HP V8.5 - Manual

HP V8.5

HP V8.5 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
77 Page 77
78 Page 78
79 Page 79
80 Page 80
Page: / 80

Table of Contents:

  • Page 2 – Versatec is a registered trademark of Versatec Corporation.; DISCLAIMER
  • Page 4 – Important; – This equipment; Europe; – This digital equipment fulfils the requirements for radiation; Vorsicht; – Muss befolgt werden, um Totalverlust oder Beschädigung; Wichtig
  • Page 5 – iv; Elektromagnetische Kompatibilität (EMC) USA; – Dieses Gerät; Europa; – Dieses digitale Gerät entspricht den Anforderungen für
  • Page 6 – LIMITATION OF LIABILITY
  • Page 7 – Contents
  • Page 8 – vii
  • Page 9 – viii; APPENDICES
  • Page 10 – ix
  • Page 11 – INTRODUCTION; GENERAL DESCRIPTION; in the V8.5e is made up of 1728 thermal heater; MEDIA DESCRIPTION
  • Page 13 – S P E C I F I C A T I O N S; Operation; Command panel
  • Page 15 – Media
  • Page 16 – Transport
  • Page 17 – Dimensions
  • Page 18 – INSTALLATION; Sample Roll of paper
  • Page 19 – I N S T A L L A T I O N; MOUNTING AND POSITIONING; or rack components could result if the plotter becomes unstable.; VORSICHT: Versichern Sie sich vor dem Betrieb des Gerätes, dass die; zu Schäden am Plotter oder am Gestell führen.
  • Page 20 – INTERFACE SETUP; For optional Centronics interface setup, see Appendix C.; MEDIA INSTALLATION; medium installed. This may damage the print head and will void the; VORSICHT: Versuchen Sie bitte nicht, einen Druckvorgang oder; Papiervorschub zu starten, wenn sich kein Druckmedium im Plotter
  • Page 21 – Installing rolled paper; To install rolled paper:
  • Page 25 – Installing fan-fold paper
  • Page 26 – CAUTION: Before plotting or testing on any print media, make sure; to the printhead and warranty. The media may also be damaged.; VORSICHT: Bevor Sie mit dem Plotten oder Testdrucken auf einem; einer Beschädigung des Druckkopfes und zum Verlust der Garantie; Installing rolled film; Orient the roll so that the film feeds off of the top of the roll.
  • Page 28 – O P E R A T I O N; POWER SUPPLY PRECAUTIONS; Unplugging the plotter; CAUTION: Take care not to discharge static into the plotter.; This may cause damage to the integrated circuits or other
  • Page 29 – USING THE CONTROL PANEL
  • Page 30 – Table 4-1. Control panel button functions
  • Page 32 – Changing function settings; a n d h o l d i n g; NOTE: Press and hold the MENU/SAVE button immediately after the; without doing so will not save your changes.; CONTROL PANEL FUNCTIONS AND SETTINGS
  • Page 33 – Default Settings; during the boot up sequence, indicating that; Test plot; Press Button 1 to put the plotter into OFFLINE mode.; tP; to
  • Page 35 – and
  • Page 36 – Scaling; through
  • Page 37 – Form feed length; without holding; PF
  • Page 39 – Bytes per scan; Press and hold Button 3 until the display flashes:
  • Page 40 – Grayscale media table number; The V8.5E must be in PRINT mode for the setup
  • Page 43 – ERROR MESSAGES; cools to a temperature that is safe to plot again.; 4 Volts Error: The plotter will display 24 and the error LED will; contact your product representative.
  • Page 45 – T H E O R Y O F O P E R A T I O N; PLOTTER FUNCTIONS AND FEATURES
  • Page 47 – Stepper motor
  • Page 48 – Table 5-2 Data Transfer
  • Page 50 – Data rates
  • Page 51 – Scan width
  • Page 52 – Print mode; ti
  • Page 53 – THERMAL PRINTHEAD; . Each bit within a scan addresses an individual nib. Plot patterns; Automatic Head Temperature Feedback; and the
  • Page 54 – Film media
  • Page 55 – MAINTENANCE
  • Page 57 – M A I N T E N A N C E; REGULAR MAINTENANCE; one fails by authorized repair depot.
  • Page 58 – Cleaning the thermal printhead; Print Head
  • Page 59 – CAUTION: Do not touch the printhead with your fingers or other ob-; quality and shortens the life span of the printhead.; VORSICHT: Den Druckkopf nicht mit den Fingern oder irgendwelchen; Gegenständen berühren. Fett oder Öl verschmutzt den Druckkopf,; Cleaning the platen roller
  • Page 60 – Replacing the fuse; The fuse is located in a clip next to the AC receptacle. Figure 3-2.; WARNUNG: Beim Auswechseln der Sicherungen nur solche mit; verursachen. Siehe Kapitel 2, Spezifikationen, hinsichtlich der; WARNING: Consistent damage to the plotter AC fuse indicates a seri-; ous problem and should be repaired immediately. Contact your au-
  • Page 61 – T R O U B L E S H O O T I N G
  • Page 62 – Plotter does not plot
  • Page 63 – Plot has vertical white stripes; Figure 7-3 . Plot with vertical white stripes
  • Page 64 – Plot is blotchy or faded
  • Page 65 – Plot contrast is weak
  • Page 66 – Plot has black vertical lines; Figure 7-6 . Plot with black vertical lines
  • Page 67 – Plot is wrong length
  • Page 68 – Plotter has no power; Replace the fuse as described in Chapter 6.; Plotter display is functioning but motor does not function; Contact your authorized service center.; Can’t make changes to control panel settings; Plotter is in ONLINE mode.
  • Page 69 – Plot output speed is erratic
  • Page 70 – Burning smell during plot, or “blooming” present on output
  • Page 71 – Form feed stops before desired length; Contact your authorized service center.
  • Page 72 – Plot is skewed or unreadable; The scan width is incorrect.
  • Page 73 – W A R R A N T Y
  • Page 75 – A P P E N D I X; A S C I I T A B L E S; M S N : M o s t s i g n i f i c a n t n i b b l e; Table A-2. ASCII control code character set
  • Page 76 – INTERFACE CONNECTOR PIN ASSIGNMENT
  • Page 77 – I N T E R F A C E C O N N E C T O R P I N A S S I G N M E N T
  • Page 78 – C E N T R O N I C S I N T E R F A C E B O A R D; a) Rev 1-2 cards will accept either of the two data transfer
  • Page 79 – Enhanced transfer format
Loading the manual

