HP LA1905WL - Manual

2 Setting Up the Monitor To set up the monitor, ensure that the power is turned off to the monitor, computer system, and otherattached devices, then follow the instructions below. Unfolding the Monitor Pedestal Base 1. Lift the monitor from its box and place it face down on a flat surface. 2. Hold d...

Connecting the Cables 1. Place the monitor in a convenient, well-ventilated location near the computer. NOTE: Before connecting the cables, route them through the opening on the monitor's pedestal. 2. Connect a VGA signal cable, DVI-D signal cable, or DisplayPort signal cable. NOTE: The monitor is c...

WARNING! To reduce the risk of electric shock or damage to the equipment: Do not disable the power cord grounding plug. The grounding plug is an important safety feature. Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times. Disconnect power from the...

NOTE: To view an OSD menu simulator, visit the HP Customer Self Repair Services Media Library at http://www.hp.com/go/sml . Adjusting the Monitor NOTE: Your monitor model may look different than the model in the following illustrations. 1. Tilt the monitor's panel forward or backward to set it to a ...

NOTE: To view information on the screen in portrait mode, you will need to install the Pivot Pro software included on the software and documentation CD. The position of the OSD menu canalso be rotated to portrait mode. To rotate the OSD menu, access the OSD menu by pressingthe Menu button on the fro...

Connecting USB Devices USB connectors are used to connect devices such as a digital camera, USB keyboard, or USBmouse. Two USB connectors are located on the side panel of the monitor. NOTE: You must connect the USB hub cable from the monitor to the computer to enable the USB 2.0 ports on the monitor...

Removing the Monitor Pedestal Base You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,or other mounting fixture. CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnec...

Mounting the Monitor The monitor panel can be attached to a wall, swing arm, or other mounting fixture. NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket. 1. Remove the monitor panel from the pedestal base. Refer to Removing the Monitor Pedestal Base on page 11 ...

Locating the Rating Labels The rating labels on the monitor provide the spare part number, product number, and serial number.You may need these numbers when contacting HP about the monitor model. The rating labels arelocated on the rear panel of the monitor display head. Figure 2-12 Locating the Rat...

3 Finding More Information Reference Guides Refer to the HP LCD Monitors Reference Guide included on the CD with your monitor for additional information on: ● Optimizing monitor performance ● Safety and maintenance guidelines ● Installing software from the CD ● Using the OSD menu ● Downloading softw...

A Technical Specifications NOTE: All performance specifications are provided by the component manufacturers. Performance specifications represent the highest specification of all HP's component manufacturers' typical levelspecifications for performance and actual performance may vary either higher o...

Table A-8 Factory Preset Modes (continued) 4 1024 × 768 48.363 60.004 5 1280 × 960 60.00 60.00 6 1280 × 1024 63.981 60.02 7 1440 × 900 55.935 59.887 8 1600 × 1200 75.00 60.00 9 1680 × 1050 65.29 60.00 10 1920 × 1080 67.5 60.00 11 1920 × 1200 74.038 59.95 12 1920 × 1200 74.556 60.00 * Preset 2 not su...