HP QR482A - Manual

HP QR482A

HP QR482A – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
77 Page 77
78 Page 78
79 Page 79
80 Page 80
81 Page 81
82 Page 82
83 Page 83
84 Page 84
85 Page 85
86 Page 86
87 Page 87
88 Page 88
89 Page 89
90 Page 90
91 Page 91
92 Page 92
93 Page 93
94 Page 94
95 Page 95
Page: / 95

Table of Contents:

  • Page 6 – Tools; Preventing Electrostatic Discharge
  • Page 7 – Use conductive field service tools.; Racks; To reduce the risk of personal injury or damage to the equipment:
  • Page 8 – “Installing Storage System Components into a Rack” (page 19); Storage System Hardware Installation Checklist
  • Page 9 – Identifying Storage System Components; storage system configuration.; shows the 2U24 drive enclosure, and also; Disk Drive Numbering
  • Page 10 – Controller Nodes; Figure 3 HP 3PAR StoreServ 7200 Controller Nodes
  • Page 11 – Controller Node PCIe Slots and Ports; Table 1 Storage System Expansion Cards; shows the ports on a controller node.; The MFG port is not used.
  • Page 12 – and; Power Cooling Modules
  • Page 13 – Service Processor; Figure 12 HP 3PAR Service Processor DL 320e
  • Page 14 – Power Distribution Units; Depending on the configuration, PDUs can be mounted vertically.
  • Page 15 – Setting Up a Factory-Integrated Storage System; “Repositioning the Storage System” (page 37); Verify the Cabling
  • Page 16 – Installing and Removing the Cable Restraint Shipping Brackets; Installing the Brackets; Connect the data cables to the enclosure.
  • Page 18 – Removing the Brackets; Procedure 1
  • Page 19 – Installing Storage System Components into a Rack; “Setting Up a; Unpacking Disk Drive and Controller Node Enclosures; Table 3 Part Numbers
  • Page 20 – Mounting a 2U rail shelf onto the rack; Figure 17 Mounting the 2U Rail Shelf; Mounting a 4U rail shelf onto the rack
  • Page 22 – Installing PCIe Adapters in the Controller Nodes; Remove the controller node and then the cover.; Installing Enclosures; To install an enclosure on the rack:
  • Page 24 – Guidelines for Installing Disk Drives in Disk Enclosures
  • Page 25 – Installing a Disk Drive; “Guidelines for Installing Disk Drives in Disk Enclosures” (page 24)
  • Page 27 – Installing the Service Processor in the Storage System; Table 4 Rack Types
  • Page 30 – Figure 28 Installing Cage Nuts and Rail Mounting Pins
  • Page 34 – Cabling the Storage System; . Scroll to Support, and click HP 3PAR StoreServ 7000 Support and; Cabling Controller Nodes; In
  • Page 35 – Do not power on the service processor.; Cabling Power to the Storage System; To cable the power cables:
  • Page 36 – Do not power on the PCMs at this time.; Cabling the Power Distribution Unit; Remove the two top mounting screws.; Cabling the Power Strips; Continue on to
  • Page 37 – Verifying Setup and Powering On the Storage System; Verifying Power Connections; Redundant Power; Repositioning the Storage System
  • Page 38 – Acclimating the Storage System; Powering On the Storage System
  • Page 39 – Verifying LED Status; Figure 35 Bezel LEDs
  • Page 42 – Node Interconnect Ports; The node interconnect ports are used only with 7400 4-Node systems.; Cluster link cabling error
  • Page 43 – Drive Enclosure LEDs; Figure 40 Drive Enclosure PCM LEDs
  • Page 44 – Identifying Service Processor LEDs; Figure 41 Front Panel LEDs
  • Page 46 – Connecting to a Virtual Service Processor; Prerequisites for Using a VSP; Verify both the VSP and StoreServ system are on the same subnet.; Deploying the VSP OVF File; Insert the HP 3PAR Virtual Service Processor software DVD.
  • Page 47 – Establishing the Virtual Service Processor IP Address; Option A: DHCP Network Environment; “Setting Up the Service Processor and Storage System” (page 51); setupusr
  • Page 48 – Connecting to a Physical Service Processor; Configuring the Physical Service Processor IP Address
  • Page 49 – Figure 44 Assign IP Address
  • Page 51 – Setting Up the Service Processor and Storage System; Storage System Software Installation Checklist; Table 12 SP and Storage System Software Installation Checklist
  • Page 52 – SmartStart Prerequisites; gigahertz or higher processor
  • Page 53 – “Launching the HP 3PAR Service Processor Setup Wizard” (page 53); Launching the HP 3PAR Service Processor Setup Wizard; Set up the Service Processor
  • Page 54 – Figure 46 Set up systems Page; User Name; Welcome Page; Welcome
  • Page 55 – Figure 47 Welcome Page; Generate Service Processor ID; Generate SP ID
  • Page 56 – Figure 48 Generating SP ID Page; Configure SP Networking; Advanced
  • Page 57 – Remote Support; Timely remote service; Requirements for Setting Firewalls and Ports
  • Page 58 – Table 13 Firewall and Port Requirements; for collecting an archive of diagnostic data (known as an InSplore).
  • Page 59 – System Support Information; Installation Site Information
  • Page 60 – Figure 51 System Support Information Page; Time and Region; On the
  • Page 61 – Figure 52 Time and Region Page; Change Passwords; Next
  • Page 62 – Figure 53 Change Passwords Page
  • Page 63 – Summary; Applying Settings; The
  • Page 64 – Figure 55 Apply Settings; Finish
  • Page 65 – Set up the storage system
  • Page 66 – Enter Serial Number
  • Page 68 – Verify Storage System; Configure Networking
  • Page 69 – Figure 62 Configure Networking Page; Configuring Time; Figure 63 Configure Time Page
  • Page 70 – Change Password; paradm; username can include all printable characters and be between
  • Page 71 – Verify Configuration; Progress
  • Page 72 – Figure 66 Progress Page; Results
  • Page 73 – Validating Remote Support
  • Page 74 – Support and Other Resources; Contacting HP; HP 3PAR documentation
  • Page 77 – Typographic conventions; Table 14 Document conventions; irreversible damage to data or to the operating system.; Required; HP 3PAR branding information
  • Page 78 – 0 Documentation feedback; when submitting your feedback.
  • Page 79 – A HP 3PAR StoreServ 7000 (Controller and Storage) and; Appearance of components
  • Page 83 – Figure 79 Service Processor DL320e; Rail Kits
  • Page 86 – B Enhancing Security with Data Encryption
  • Page 87 – C Adding Disk Drives and Expansion Drive Enclosures; Information About Drive Enclosure Upgrades
  • Page 88 – Disks must be identical pairs.; HP M6710 Drive Enclosure (2U24) Disk Drive Placement; Figure 87 M6720 Drive Enclosure (4U24) Disk Drive Placement Order
  • Page 89 – Checking Initial Status; Systems; Inserting Disk Drives; New
  • Page 90 – Checking Progress
  • Page 91 – Completing the Upgrade; “Cabling the Storage
  • Page 92 – Prerequisites; Launching the Storage System Setup Wizard
  • Page 93 – E Validating Remote Support; Figure 92 SPOCC Support Page
  • Page 94 – Figure 94 SPOCC Communication Results
  • Page 95 – F Troubleshooting; Stop
Loading the manual