V

8.5

Thermal Plotter

User Guide

V8.5 Thermal Plotter is a product of iSys - The Imagaing Systems Group. © 2005

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Versatec is a registered trademark of Versatec Corporation.; DISCLAIMER

i V8.5e Rev 2.2.2002 COPYRIGHT NOTICE This document is copyrighted by The Imaging Systems Group Inc.,2000. No part of this publication may be reproduced, transmitted,transcribed, or stored in a retrieval system of any kind without priorwritten permission of The Imaging Systems Group Inc. TRADEMARKS ...

Page 4 - Important; – This equipment; Europe; – This digital equipment fulfils the requirements for radiation; Vorsicht; – Muss befolgt werden, um Totalverlust oder Beschädigung; Wichtig

iii V8.5e Rev 2.2.2002 Caution! – must be observed to avoid loss or damage to your equipment. Important : - must be observed to avoid operational impairment. Do not proceed past any of the above notices, until you have fullyunderstood the implications. Electromagnetic Compatibility (EMC) USA – This ...

Page 5 - iv; Elektromagnetische Kompatibilität (EMC) USA; – Dieses Gerät; Europa; – Dieses digitale Gerät entspricht den Anforderungen für

iv V8.5e Rev 2.2.2002 Bitte verfahren Sie erst dann weiter, wenn Sie die Bedeutung dervorstehenden Hinweise vollständig verstanden haben. Elektromagnetische Kompatibilität (EMC) USA – Dieses Gerät erzeugt und verbreitet Hochfrequenzenergie und kann daher, sofernes nicht gemäß dem Benutzerhandbuch in...

Other HP Models

All HP Other