMMs.These memory sockets are populated w...

Populating DIMM Sockets There are four DIMM sockets on the system board, with two sockets per channel. The sockets arelabeled DIMM1, DIMM2, DIMM3, and DIMM4. Sockets DIMM1 and DIMM2 operate in memory channelA. Sockets DIMM3 and DIMM4 operate in memory channel B. Figure 2-7 DIMM Socket Locations Tabl...

will have more memory than the other, the larger amount should be assigned to Channel A. Forexample, if you are populating the sockets with one 1-GB DIMM, and three 512-MB DIMMs,Channel A should be populated with the 1-GB DIMM and one 512-MB DIMM, and Channel B shouldbe populated with the two 512-MB...

Removing or Installing an Expansion Card The computer has one PCI expansion slot, two PCI Express x1 expansion slots, and one PCI Expressx16 expansion slot. Figure 2-9 Expansion Slot Locations Table 2-2 Expansion Slot Locations Item Description 1 PCI expansion slot 2 PCI Express x16 expansion slot 3...

Installing and Removing Drives When installing additional drives, follow these guidelines: ● The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATAconnector on the system board labeled SATA0. ● Connect a SATA optical drive to the white SATA connector on the system b...

Installing an Internal 3.5-inch Hard Drive NOTE: The system does not support Parallel ATA (PATA) hard drives. 1. Remove/disengage any security devices that prohibit opening the computer. 2. Remove all removable media, such as compact discs or USB flash drives, from the computer. 3. Turn off the comp...

12. Reconnect the power cord and any external devices, then turn on the computer. 13. Lock any security devices that were disengaged when the access panel was removed. Removing and Replacing a Removable 3.5-inch SATA Hard Drive Some models are equipped with a Removable SATA Hard Drive Enclosure in t...

B Battery Replacement The battery that comes with the computer provides power to the real-time clock. When replacing thebattery, use a battery equivalent to the battery originally installed in the computer. The computer comeswith a 3-volt lithium coin cell battery. WARNING! The computer contains an ...

C External Security Devices NOTE: For information on data security features, refer to the Computer Setup (F10) Utility Guide , the Desktop Management Guide , and the HP ProtectTools Security Manager Guide (some models) at http://www.hp.com . Installing a Security Lock The security locks displayed be...

Padlock Figure C-2 Installing a Padlock HP Business PC Security Lock 1. Fasten the security cable by looping it around a stationary object. Figure C-3 Securing the Cable to a Fixed Object ENWW Installing a Security Lock 47

4. Insert the plug end of the security cable into the lock (1) and push the button in (2) to engage thelock. Use the key provided to disengage the lock. Figure C-6 Engaging the Lock Front Bezel Security The front bezel can be locked in place by installing a security screw provided by HP. To install ...

D Electrostatic Discharge A discharge of static electricity from a finger or other conductor may damage system boards or otherstatic-sensitive devices. This type of damage may reduce the life expectancy of the device. Preventing Electrostatic Damage To prevent electrostatic damage, observe the follo...

E Computer Operating Guidelines,Routine Care and Shipping Preparation Computer Operating Guidelines and Routine Care Follow these guidelines to properly set up and care for the computer and monitor: ● Keep the computer away from excessive moisture, direct sunlight, and extremes of heat and cold. ● O...

Optical Drive Precautions Be sure to observe the following guidelines while operating or cleaning the optical drive. Operation ● Do not move the drive during operation. This may cause it to malfunction during reading. ● Avoid exposing the drive to sudden changes in temperature, as condensation may f...

Index A access panel locking and unlocking 46removing 9replacing 10 audio connectors 2, 4 B battery replacement 43 C computer operating guidelines 52connecting drive cables 22 D DIMMs. See memory drives connecting cables 22installing 22locations 21 E electrostatic discharge, preventing damage 51 exp...