HP 3PAR StoreServ 7000 Storage

nl

Installation Guide

Abstract

This guide is designed to instruct qualified technicians who are authorized to install the HP 3PAR StoreServ 7000 Storage
system and associated hardware components.

HP Part Number: QR482-96436
Published: August 2013
Edition: 1

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 6 - Tools; Preventing Electrostatic Discharge

1 Getting Started Before you begin, read the following guidelines to help you complete the installation successfully. If you need assistance with the installation, contact HP Support or visit http://www.hp.com/support . Tools The following tools are not required but can be useful, especially when un...

Page 7 - Use conductive field service tools.; Racks; To reduce the risk of personal injury or damage to the equipment:

• Cover workstations with approved static-dissipating material. Use a wrist strap connected tothe work surface, and properly grounded (earthed) tools and equipment. • Keep the work area free of nonconductive materials, such as ordinary plastic assembly aidsand foam packing. • Ensure that you are alw...

Page 8 - “Installing Storage System Components into a Rack” (page 19); Storage System Hardware Installation Checklist

Redeeming and Registering HP 3PAR Licenses HP 3PAR StoreServ 7000 products include 3PAR licensing, which enables all system functionality.Failure to register the license key may limit access and restrict system upgrades. The Summary Entitlement Certificate is enclosed in a blue envelope in the acces...

Other HP Models

All HP Other